Spectrophotometric determination of iron as phenylfluorone complex sensitized with Triton X-100

Summary The effect of some surfactants and protective colloids on the absorbance of the iron(III)-phenylfluorone complex has been investigated. The binary complex formed at pH 9.0 show a molar absorptivity of 7.5×10⁴ l · mol^–1 · cm^–1 at 530 nm. In the presence of 2% Triton X-100, at the same pH, the molar absorptivity of the sensitized complex was 1.19×10⁵ l · mo^–1 · cm^–1 at 555 nm. Full colour development of the sensitized complex occurred within 25 min and Beer's law was followed up to 0.53 ppm of iron. The molar ratio and continuous variation methods indicated a 13 metal-ligand ratio for the sensitized complex. The effect of various amounts of different ions has been studied under the experimental conditions and some masking agents were recommended. The method has been applied to the determination of iron in copper and nickel metals and some non-ferrous alloys.

---

Spektralphotometrische Bestimmung von Eisen als Phenylfluoronkomplex sensibilisiert mit Triton X-100

     

Chlorobiphenyls in sewage sludge; comparison of extraction methods

Six extraction methods for the analysis of PCBs (CB-28, CB-52, CB-101, CB-118, CB-138, CB-153 and CB-180) in sewage sludge were tested. A certified reference material (CRM 392) was used for the evaluation of the performance of the methods. Soxhlet-Dean-Starch with toluene as solvent, Soxhlet with hexane:acetone (2:3), cold digestion/saponification with 2 mol/L KOH in methanol followed by partition with hexane, and sonicated liquid-solid extraction with hexane:acetone (1:1) produced accurate results (97%, 93%, 104%, and 88%, respectively) with acceptable precisions (6.2%, 6.8%, 15% and 12%, respectively). Results in close agreement with the certified value for all congeners were obtained by treatment with BF₃-methanol prior to partition with dichloromethane. However, this is a tedious procedure and involves the use of hazardous compounds. Cyclic steam distillation produced results with an accuracy of around 80% and a good precision (5.2%). The very low consumption of solvents and other expensive chemicals by this technique and the possibility of analyzing the extract directly without clean-up make it an interesting alternative to the more sophisticated methods. Column elution with dichloromethane was found to be less efficient (61%), but it is a rapid, direct method with a low consumption of solvents and it may therefore serve as screening method. Received: 29 April 1997 / Revised: 30 July 1997 / Accepted: 6 August 1997     

Adsorption of some toxic elements from water samples on modified activated carbon,activated carbon and red soil using neutron activation analysis

A simple and sensitive method for the determination of some metalloids and heavy metals in water samples is presented. The method is based on the preconcentration of the attachment of chelating functionalities with metalloids and toxic metals irreversibly and targeted towards toxic metals adsorbed on modified activated carbon, activated carbon and red soil particles at pH 3.0–9.0±0.2, followed by quantitative determination using instrumental neutron activation analysis (INAA), on the absorbers. Attachment results from attraction that may be physical, chemical, electrical, or a combination of all three. The efficient removal of metalloids and toxic metals, especially arsenic, chromium and mercury is anticipated. The adsorption capacity of the chemically modified activated carbon materials was evaluated for the above mentioned metalloid and toxic metal ions in the presence of iron ions and simulated water samples. Red soil particles containing iron was utilized in the control of oxidation-reduction reaction with metalloids and toxic metals. The preconcentration of the elements of interest on red soil particles, activated carbon and modified activated carbon at different depths, pH and oxidation states was investigated. The results obtained showed good agreement with certified values giving relative errors of less than 10%.     

The preparation and some reactions of 2, 3, 5, 6-tetrachlorophenylmagnesium chloride

The reaction of pentachlorobenzene with metallic magnesium in THF at 10–15°C gives after hydrolysis 1, 2, 4, 5-tetrachlorobenzene (76%) and pentachlorobenzene (8%); after trimethylsilylation, 1, 2, 4, 5-tetrachloro-3-(trimethylsilyl)benzene (74%), pentachloro(trimethylsilyl)benzene (8%) and 1, 2, 4, 5-tetrachlorobenzene (6%); after iodination, 1, 2, 4, 5-tetrachloroiodobenzene (44%), pentachloroiodobenzene (12%) and 1, 2, 4, 5-tetrachlorobenzene (9%); and finally after carbonation, 2, 3, 5, 6-tetrachlorobenzoic acid (58%). These products indicate that in the Grignard reaction a mixture of largely 2, 3, 5, 6-tetrachlorophenylmagnesium chloride and some pentachlorophenylmagnesium chloride is formed. The formation pentachlorophenylmagnesium chloride is explained on the basis of metal—hydrogen exchange reaction between 2, 3, 5, 6-tetrachlorophenylmagnesium chloride and the unreacted pentachlorobenzene.     

