Interactions between synthetic and indigenous naphthenic acids and divalent cations across oil–water interfaces: effects of addition of oil-soluble non-ionic surfactants

Interactions between naphthenic acids and divalent metal cations across model oil–alkaline water interfaces were investigated by correlating changes in dynamic interfacial tension (IFT), to plausible reaction mechanisms. The measurements were carried out by using a CAM 200 optical instrument, which is based on the pendant drop technique. The naphthenic acids used were synthesised model compounds as well as commercial acid mixtures from crude distillation and extracted acid fractions from a North Sea crude oil. The divalent cations involved Ca²⁺, Mg²⁺, Sr²⁺, and Ba²⁺, which are all common in co-produced formation water and naphthenate deposits. The results show that the dynamic IFT strongly depends on naphthenic acid structure, type of divalent cation, and the concentration of the compounds as well as the pH of the aqueous phase. Introducing divalent cations to systems involving saturated naphthenic acids caused mostly a permanent lowering of the IFT. The decline in IFT is due to electrostatic attraction forces across the interface between the cations in the aqueous phase and the carboxylic-groups at the o/w interface, which cause a higher interfacial density of naphthenic acid monomers. The permanent lowering in IFT is likely due to formation of positively charged monoacid complexes, which possess high interfacial activity. On the other hand, in the case of the aromatic model compounds, the cations affected the IFT differently. This is mainly discussed in light of degree of cation hydration and steric conditions. Various oil-soluble non-ionic surfactant mixtures were also introduced to systems involving a model naphthenic acid and Ca²⁺ in order to investigate how the interfacial competition affected the local interactions. Based on the behaviour of dynamic IFT, probable inhibition mechanisms are discussed.Electronic Supplementary Material Supplementary material is available for this article at     

Kinetic aspects of the syntheses using short-lived radionuclides

“ACTIVA” is an activation analysis programme written for small computers (16 to 32 k-words) in FORTRAN-IV. Input-mode for operating commands is interactive, guided with self-explenatory questions. This enables the evaluation of gamma-spectra which could be registered under 4 different conditons (flux, geometry, etc.) with two different counting systems existing in Atominstitute. In each case another data-library with different calibration factors will be chosen and used automaticly. Programme “ACTIVA” is originally designed for gamma-spectra registered with “Loss-Free-Counting” (LFC) electronic with 2×2048 channels, but can be modified for 1024 or 4096 channels easily. Two different multichannel analysers (MCA) can be chosen for data-input: ORTEC-6240 MCA, or NOVALFC (Loss-Free-Counting). The correct energy calibration constants will also be chosen automaticly. The programme has a modular constraction and combined (linked) with overlay technique.     

Synthesis of high performance,conductive PEDOT‐coated polyester yarns by OCVD technique

Production of high performance conductive textile yarn fibers for different electronic applications has become a prominent area of many research groups throughout the world. We have used oxidative chemical vapor deposition (OCVD) technique to coat flexible and high strength polyester yarns with conjugated polymer, poly(3,4‐ethylenedioxythiophene) (PEDOT) in presence of ferric (III) chloride (FeCl₃) oxidant. OCVD is an efficient solvent free technique used to get uniform, thin, and highly conductive polymer layers on different substrates. In this paper, PEDOT‐coated polyester (PET) yarns were prepared under specific reaction conditions, and the electrical, mechanical and thermal properties were compared to previously studied PEDOT‐coated viscose yarns. Scanning electron microscopy (SEM) and FT‐IR analysis revealed that polymerization of PEDOT on the surface of the polyester yarns has been taken place successfully and structural analysis showed that PEDOT has strong interactions with viscose yarns as compared to PET yarns. The voltage–current (V–I) characteristics showed that PET yarns are more conductive than PEDOT‐coated viscose yarns. The variation in the conductivity of PEDOT‐coated yarns and the heat generation properties during the flow of current through coated yarns for longer period of time, was studied by time–current (t–I) characteristics. Thermogravimeteric analysis (TGA) was employed to investigate the thermal properties and the amount of PEDOT in PEDOT‐coated PET yarns compared to PEDOT‐coated viscose. The effect of PEDOT coating and ferric (III) chloride concentration on the mechanical properties of coated yarns was evaluated by tensile testing. The obtained PEDOT‐coated conductive polyester yarns could be used in smart clothing for medical and military applications. Copyright © 2011 John Wiley & Sons, Ltd.     

Analysis of 'ARN' naphthenic acids by high temperature gas chromatography and high performance liquid chromatography

Examination by high temperature GC (HTGC) of the methyl esters of the so-called 'ARN' naphthenic acids from crude oils of North Sea UK, Norwegian Sea and West African oilfields revealed the distributions of resolved 4-8 ring C80 tetra acids and trace amounts of other acids. Whilst all three oils contained apparently the same major acids, the proportions of each differed, possibly reflecting the growth temperatures of the archaebacteria from which the acids are assumed to have originated. The structures of the 4, 5, 7 and 8 ring acids are tentatively assigned by comparison with the known 6 ring acid and related natural products and an HPLC method for the isolation of the individual acids is described. ESI-MS of individual acids isolated by preparative HPLC established the elution order of the 4-8 ring acids on the HPLC and HTGC systems and revealed the presence of previously unreported acids tentatively identified as C81 and C82 7 and 8 ring analogues.     

