Study of structural and dielectric behaviour on carbon nano tube dispersed {xPVF: (1 − x)CH3COONH4} electrolyte

In the present work, improvement in ion transport property of polyvinyl formal (PVF)-based nanocomposite polymer electrolytes has been studied upon dispersal of multiwall carbon nanotube (MWCNT) filler. Nanocomposite polymer electrolyte (NCPE) films of xPVF: (1 ? x)CH₃COONH₄ (ammonium acetate) were prepared by solution cast technique. The formation of nanocomposite has been ascertained by X-ray diffraction (XRD) pattern, which also shows that doping of salt increases amorphousness through polymer salt complexation. Changes in surface morphology have been observed in optical microscopy and Scanning Electron Microscopic (SEM) images. Variation of dielectric constant, dielectric loss, tangent loss and modulus spectra with the change in frequency and temperature were studied with the aid of impedance spectroscopy.     

Simultaneous determination of centbutindole and its hydroxy metabolite in serum by high-performance liquid chromatography.

A high-performance liquid chromatographic assay has been developed and validated for the determination of centbutindole and its hydroxy metabolite in serum. The method involves extraction of serum samples with diethyl ether at pH greater than 8, back-extraction into 0.5 M hydrochloric acid and finally again with diethyl ether after addition of 2 M potassium hydroxide. Separation was accomplished by reversed-phase high-performance liquid chromatography on a cyano column with an acetonitrile-phosphate buffer system. The recovery of centbutindole and its metabolite was always greater than 80%. Calibration curves were linear over the concentration range 0.25-5 ng/ml for centbutindole and 0.05-1 ng/ml for the hydroxy metabolite. Although the lower limit of detection was 0.1 ng/ml for centbuntindole and 0.02 ng/ml for the hydroxy metabolite, the reliable limits of quantitation were 0.25 and 0.05 ng/ml, respectively, using 4 ml of serum.     

Infrared and Raman spectra of vicinally trisubstituted 2-methyl, 3-chloroaniline and 2-methyl, 6-chloroaniline

The IR and Raman spectra of 2-methyl, 3-chloroaniline (2-M, 3-CA) and 2-methyl, 6-chloroaniline (2-M, 6-CA) have been recorded at room temperature in the region 3600-100 cm⁻¹. A vibrational analysis has been made using additional frequencies obtained from IR studies at 223 and 123 K and also including the polarization measurement of the Raman lines. A comparative study of these two molecules together with the spectra of 2,3-dimethylaniline (2,3-DMA), investigated earlier, has been presented. The anomalous behaviour of certain normal modes at low temperatures indicates the presence of an intermolecular hydrogen bonding of the N-H…N type in 2-M, 3-CA and 2,3-DMA, whereas, in 2-M, 6-CA, an intramolecular hydrogen bonding of the type N-H…Cl has been detected owing to the presence of the highly electronegative Cl atom at the ortho position.     

Kinetic determination of silver at trace level based on its catalytic effect on a ligand substitution reaction

It is observed that Ag(I) catalyzes the rate of substitution of phenylhydrazine (PhNHNH₂) into hexacyanoferrate(II), producing a cherry red colored complex, [Fe(CN)₅PhNHNH₂]³⁻. The reaction was monitored at 488 nm leading to the formation of the complex under the conditions: [Fe(CN)₆]⁴⁻ (5.0 × 10⁻³ mol dm⁻³), PhNHNH₂ (2.0 × 10⁻³ mol dm⁻³), temperature (25 ± 0.1 °C), pH (2.8 ± 0.02), and ionic strength, I (0.02 mol dm⁻³), (KNO₃). Under optimum conditions, absorbance at fixed times (A _t ) is linearly related to Ag(I) in the concentration range 10.79–97.08 ng cm⁻³, in the presence of several diverse ions. The highest percentage error and relative standard deviations in the entire range of Ag(I) determination are found to be 2.5% and 0.16, with a detection limit of 8.75 ng cm⁻³ of silver(I). The experimental accuracies expressed in terms of percentage recoveries are in the range of 97.87–102.50. The method was successfully applied for the determination of Ag(I) in a few synthetic samples and found to be in good agreement with those obtained from atomic absorption spectrophotometry (AAS). The validity of the proposed method has also been tested for Ag(I) determination in spiked drinking water samples. The present catalytic kinetic method (CKM) is highly sensitive, selective, reproducible, and inexpensive. A review of recently published catalytic spectrophotometric methods for determination of Ag(I) has also been presented for comparison.     