Metal chelates of phosphonate-containing ligands-IV (Stability of some 1,6-hexamethylenediamine-N,N,N',N'-tetra(methylenephosphonic) acid metal chelates)

The stability constants of the complexes formed between the anion of 1,6-hexamethylenediamine-N,N,N',N'-tetra(methylenephosphonic) acid and some transition and non-transition metal ions have been measured potentiometrically at a temperature of 25 degrees and an ionic strength of 0.1M (KNO(3)). The acid dissociation constants of the ligand and stability constants of the protonated complexes are also reported. Comparisons are made with the acid dissociation constants of the analogous compounds EDTA, ENTMP and HDTA, and possible structural formulae are given.     

The preparation and characterization of mono- and bis-chelated cadmium(II) complexes of the di-2-pyridylketone Schiff base of S-methyldithiocarbazate (Hdpksme) and the X-ray crystal structure of the [Cd(dpksme)2] · 0.5 MeOH complex

New cadmium(II) complexes of empirical formulae, [Cd(dpksme)X] (dpksme = anionic form of the Schiff base; X = NCS^–, Cl^–, I^–) and [Cd(dpksme)₂] · 0.5MeOH, respectively have been prepared and characterized. The mono-ligated cadmium(II) complexes, [Cd(dpksme)X] are four-coordinate and tetrahedral but the bis-ligand complex, [Cd(dpksme)₂] · 0.5MeOH is six-coordinate and octahedral. The crystal and molecular structure of [Cd(dpksme)₂] · 0.5MeOH has been determined by X-ray diffraction. The complex has a distorted mer-octahedral structure in which the ligands are coordinated as uninegatively charged tridentate chelating agents via the pyridine nitrogen atoms, the azomethine nitrogen atoms and the thiolate sulfur atoms. The distortion from regular octahedral geometry is ascribed to the restricted bite angles of the ligands. The Schiff base and its cadmium(II) complexes exhibit mild antibacterial activities against Shigella dysenteriae, Bacillus cereus, Staphylococcus aureus and Escherichia coli. They are also mildly fungitoxic against the phytopathogenic fungi, Alternaria alternata and Macrophomina phaseolina.     

Metal chelates of phosphonate-containing ligands-I Stability of some N,N,N',N'-ethylenediaminetetra(methylenephosphonic) acid metal chelates

A potentiometric investigation of the acid dissociation constants of the octabasic ENTMP [N,N,N',N'-ethylenediaminetetra(methylenephosphonic) acid] is reported. The stability constants of protonated MH(n)L (n = 1, 2, 3 and 4) and unprotonated ML metal chelates of Mg, Ca, Ba and Cd with ENTMP have been measured. The stabilities are in the order Mg < Ca < Ba < Cd.     

A modulated dsc study on the in situ polymerization of cyclic butylene terephthalate oligomers

The polymerization of a cyclic butylene terephthalate (CBT) oligomer was studied as a function of temperature (T=200 and 260°C, respectively) by modulated DSC (MDSC). The first heating was followed by cooling after various holding times (5, 15 and 30 min) prior to the second heating which ended always at T=260°C. This allowed us to study the crystallization and melting behavior of the resulting polybutylene terephthalate (PBT), as well. In contrary to the usual belief, the CBT polymerization is exothermic and the related process is superimposed to that of the CBT melting. The melting behavior of the PBT was affected by the polymerization mode (performed below or above the melting temperature of the PBT product) of the CBT. Annealing above the melting temperature of PBT yielded a product featuring double melting. This was attributed to the presence of crystallites with different degrees of perfection. The crystals perfection which occurred via recrystallization/remelting was manifested by a pronounced exothermic peak in the non-reversing trace.     

A Chebotarev Theorem for finite homogeneous extensions of shifts

We derive a Chebotarev Theorem for finite homogeneous extensions of shifts of finite type. These extensions are of the form :X×G/H→X×G/H where (x,gH)=(σx, α(x)gH), for some finite groupG and subgroupH. Given a σ-closed orbit τ, the periods of the -closed orbits covering τ define a partition of the integer |G/H|. The theorem then gives us an asymptotic formula for the number of closed orbits with respect to the various partitions of the integer |G/H|. We apply our theorem to the case of a finite extension and of an automorphism extension of shifts of finite type. We also give a further application to ‘automorphism extensions’ of hyperbolic toral automorphisms. Financially supported by Universiti Kebangsaan Malaysia     

Chemical Constituents of Brown Rice Grain (<Emphasis Type="Italic">Oryza sativa</Emphasis>)

One new compound 3,7,11,15,19-pentamethyl-9α,10α,11α,17α,18α-pentahydroxy-n-tetracosan-1-oxy-p-hydroxycaffeoate (oryzaterpenyl caffeoate) (1), together with three known fatty acids linoleic acid, stearic acid and myristic acid were isolated and identified from the rice grain of Oryza sativa. The structure of the new compound was elucidated by 1D and 2D NMR spectroscopic techniques (¹H-¹HCOSY, ¹H-¹³C HETCOR) aided by EI-MS, and IR spectra. __________ Published in Khimiya Prirodnykh Soedinenii, No. 6, pp. 535–537, November–December, 2005.