ASAXS study of styrene‐grafted sulfonated poly(vinylidene fluoride) membranes

Small‐angle and wide‐angle X‐ray scattering and anomalous small‐angle X‐ray scattering were used to investigate proton‐conducting membranes prepared by radiation‐induced styrene grafting and sulfonation of commercial poly(vinylidene fluoride) (PVDF‐g‐PS) films. The membranes retain the lamellar and highly oriented structure of the original PVDF films even through excessive grafting and sulfonation. The sulfonate groups aggregate in the central part of the amorphous layers, where they form a weakly ordered structure that does not show any preferred orientation. This structure is suggested to be lamellar with alternate metal‐sulfonated hydrate and PVDF‐g‐PS layers. The lamellar period is 15.1 Å. © 2000 John Wiley & Sons, Inc. J Polym Sci B: Polym Phys 38: 1734–1748, 2000     

New rhenium-tin cluster adds palladium phosphine groups across Re-Sn bonds

The new rhenium-tin complex Re2(CO)8(mu-SnPh2)2, 1 was obtained in 52% yield from the reaction of Re2(CO)8(mu-H)[mu-C(H)C(H)Bu] with Ph3SnH. Compound 1 contains two SnPh2 groups bridging a long Re-Re single bond, Re-Re = 3.1971(4) A [3.1902(4) A], Re-Sn = 2.7429(4) A [2.7445(4) A], and 2.7675(4) [2.7682(5) A]. A bis-Pd(PBut3) adduct of 1, Pd2Re2(CO)8(mu-SnPh2)2(PBut3)2, 2 was obtained from the reaction of 1 with Pd(PBut3)2. Compound 2 contains Pd(PBut3) groups bridging two of its four Re-Sn bonds. The Re-Re bond and the unbridged Re-Sn bonds in 2 are significantly longer than those in 1, 3.245(1) A and 2.8167(14) A, respectively. Fenske-Hall molecular orbital calculations on 1 and 2 have been performed to explain the metal-metal bonding in these unusual mixed-metal polynuclear metal complexes.     

Asymmetric equilibria in dynamic two-sided matching markets with independent preferences

A fundamental fact in two-sided matching is that if a market allows several stable outcomes, then one is optimal for all men in the sense that no man would prefer another stable outcome. We study a related phenomenon of asymmetric equilibria in a dynamic market where agents enter and search for a mate for at most n rounds before exiting again. Assuming independent preferences, we find that this game has multiple equilibria, some of which are highly asymmetric between sexes. We also investigate how the set of equilibria depends on a sex difference in the outside option of not being mated at all.     

Multivariate design

In multivariate data analysis such as principal components analysis (PCA) and projections to latent structures (PLS), it is essential that the training set systems (objects) are selected to provide data with substantial information for model parametrization, and to represent properly any future situations where the multilvariate model is used for predictions. In the framework of multivariate projections (PCA, SIMCA and PLS), elementary concepts of statistical design (fractional factorials and composite designs) can be used with the latent variables (PC or PLS scores) as design variables. The plan of action thus becomes: (1) problem formulation (specify aim and model, make a conceptual division of the investigated system into subsystems); (2) collection of multivariate data for each type of subsystems; (3) estimation of the practical dimensionality of the data for each type of subsystems by PC or PLS analysis; (4) use of the PC or PLS scores (t) as design variables in the combination of subsystems to systems in the training set; (5) measurement of responses (Y); (6) analysis of data by PCA or PLS; (7) interpretation of results with possible feedback to steps 1, 2 or 3. The procedures are illustrated by two problems: a structure/activity relationship for a family of peptides, and optimization of an organic synthesis with respect to system variables (solvent, substrate, co-reactant_) and process variables (temperature, reactant concentrations).     

Non-contact protein microarray fabrication using a procedure based on liquid bridge formation

Contemporary microarrayers of contact or non-contact format used in protein microarray fabrication still suffer from a number of problems, e.g. generation of satellite spots, inhomogeneous spots, misplaced or even absent spots, and sample carryover. In this paper, a new concept of non-contact sample deposition that reduces such problems is introduced. To show the potential and robustness of this pressure-assisted deposition technique, different sample solutions known to cause severe problems or to be even impossible to print with conventional microarrayers were accurately printed. The samples included 200 mg mL^–1 human serum albumin, highly concentrated sticky cell adhesion proteins, pure high-salt cell-lysis buffer, pure DMSO, and a suspension of 5-μm polystyrene beads. Additionally, a water-immiscible liquid fluorocarbon, which was shown not to affect the functionality of the capture molecules, was employed as a lid to reduce evaporation during microarray printing. The fluorocarbon liquid lid was shown to circumvent hydrolysis of water-sensitive activated surfaces during long-term deposition procedures.     

A direct approach to Bergman kernel asymptotics for positive line bundles

We give an elementary proof of the existence of an asymptotic expansion in powers of k of the Bergman kernel associated to L ^k , where L is a positive line bundle over a compact complex manifold. We also give an algorithm for computing the coefficients in the expansion.