pH-dependent Raman study of pyrrole and its vibrational analysis using DFT calculations

Raman spectra of pyrrole in aqueous medium at different pH values, 2.5, 5.5, 7.5 and 10.5 were recorded in the two spectral regions, 1,040-1,160 cm(-1) and 3,300-3,360 cm(-1) and pH dependence of the linewidth, peak position and intensity of the Raman bands corresponding to the ring breathing and symmetric nu(N-H) stretching modes were examined. A linear pH dependence of the peak positions for the ring breathing mode and a maximum at nearly neutral pH (7.5) for the symmetric nu(N-H) normal mode is observed, whereas the linewidth (FWHM) shows almost no variation with the change of pH. A slight decrease in the wavenumber position of the nu(N-H) mode at pH value >7.5 indicates that the influence of deprotonation is small, which results from a weak interaction between the reference molecule and the surrounding environment. The density functional theory (DFT) calculations were made primarily to obtain the optimized geometry and vibrational spectra of pyrrole in the ground electronic state using B3LYP functional and the highest level basis set 6-311++G(d,p). The assignments of the normal modes of pyrrole were made on the basis of potential energy distribution (PED). The calculations were also performed on protonated and deprotonated structures of pyrrole.     

Identification and characterization of in vitro and in vivo fidarestat metabolites: Toxicity and efficacy evaluation of metabolites

The progression of diabetic complications can be prevented by inhibition of aldose reductase and fidarestat considered to be highly potent. To date, metabolites of the fidarestat, toxicity, and efficacy are unknown. Therefore, the present study on characterization of hitherto unknown in vitro and in vivo metabolites of fidarestat using liquid chromatography–electrospray ionization tandem mass spectrometry (LC/ESI/MS/MS) is undertaken. In vitro and in vivo metabolites of fidarestat have been identified and characterized by using LC/ESI/MS/MS and accurate mass measurements. To identify in vivo metabolites, plasma, urine, and feces samples were collected after oral administration of fidarestat to Sprague–Dawley rats, whereas for in vitro metabolites, fidarestat was incubated in human S9 fraction, human liver microsomes, and rat liver microsomes. Furthermore, in silico toxicity and efficacy of the identified metabolites were evaluated. Eighteen metabolites have been identified. The main in vitro phase I metabolites of fidarestat are oxidative deamination, oxidative deamination and hydroxylation, reductive defluroniation, and trihydroxylation. Phase II metabolites are methylation, acetylation, glycosylation, cysteamination, and glucuronidation. Docking studies suggest that oxidative deaminated metabolite has better docking energy and conformation that keeps consensus with fidarestat whereas the rest of the metabolites do not give satisfactory results. Aldose reductase activity has been determined for oxidative deaminated metabolite (F‐1), and it shows an IC50 value of 0.44 μM. The major metabolite, oxidative deaminated, did not show any cytotoxicity in H9C2, HEK, HEPG2, and Panc1 cell lines. However, in silico toxicity, the predication result showed toxicity in skin irritation and ocular irritancy SEV/MOD versus MLD/NON (v5.1) model for fidarestat and its all metabolites. In drug discovery and development research, it is distinctly the case that the potential for pharmacologically active metabolites must be considered. Thus, the active metabolites of fidarestat may have an advantage as drug candidates as many drugs were initially observed as metabolites.     

