Emission characteristics of Cu in Dc voltage modulation applied glow discharge optical emission spectrometry.

In order to obtain the depth profile of a thin film, we investigated the emission characteristics of a voltage modulation glow discharge to optimize the modulation parameters (modulation voltage, offset voltage, and modulation frequency). In this study, a phase-sensitive detection method with a lock-in amplifier to the modulation technique led to a higher sensitivity and a larger signal-to-noise ratio in the emission analysis compared to the normal dc amplification method. Upon increasing the maximum voltage, the emission intensity of the Cu atomic line (CuI 239.34 nm) increased linearly at a modulation voltage of 400 V and an offset voltage of 300 V. On the other hand, the emission intensity was gradually reduced when a modulation frequency increased. It is advantageous for surface analysis that the voltage modulation technique gives a lower sputtering rate rather than the conventional dc discharge.     

The synthesis of 1,4-diazacycl[3,2,2]azine

The diazaanalog of “cycl[3,2,2]azine”, “1,4-diazacycl[3,2,2]azine” (1,4,7b-triazacyclopent-[cd]indene) and its 2-methyl derivative were prepared. These compounds are subject to facile acid-catalyzed hydrolysis affording substituted imidazo[1,2-a]pyridines.     

Template synthesis in the nickel(II)–thiocarbohydrazide–propanone triple system

The complexing process proceeding in the Ni^II–thiocarbohydrazide (H₂N–H–NC(=S)–NH–NH₂)–propanone triple system in EtOH solution and nickel(II)hexacyanoferrate(II) gelatin-immobilized matrix has been studied. It has been found that in the first case, template synthesis leading, as a minimum, to formation of three coordination compounds of Ni^II with (N,N,S,S)-donor tetradentate ligands having NiL¹, NiL² and NiL³compositions where L¹ is 4,6,6-trimethyl-2,3,7,8-tetraazanonen-3-di(thiohydrazide)-1,9, L² is 4,6,6,12-tetrametyl-1,9-dithio-2,3,7,8,10,11-hexaazatridekadien-3,11-hydrazide-1 and L³ is 2,8,10,10,16-pentamethyl-5,13-dithio-3,4,6,7,11,12,14,15-octaazaheptadekatrien-2,7,15 is observed, whereas in the gelatin-immobilized matrix, a complexing process in the system considered does not occur.     

Chemische Vitamin D<Subscript>3</Subscript>-Bestimmung in Lebertran

The different aspects of Vitamin D₃ determination and the data reported in the literature are discussed. The spectrophotometric determination of Vitamin D₃ in cod-liver oil is carried out after the alkaline saponification, extraction of unsaponified parts, precipitation of accompanying sterols and the column- and thin-layer chromatographic purification and separation of vitamin D₃ on 40 cm plates from other vitamins. The dyestuff α-naphtholbenzein is suited well as standard substance for the better location and identification of vitamin D₃ zone on the thin-layer plate. The results obtained from the chemical method were checked through the simultaneous biological determination.     

Ab initio studies of the allylic hydroxylation: DFT calculation on the reaction of 2-methyl-2-butene with selenium dioxide

The mechanism of the allylic oxidation of 2-methyl-2-butene with selenium dioxide has been investigated by ab initio quantum mechanics. Transition states for two major steps (an ene reaction and a [2,3]-sigmatropic rearrangement) of this reaction have been optimized by the B3LYP/6-311+G(d,p) method. A comparison of the energies of the transition states shows that the anti-endo and syn-endo approaches are the efficient routes in the ene reaction and the methyl (C4) group is sited in a pseudo-equatorial environment in cyclic transition states during the [2,3]-rearrangement. Calculations also show the kind of the terminal alkyl (C4) substituents may control (E)-selectivity in the formation of the allylic alcohols.     

Isolation of essential oils from tobacco by gas co-distillation/solvent extraction

Summary The essential oils have been isolated from tobacco leaves using a simple gas co-distillation apparatus. The method involves co-distillation with water under the continuous stream of an inert gas with subsequent single solvent extraction of the distillate. The extract is analysed on GC and GC/MS in splitless injection mode without further concentration. The method was evaluated for reproducibility using n-octadecane as an internal standard. The distillation-extraction procedure was reporducible with an average deviation of ±3% for the major constituents. The present method was applied to the analyses of the essential oils of other agricultural products.Dedicated to Dr. L. S. Ettre on the occasion of his 60th birthday.     

Lanthanide triflate-catalyzed three component synthesis of alpha-amino phosphonates in ionic liquids. A catalyst reactivity and reusability study

The catalyst reactivity and reusability for the lanthanide triflate-catalyzed three component synthesis of alpha-amino phosphonates have been examined in room temperature ionic liquids, [bmim][X], in which the catalytic activities were very dependent on the counter anion, X, as well as on the phosphorus nucleophile, and moreover, the catalyst immobilized in an ionic liquid was reused several times without any loss of activity.