Voltammetric Behavior of the Alizarin Red S Interaction with DNA and Damage to DNA

The electrochemical behavior and the interaction of alizarin red S (ARS) with calf thymus DNA was investigated on a bare glassy carbon electrode (GCE) and DNA modified GCE (DNA/GCE), respectively. ARS showed a pair of redox peaks at ?0.445 V and ?0.414 V on a bare GCE. On addition of DNA into the ARS solution, the peak current of ARS decreased and the peak potential positively shifted, but without new redox peaks appeared. The ARS reduction peak current increased with immersion time on a DNA/GCE. The results showed that ARS could interact with DNA molecules by intercalative binding mode. The equilibrium constant, binding number and the ratio of binding constant for oxidized and reduced ARS forms were obtained. The DNA damage was directly detected by appearance of guanosine and adenosine bases oxidation signal. The influence of experimental conditions on DNA damage extent was discussed in detail.     

阳离子交换柱分离-导数光度法测定原油中钒

以 5Br PADAP为显色剂 ,用阳离子交换柱分离干扰离子 ,在波长 6 30nm采用一阶导数光度法测定原油中钒 ,方法灵敏度高 ,摩尔吸光系数为 3.0× 10 5L·mol- 1·cm- 1,较其它光度法测定钒的摩尔吸光系数提高 1～ 2个数量级。对实际样品进行分析并做加标回收试验 ,钒的回收率在97.5 %～ 10 4 .0 %。与ICP AES方法进行对照试验 ,结果相吻合。     

千克级窄分子质量分布聚苯乙烯的制备与表征

以正丁基锂为引发剂，以经过处理的工业级环己烷为溶剂、四氢呋喃为促进剂，用阴离子聚合的方法，在常压和惰性气体保护条件下，制得一系列千克级窄分子质量分布的聚苯乙烯，利用IR、^1H-NMR、GPC等技术对聚苯乙烯产物进行了表征，分析了影响聚苯乙烯的分子质量及分子质量分布的因素。     

硅酸及其盐的研究 XX聚硅酸溶液中的酸强度与分子结构的关系

本文利用无机酸系列的酸强度(pKa值)与羟基上氧原子的亲电子超离域度S(E)成线性关系的规律性,找出聚硅酸系列的相应线性方程为:并由此推测低聚硅酸溶液中可能存在的硅酸结构:在三聚硅酸溶液中主要存在着六元平面环的三聚体;在四聚硅酸中则主要存在着三种环状的四聚体。     

Synthesis of perfluoroalkyl-containing multifunctional groups compounds for textile finishing

A new kind of perfluoroalkyl-containing multifunctional groups compound was designed. Treatment of 1H,1H,2H,2H-perfluorooctyltrichlorosilane (4) with allylmagnesium bromide provided key intermediate 1H,1H,2H,2H-perfluorooctyltriallylsilane (2). Hydroboration followed by oxidation, epoxidation and dihydroxylation of 2 gave perfluoroalkyl-containing multifunctional groups compound 1a, 1b and 1c, respectively.     

碳纳米管添加剂对质子交换膜燃料电池低铂载量膜电极性能的影响研究

以碳纳米管（CNT）作为低铂载量膜电极（CCM）催化层（0.1 mg_Pt·cm^-2）添加剂，研究了CNT的添加方式对催化层微观结构以及膜电极性能的影响.结果表明，与常规低铂载量催化层相比，在其表面喷涂一层CNT或将CNT均匀分散到Pt/C催化层中均有利于提升低铂载量膜电极的输出性能，在70℃和100%相对湿度条件下最高输出功率比常规低铂载量膜电极的0.522 W·cm^-2分别提升了22.4%和60.0%，并且均匀分散添加方式优于分层添加方式.其原因在于分层添加CNT后改善了低铂催化层和气体扩散层之间的接触界面，降低了催化层与扩散层间的接触电阻，而均匀分散添加方式除了可降低界面接触电阻外，还显著改善了低铂催化层中的气体传输，大幅提升了Pt催化剂的利用效率，使得膜电极电化学反应电阻明显降低.进一步对均匀分散添加方式中CNT的载量进行优化，表明CNT添加量为37.5 μg·cm^-2时电池输出性能最佳，70℃和100%相对湿度条件下的最大输出功率达到0.91 W·cm^-2.本研究工作表明，将CNT均匀分散添加到催化层中是一种有效提升低铂载量膜电极性能的方法.     

