Frequency Dependence of ESR in Pristine Trans-Polyacetylene: Line Width

We measured a frequency dependence of ESR line width in (CH)x and (CD)x at frequencies 5～9,500 MHz. From a detailed analysis we could independently deduce 1-D diffusion rate of electron spin (neutral soliton) D_‖ /c_‖ ², and the trapped spin concentration C between 200 and 340 K.     

Structure and catalytic properties of nanosized alumina supported platinum and palladium particles synthesized by reaction in microemulsion

Mixtures of nanosized platinum and palladium particles have been prepared by reduction of salt-containing microemulsion droplets using hydrazine as the reducing agent. To avoid possible negative effects of the presence of sulfur compounds during the preparation the microemulsion was made using the sulfur-free nonionic polyoxyethylene 4 lauryl ether surfactant. Transmission electron microscopy showed that the as-prepared mixtures contained crystalline platinum particles of fairly homogeneous size (20 to 40 nm) with adsorbed amorphous palladium particles 2 to 5 nm in size. Catalyst samples were prepared by depositing the nanoparticles on a gamma-Al(2)O(3) support followed by heating in air at 600 degrees C. Alloyed particles of platinum and palladium with sizes ranging from 5 to 80 nm were obtained during the heating. The majority of the particles had the fcc structure and their compositional range was dependent upon the Pt:Pd molar ratio of the microemulsion. A catalyst prepared from a microemulsion with a 20:80 Pt:Pd molar ratio showed the highest catalytic activity for CO oxidation, while pure platinum and palladium catalysts showed higher sulfur resistance. These results differ from the performance of conventional wet-impregnated catalysts, where a 50:50 Pt:Pd molar ratio resulted in the highest catalytic activity as well as the highest sulfur resistance.     

Hydrogen-bond-assisted control of H versus J aggregation mode of porphyrins stacks in an organogel system

To obtain insights into a correlation relationship between the structure and the aggregation mode in an organogel system, we synthesized gelators 2a-4a bearing a porphyrin moiety as a one-dimensional aggregation unit and amide groups as peripheral hydrogen-bonding sites. Gelators 3a and 3b bearing the amide groups at the 4-position of the meso-phenyl groups are classified as versatile gelators, gelating 10 and 14 solvents, respectively, among 23 solvents tested herein. In contrast, gelators 2a and 4a bearing the amide groups at the 3,5-positions and 3-position, respectively, are classified as poor gelators. Examination by spectroscopic methods (UV-vis, ATR-FTIR, XRD, etc.) revealed that in the organogel phase porphyrins in 3a adopt the H aggregation mode whereas those in 2a and 4a adopt the J aggregation mode. X-ray analysis of the single crystals established that in fact 3b features a columnar stack of porphyrin moieties that can be classified as the H-aggregate, whereas 2a results in a two-dimensional a-b plane, in which porphyrin moieties are arranged in the J-aggregate. Very interestingly, the difference in the H versus J aggregation mode is well-reflected by the difference in the macroscopic aggregate morphology observed by SEM: 3a + cyclohexane gel results in a one-dimensionally aggregated fibrillar structure, whereas 2a + cyclohexane gel results in a two-dimensional sheetlike structure. These findings indicate that the H versus J aggregation mode of porphyrin stacks can be controlled by the peripheral hydrogen-bonding interactions and the microscopic hydrogen-bonding network structure is well-reflected by the macroscopic SEM-observed structure.     

Effect of diet on aflatoxin B1-DNA binding and aflatoxin B1-induced glutathione S-transferase placental form positive hepatic foci in the rat

