Faceted structures in Langmuir monolayers of diethylene glycol mono-n-octadecyl ether at the air--water interface

We have concurrently studied the surface pressure (pi) versus area (A) isotherms and microscopic surface morphological features of Langmuir monolayers of diethylene glycol mono-n-octadecyl ether (C18E2) by film balance and Brewster angle microscopy (BAM) over a wide range of temperature. At temperatures < or =10 degrees C, the monolayers exist in the form of condensed phase even just after the evaporation of the spreading solvent, suggesting that the melting point of the condensed phase is above this temperature. At > or =15 degrees C, the monolayers can exist as gas (G), liquid expanded (LE), and liquid condensed (LC) phases and undergo a pressure-induced first-order phase transition between LE and LC phases showing a sharp cusp point followed by a plateau region in the pi-A isotherms. A variety of 2-D structures, depending on the subphase temperature, are observed by BAM just after the appearance of the cusp point. It is interesting to note here that the domains attain increasingly large and compact shape as the subphase temperature increases and finally give faceted structures with sharp edges and corners at > or =30 degrees C. The BAM observations were coupled with polarization modulation infrared reflection absorption spectroscopy (PM-IRRAS) to gain better understanding regarding the conformational order and subcell packing of the molecules. The constancy of the methylene stretching modes over the studied temperature range suggests that the hydrocarbon chains do not undergo any conformational changes upon compression of the monolayer. However, the full width at half-maximum (fwhm) values of the asymmetric methylene stretching mode (nu(as)(CH(2))) are found to respond differently with changes in temperature. It is concluded that even though the trans/gauche ratio of the hydrocarbon chains remains virtually constant, the LE-LC phase transition upon compression of the monolayer is accompanied by a loss of the rotational freedom of the molecules.     

Biologically active metabolites from fungi, 19: new isocoumarins and highly substituted benzoic acids from the endophytic fungus, Scytalidium sp

Six known metabolites, two new isocoumarins 4 and 8, and one new highly substituted benzoic acid derivative 9 were isolated from the ethyl acetate culture extract of a fungal endophyte, Scytalidium sp. In addition, another new benzoic acid 10 with an unusual 1,2-dicarbonyl side chain was indirectly identified from its methylated derivatives 10a-10d.     

Studies on the thermal behaviour of detonating fuse and detonators

Investigations of the thermal stability of detonating fuse containing 10 g pentaerythrol tetranitrate (PETN) revealed that the cord burnt under unconfinement at 403 K. Under confinement in a steel pipe or copper tube there was a partial detonation at 403 K. In order to characterize the thermal stability of PETN and pyrotechnic composition used in fuse head of electric detonators differential thermal analysis (DTA) was used.The electric detonators of aluminium cell and copper cell were heated from ambient temperature to 373 K at an average rate of 0.4 deg/min. The rate of heating was increased gradually to 1.5 deg/min till explosion. The detonation temperature varied between 373 K and 375 K.The impact and friction sensitivity of detonating fuse was poor. There was no detonation when a 5 kg hammer was repeatedly hit over the fuse from a height of one metre. There was no detonation when the detonating fuse was rubbed by a blunt edge of steel plate till it was smashed.

---

Zusammenfassung Untersuchungen der thermischen Stabilität von Sprengschnuren mit 10 gm^–1 PETN zeigten, daß die Schnur frei bei 403 K verbrennt. Unter Abschluß in einem Stahloder Kupferrohr tritt bei 403 K eine partielle Detonation auf. Zur Charakterisierung der thermischen Stabilität von PETN und von pyrotechnischen Mischungen, die in Zünderköpfen von elektrischen Sprengkapseln verwendet werden, wurde Differentialthermoanalyse (DTA) angewendet. Die elektrischen Sprengkapseln von Aluminium- und Kupferzellen wurden mit einer durchschnittlichen Aufheizgeschwindigkeit von 0.4 Grad/min von Raumtemperatur auf 373 K erhitzt. Die Aufheizgeschwindigkeit wurde bis zur Explosion allmählich auf 1,5 Grad/min erhöht. Die einzelnen Detonationen erfolgten bei einer Temperatur zwischen 373 und 375 K. Die Stoß- und Reibempfindlichkeit der Sprengschnur war gering. Bei einem mehrmaligen Einwirken eines 5 kg-Hammers aus einer Höhe von 1 m erfolgte keine Detonation. Bei Reiben mit der unscharfen Kante einer Stahlplatte bis zur Zerstörung erfolgte keine Detonation.

---

, 10 ^–1 PETN, , 403 , 403 . PETN , , . 373 0,4°/. 1,5°/ . 373 375 . . 5 1 . , .

---

---

The authors are indebted to the Director, Central Mining Research Station for giving permission to publish this paper. The views expressed in the paper are those of the authors and not necessarily of the institute which they belong to.     

