Thin SiC<Subscript><Emphasis Type="Italic">x</Emphasis></Subscript> layers prepared by hybrid laser–magnetron deposition

Thin SiC _x films were fabricated by hybrid laser–magnetron deposition system. KrF excimer laser was used for deposition of carbon and magnetron at the same time for sputtering of Si species. Films were fabricated in argon/hydrogen ambient with and without additional RF discharge. The substrate temperature was changed up to 700°C. Films topology, crystallinity, composition, chemical bonds and optical emission spectra were studied. Films were smooth and amorphous. Films of thickness 400–1000 nm were fabricated. Adhesion moved from 8 to 14 N, depending on deposition conditions.     

Diamond/graphite content and biocompatibility of DLC films fabricated by PLD

Biocompatibility and physicochemical properties of diamond-like carbon (DLC) thin layers prepared by pulsed laser deposition method were studied. The films of high and low diamond/graphite content were prepared by changing the laser energy density on the graphite target from 4 to 11 J cm⁻². The bonds and surface properties as roughness, atomic force microscopy topology, contact angle parameters, and zeta potential were measured. The cell adhesion/proliferation on DLC layers was tested using normal human fibroblasts and keratinocytes.     

Formation of copper islands on a native SiO2 surface at elevated temperatures

A combination of in situ X-ray photoelectron spectroscopy analysis and ex situ scanning electron- and atomic force microscopy has been used to study the formation of copper islands upon Cu deposition at elevated temperatures as a basis for the guided growth of copper islands. Two different temperature regions have been found: (I) up to 250 °C only close packed islands are formed due to low diffusion length of copper atoms on the surface. The SiO₂ film acts as a barrier protecting the silicon substrate from diffusion of Cu atoms from oxide surface. (II) The deposition at temperatures above 300 °C leads to the formation of separate islands which are (primarily at higher temperatures) crystalline. At these temperatures, copper atoms diffuse through the SiO₂ layer. However, they are not entirely dissolved in the bulk but a fraction of them forms a Cu rich layer in the vicinity of SiO₂/Si interface. The high copper concentration in this layer lowers the concentration gradient between the surface and the substrate and, consequently, inhibits the diffusion of Cu atoms into the substrate. Hence, the Cu islands remain on the surface even at temperatures as high as 450 °C.     

Effect of the chiral chain length on structural and phase properties of ferroelectric liquid crystals

Studies of structural and phase properties obtained on several ferroelectric liquid crystalline materials with 2-alkoxypropionate group used as a chiral centre and without any lateral substitution are presented. In dependence on the chiral chain length these compounds exhibit the cholesteric N* phase, the ferroelectric smectic C* and a low-temperature SmX phase. Values of the spontaneous polarization and spontaneous tilt angle have been determined within the whole range of the SmC* phase. A low-temperature SmX phase has been identified as the orthogonal hexatic SmB* phase. The molecular parameters, namely the layer spacing in the SmC* and SmB* phases and the average intermolecular distances (D) between neighbouring parallel molecules in all investigated phases have been determined using the results of the X-ray diffraction obtained on non-oriented samples. The effect of the chiral chain length on mesomorphic, structural and physical properties of the studied ferroelectric liquid crystalline materials is discussed.     

Electrochemistry of Cobalta Bis(dicarbollide) Ions Substituted at Carbon Atoms with Hydrophilic Alkylhydroxy and Carboxy Groups

In this study we explore the effect on the electrochemical signals in aqueous buffers of the presence of hydrophilic alkylhydroxy and carboxy groups on the carbon atoms of cobalta bis(dicarbollide) ions. The oxygen-containing exo-skeletal substituents of cobalta bis(dicarbollide) ions belong to the perspective building blocks that are considered for bioconjugation. Carbon substitution provides wider versatility and applicability in terms of the flexibility of possible chemical pathways. However, until recently, the electrochemistry of compounds substituted only on boron atoms could be studied, due to the unavailability of carbon-substituted congeners. In the present study, electrochemistry in aqueous phosphate buffers is considered along with the dependence of electrochemical response on pH and concentration. The compounds used show electrochemical signals around −1.3 and +1.1 V of similar or slightly higher intensities than in the parent cobalta bis(dicarbollide) ion. The signals at positive electrochemical potential correspond to irreversible oxidation of the boron cage (the C2B9 building block) and at negative potential correspond to the reversible redox process of (CoIII/CoII) at the central atom. Although the first signal is typically sharp and its potential can be altered by a number of substituents, the second signal is complex and is composed of three overlapping peaks. This signal shows sigmoidal character at higher concentrations and may be used as a diagnostic tool for aggregation in solution. Surprisingly enough, the observed effects of the site of substitution (boron or carbon) and between individual groups on the electrochemical response were insignificant. Therefore, the substitutions would preserve promising properties of the parent cage for redox labelling, but would not allow for the further tuning of signal position in the electrochemical window.     

Development of special optical fibers for evanescent-wave chemical sensing

The paper summarizes results achieved in the Institute of Radio Engineering and Electronics in the field of investigation and fabrication of novel fiber-optic structures for evanescent-wave chemical sensing. Several approaches for increasing the evanescent-wave sensitivity of multimode silica optical fibers to gaseous and liquid chemicals are shown. These approaches make use of the decrease of the core diameter in sectorial and capillary sectorial fibers, modification of trajectories of optical rays in the cores of inverted-graded-index fibers, tailoring of the refractive index of porous layers applied on silica cores, an output mode filter preventing the detection of rays propagating at low axial angles or fibers bent in single or multiple turns. Presented at the 1st Czech-Chinese Workshop “Advanced Materials for Optoelectronics”, Prague, Czech Republic, June 13–17, 1998. This work was supported by the Grant Agency of the Czech Republic (projects No. 102/96/0939 and No. 102/98/1358) and by joint project No. 4104 of AS CR and CNRS, France.     

Regularity of ultrafilters

If there arek ⁺⁺ eventually functions fromk ⁺ intok or if there arek ⁺⁺ eventually different functions fromk ⁺ then uniform ultrafilters onk ⁺ are (k, k ⁺)-regular. The research of the first author was supported in part by NSF grant. The second author is a Miller’s Fellow at the University of California in Berkeley.     

A theory of non-radiative transfer of excitation energy in solids

A theory of non-radiative transfer of excitation energy in solids is elaborated for the case of strong interaction of an atom of the sensitizer and an atom of the activator with the oscillations of the whole crystal lattice.     

Ein Detektor Langsamer Neutronen

Zusammenfassung Der Scintilationsdetektor für Thermo-und Resonanzneutronen, der in dieser Arbeit beschrieben wird, wurde aus einem geschmolzenen Gemisch von ZnS(Ag) und ₂₃ hergestellt. Bei optimalem Verhältnis beider Komponenten und optimaler Dicke des Detektors kann für Thermoneutronen eine verhältnismässig grosse Wirksamkeit erzielt werden (bis 25%). Der Detektor kann auch bei starkem Hintergrund von -Strahlung benützt werden, da die Wirksamkeit der -Strahlregistrierung durch passende Einstellung des Diskriminators unter 10^–7% herabgesetzt werden kann, bei einer Wirksamkeit für Thermoneutronen von ungefähr 6%.