Effect of temperature on AC conductivity of poly(butyl methacrylate)/cerium dioxide nanocomposites and applicability of different conductivity modeling studies

In this research, the effect of cerium dioxide (CeO₂) nanoparticles on electrical properties of poly(butyl methacrylate) (PBMA) has been investigated. Polymer nanocomposites reinforced with variable contents of CeO₂ nanoparticles (3, 5, 7 and 10 wt%) were fabricated by an in situ polymerization method. The formation of nanocomposites was analyzed by FTIR, XRD, SEM and TEM analysis. Also, the AC and DC conductivities of CeO₂ nanoparticles-reinforced PBMA were systematically studied with respect to different loadings of CeO₂ fillers. The FTIR, XRD and morphological studies revealed that the nanoparticles were well inserted and uniformly dispersed into the macromolecular chain of PBMA. The AC conductivity of PBMA/CeO₂ composite increases not only with the loading of nanoparticles but also with the temperature of the system. The activation energy determined from AC electrical conductivity was found to decrease with the frequency and temperature. DC conductivity of the nanocomposites was increased with the insertion of nanoparticles into PBMA. The DC conductivity of all the composites was greater than pure PBMA. The applicability of different theoretical models such as Scarisbrick, Bueche and McCullough equations was compared with the experimentally determined DC conductivity of PBMA/CeO₂ nanocomposites. These models fail to explain the conductivity of polymer composite in the entire loading of fillers. Hence, a new theoretical model is proposed in this study and it shows good agreement with the experimentally observed conductivity values.

     

(4aR,8aS,9aR,10aS)‐8a,9a‐Difluoro‐1,4,4a,5,8,8a,9,9a,10,10a‐decahydroanthracene‐4a,10a‐diol hemihydrate

The title compound, C₁₄H₁₈F₂O₂·0.5H₂O, a hemihydrate of a C_s‐symmetric unsaturated difluorodiol, crystallizes in the centrosymmetric space group P2/m (Z = 4). The asymmetric unit contains two crystallographically independent difluorodiol half‐molecules, occupying the mirror planes at (x, 0, z) and (x, , z), and half a molecule of water, lying on the twofold axis at (0, y, 0). Four difluorodiol molecules self‐assemble around each solvent water molecule via O—H...O hydrogen bonds in a near tetrahedral symmetry to generate a cylindrical column‐like architecture.     

A theoretical charge density study on nitrogen-rich 4,4′,5,5′-tetranitro-2,2′-bi-1H-imidazole (TNBI) energetic molecule

The bond topological and electrostatic properties of nitrogen-rich 4,4′,5,5′-tetranitro-2,2′-bi-1H-imidazole (TNBI) energetic molecule have been calculated from the DFT method with the basis set 6-311G** and the AIM theory. The optimized geometry of this molecule is almost matched with the experimental geometric parameters. The electron density at the bond critical point and the Laplacian of electron density of C–NO₂ bonds are not equal, one of them is much weaker than the other. Similar trend exists in the C–N bonds of the imidazole ring of the molecule. The ratio of the bond dissociation energy (BDE) of the weakest bond to the molecular total energy exhibits nearly a linear correlation with the impact sensitivity; its h ₅₀% value is ~32.01 cm. The electrostatic potential around both the nitro groups are found unequal; the NO₂ group of weakest C–NO₂ bond exhibits an extended electronegative region.     

Multicolored and white-light phosphors based on doped GdF3 nanoparticles and their potential bio-applications

Rare-earth-doped gadolinium fluoride nanocrystals were synthesized by a single step synthesis employing ethylene glycol as solvent. Based on X-ray diffraction studies, stabilization of hexagonal modification of GdF(3) has been inferred. The microscopic studies show formation of uniformly distributed nanocrystals (~15 nm). The nanoparticles are readily dispersible in water and show bright luminescence in colloidal solution. The luminescence properties have been investigated as a function of activator concentrations, and enhanced optical properties have been attributed to efficient energy transfer from the Gd(3+) to the activator RE(3+) ions, which has further been confirmed by steady-state and time-resolved optical studies. It has been demonstrated that on doping appropriate amount of activators in host GdF(3), a novel white-light-emitting phosphor is obtained with CIE co-ordinates and correlated color temperature (CCT) very close to broad daylight. This can have promising applications as phosphor for white-light ultraviolet-light-emitting diodes (UV-LEDs). Our experiments showed efficient labeling of human breast carcinoma cells (MCF-7) by Tb(3+)-doped GdF(3) nanoparticles. The fluorescence intensity was found to be dependent on the surface modifying/coating agent, and the results were validated using confocal microscopy in terms of localization of these functionalized nanoparticles.