N-Bromosuccinimide-dibenzoyl peroxide/azabisisobutyronitrile: a reagent for Z- to E-alkene isomerization

N-Bromosuccinimide-dibenzoyl peroxide/azobisisobutyronitrile is used to carry out several types of Z- to E-alkene isomerizations. The NBS-bromination conditions are sufficient for both allylic bromination and alkene isomerization. When the allylic hydrogens are not available in substrates, only the isomerization of the alkene takes place. The present conditions for isomerization of carbon-carbon double bonds are mild and efficient.     

Aqueous polymerization of acrylonitrile by ascorbic acid–peroxodisulfate redox system

The polymerization of acrylonitrile initiated by an ascorbic acid–peroxodisulfate redox system was studied in an aqueous solution at 35°C in the presence of air. Molecular oxygen was found to have no effect on the polymerization reaction. An increase in ionic strength slightly increased the rate. The overall rate of polymerization, R_p, showed a square dependence on [monomer] and a half-order dependence on [peroxodisulfate]. A first-order dependence on [ascorbic acid] at low concentrations (<3.0 × 10^?3 mol L^?1) followed by a decrease in R_p at higher concentrations of ascorbic acid (>3.0 × 10^?3 mol L^?1) was also noted. R_p remained unchanged up to 40°C and showed a decline thereafter. Addition of catalytic amounts of cupric ions decreased the rate whereas ferric ions were found to increase the rate. Added sulfuric acid in the range (6.0?50.0) × 10^?5 mol L^?1 decreased the R_p.     

Production of indigotin in submerged culture using morchella nov. ES-1

A new strain of the fungusMorchella nov. ES-1 (ATCC 20951) that produces blue pigment in submerged culture has been isolated. The blue pigment was extracted by chloroform or ethyl acetate treatment. The crude extract when chromatographed yielded three fractions; a blue one has been identified by mass spectrometry as indigotin. Fermentation studies using enriched media revealed that maximum accumulation of indigotin in culture was approx 24 mg/L in 168 h.     

A Chebotarev Theorem for finite homogeneous extensions of shifts

We derive a Chebotarev Theorem for finite homogeneous extensions of shifts of finite type. These extensions are of the form :X×G/H→X×G/H where (x,gH)=(σx, α(x)gH), for some finite groupG and subgroupH. Given a σ-closed orbit τ, the periods of the -closed orbits covering τ define a partition of the integer |G/H|. The theorem then gives us an asymptotic formula for the number of closed orbits with respect to the various partitions of the integer |G/H|. We apply our theorem to the case of a finite extension and of an automorphism extension of shifts of finite type. We also give a further application to ‘automorphism extensions’ of hyperbolic toral automorphisms. Financially supported by Universiti Kebangsaan Malaysia     

Computational studies on glyceraldehyde and glycine Maillard reaction—I

Mechanisms for the initial stage of glyceraldehyde and glycine Maillard reaction under different pH conditions have been proposed, following usually the Hodge-scheme. Computations have been performed on the mechanisms at the standard state to test the possibility of the formation of different compounds, through evaluating the changes in Gibb's free energy during the reaction. Electronic energy changes during the reaction have also been evaluated. Glyceraldehyde+deprotonated glycine reaction has been found to be the most favorable for the formation of the Amadori rearrangement products in both gaseous and aqueous states. Due to the possibility of the production of both enol and keto forms of the Amadori rearrangement product, the rate of browning in glyceraldehyde+deprotonated glycine reaction is assumed to be faster than the others. Glyceraldehyde+unionized glycine reaction has been found to be more plausible for the formation of the keto form of the Amadori rearrangement products, particularly, in the gaseous phase. Glyceraldehyde+protonated glycine and glyceraldehyde+glycine zwitterion reactions are not favorable for the formation of the Amadori rearrangement products. Formation of hydroxyacetaldehyde from glyceralaldehyde, as one of the possible C2-fragmentation product, has been found to be favorable in the aqueous state.     

Reactions of [HOs3(CO)8{µ3-Ph2PCH(R)P(Ph)C6H4}] (R = H,Me) with Bu3SnH: synthesis and structure of bimetallic Os-Sn clusters

Reactions of unsaturated [HOs₃(CO)₈{µ₃-Ph₂PCH(R)P(Ph)C₆H₄}] (R?=?H, Me) with Bu₃SnH are examined. [HOs₃(CO)₈{µ₃-Ph₂PCH(R)P(Ph)C₆H₄}] reacts with Bu₃SnH at room temperature to afford [H₂Os₃(CO)₈(SnBu₃){µ₃-Ph₂PCH(R)P(Ph)C₆H₄}] (1) via oxidative addition of the Sn?H bond to the parent cluster. Heating 1 in refluxing toluene leads to the formation of [H₂Os₃(CO)₇(SnBu₃){µ₃-Ph₂PCH(R)P(Ph)C₆H₄}] (2) through decarbonylation. Cluster 2 exists in two isomeric forms in solution which has been probed by VT NMR spectroscopy. The new Os-Sn bimetallic clusters have been characterized by a combination of analytical and spectroscopic data together with single-crystal X-ray diffraction analysis.

Graphic abstract