基于5-芳基乙内酰脲类化合物的CoMFA和HQSAR研究

用CoMFA和HQSAR两种QSAR方法研究了50个乙内酰脲类分子的定量构效关系.本研究从构象搜索所得的低能结构出发构建化合物分子的构象, 建立CoMFA模型,并进行了全空间搜索. HQSAR本质上是一种二维的QSAR方法,与CoMFA方法相比,该方法在数据处理方面,比CoMFA方法快捷,并且可重复性好.两种方法均得到了较好分析结果, CoMFA的交叉验证相关系数q2 值为0.815, HQSAR的q2值为0.893.这些方程有力地说明了该类分子在(R,R)-N-3,5-dinitrobenzoyl-1,2-diamine型手性固定相上拆分过程中的影响因素,对今后类似拆分的实验研究提供了理论支持.     

Different catalysis role of in‐loop and out‐of‐loop waters in assisting HNS/HSN proton transfer isomerizations: Bridging vs. surrounding effect

In this work, a density function theory (DFT) study is presented for the HNS/HSN isomerization assisted by 1–4 water molecules on the singlet state potential energy surface (PES). Two modes are considered to model the catalytic effect of these water molecules: (i) water molecule(s) participate directly in forming a proton transfer loop with HNS/HSN species, and (ii) water molecules are out of loop (referred to as out‐of‐loop waters) to assist the proton transfer. In the first mode, for the monohydration mechanism, the heat of reaction is 21.55 kcal · mol^?1 at the B3LYP/6‐311++G** level. The corresponding forward/backward barrier lowerings are obtained as 24.41/24.32 kcal · mol^?1 compared with the no‐water‐assisting isomerization barrier T (65.52/43.87 kcal · mol^?1). But when adding one water molecule on the HNS, there is another special proton‐transfer isomerization pathway with a transition state 10T′ in which the water is out of the proton transfer loop. The corresponding forward/backward barriers are 65.89/65.89 kcal · mol^?1. Clearly, this process is more difficult to follow than the R–T–P process. For the two‐water‐assisting mechanism, the heat of reaction is 19.61 kcal · mol^?1, and the forward/backward barriers are 32.27/12.66 kcal · mol^?1, decreased by 33.25/31.21 kcal · mol^?1 compared with T. For trihydration and tetrahydration, the forward/backward barriers decrease as 32.00/12.60 (30T) and 37.38/17.26 (40T) kcal · mol^?1, and the heat of reaction decreases by 19.39 and 19.23 kcal · mol^?1, compared with T, respectively. But, when four water molecules are involved in the reactant loop, the corresponding energy aspects increase compared with those of the trihydration. The forward/backward barriers are increased by 5.38 and 4.66 kcal · mol^?1 than the trihydration situation. In the second mode, the outer‐sphere water effect from the other water molecules directly H‐bonded to the loop is considered. When one to three water molecules attach to the looped water in one‐water in‐loop‐assisting proton transfer isomerization, their effects on the three energies are small, and the deviations are not more than 3 kcal · mol^?1 compared with the original monohydration‐assisting case. When adding one or two water molecules on the dihydration‐assisting mechanism, and increasing one water molecule on the trihydration, the corresponding energies also are not obviously changed. The results indicate that the forward/backward barriers for the three in‐loop water‐assisting case are the lowest, and the surrounding water molecules (out‐of‐loop) yield only a small effect. © 2006 Wiley Periodicals, Inc. Int J Quantum Chem, 2006     

DFT法研究离子液中EMIM+催化丁烯双键异构反应机理(II)

用密度泛函理论(DFT)在B3LYP/6-31G(d, p)的计算水平上研究了离子液中1-乙基-3-甲基咪唑阳离子(EMIM⁺)的4-H和5-H原子催化丁烯双键异构反应的可能途径，优化了反应体系的平衡态和过渡态的几何构型，分析了反应过程中键参数的变化，通过振动分析对平衡态和过渡态进行了验证. 计算结果表明, 离子液中的EMIM⁺首先通过4-H和5-H原子吸附丁烯, 进而催化丁烯的双键异构反应, EMIM⁺的4-H和5-H催化1-丁烯异构为2-丁烯的正反应活化能分别为204.2和207.3 kJ•mol^-1，逆反应活化能约为220.9和223.8 kJ•mol^-1， 反应为基元反应.     

水杨酸与二烷基亚磷酸酯反应历程31P NMR与电喷雾质谱跟踪研究

The reaction between salicylic acid and dialkyl phosphite was traced by electrospray ionization mass spectrometry and ^31P NMR. All reactants, unstable intermediates and products were detected. The mechanism was proposed based on ESI-MS results and ^31P NMR profiles.