Effects of diets on hepatic aflatoxin B1 (AFB1)- DNA binding and AFB1-induced glutathione S- transferase placental (GST-P) form positive hepatic foci have been examined in young male Fischer rats. Animals were fed either AIN-76A or Purina Chow (PC) diet for 1 wk before AFB1- DNA binding studies in vivo and in vitro. Animals were injected i.p. with AFB1 (1 mug/kg body wt) and 3 days later were given either AIN-76A or PC diet with or without 0.1% phenobarbital (PB) in their drinking water. All animals were sacrificed 10 wks after AFB1 dosing for analysis of AFB1-induced GST-P positive hepatic foci by immunochemistry. Two h after i.p. injection of AFB1, hepatic AFB1-DNA binding in AIN-76A fed rats was twice as much as those in PC fed animals without affecting GSH levels. There was no significant effect of diet on either cytochrome P-450 content, GSH levels or microsomal cytochrome P-450 mediated AFB1-DNA binding to exogenous DNA. There was a 40% increase in cytosolic GSH S-transferase activity with 1-chloro-2,4-dinitrobenzene as a substrate in PC fed animals compared to those given AIN- 76A diet. The number and area of AFB1-induced GST-P positive hepatic foci were twice and fivefold as much in AIN-76A fed compared to those in PC fed rats. The number of AFB1-induced GST-P positive foci was increased 5-10 fold in the presence of PB in both groups. In summary, the present data indicate that feeding of PC diet compared to AIN-76A diet inhibits the initiation phase whereas AIN-76A stimulates the promotion phase of AFB1 hepatocarcinogenesis in rats by inhibiting AFB1-DNA binding and increasing AFB1-induced hepatic foci respectively.     

Crystal structure and peroxidase activity of myoglobin reconstituted with iron porphycene

The incorporation of an artificially created metal complex into an apomyoglobin is one of the attractive methods in a series of hemoprotein modifications. Single crystals of sperm whale myoglobin reconstituted with 13,16-dicarboxyethyl-2,7-diethyl-3,6,12,17-tetramethylporphycenatoiron(III) were obtained in the imidazole buffer, and the 3D structure with a 2.25-A resolution indicates that the iron porphycene, a structural isomer of hemin, is located in the normal position of the heme pocket. Furthermore, it was found that the reconstituted myoglobin catalyzed the H2O2-dependent oxidations of substrates such as guaiacol, thioanisole, and styrene. At pH 7.0 and 20 degrees C, the initial rate of the guaiacol oxidation is 11-fold faster than that observed for the native myoglobin. Moreover, the stopped-flow analysis of the reaction of the reconstituted protein with H2O2 suggested the formation of two reaction intermediates, compounds II- and III-like species, in the absence of a substrate. It is a rare example that compound III is formed via compound II in myoglobin chemistry. The enhancement of the peroxidase activity and the formation of the stable compound III in myoglobin with iron porphycene mainly arise from the strong coordination of the Fe-His93 bond.     

Phase‐Transfer‐Catalyzed Asymmetric SNAr Reaction of α‐Amino Acid Derivatives with Arene Chromium Complexes

Although phase‐transfer‐catalyzed asymmetric S_NAr reactions provide unique contribution to the catalytic asymmetric α‐arylations of carbonyl compounds to produce biologically active α‐aryl carbonyl compounds, the electrophiles were limited to arenes bearing strong electron‐withdrawing groups, such as a nitro group. To overcome this limitation, we examined the asymmetric S_NAr reactions of α‐amino acid derivatives with arene chromium complexes derived from fluoroarenes, including those containing electron‐donating substituents. The arylation was efficiently promoted by binaphthyl‐modified chiral phase‐transfer catalysts to give the corresponding α,α‐disubstituted α‐amino acids containing various aromatic substituents with high enantioselectivities.     

Syntheses and properties of liquid crystalline N-substituted pyrroles and their polymers

Three liquid crystalline N-substituted pyrroles were synthesized from 6-(1-pyrrolyl)hexanol with phenolic derivatives having a mesogenic core of cyclohexylbenzene or biphenyl by Mitsunobu reaction. These pyrroles had two anodic peaks at 1.4 and 1.8 V (vs. SCE). The former was due to an oxidation of the pyrrole moiety and the latter was due to an oxidation of the mesogenic moiety. These pyrrole monomers were polymerized by electrochemical and chemical methods. The potentiostatic method and the chemical method using FeCl₃ gave a soluble and fusible polymer, respectively. A polymer having a mesogenic core of cyclohexyl benzene obtained by the chemical method and a polymer having a mesogenic core of biphenylketone obtained by the potentiostatic method had a liquid-crystalline phase. The phase was identified as smectic A by polarizing microscopy and XRD analysis. © 1998 John Wiley & Sons, Inc. J Polym Sci A: Polym Chem 36: 2691–2698, 1998     

Cellulose alkyl ester/poly(<Emphasis Type="Italic">ε</Emphasis>-caprolactone) blends: characterization of miscibility and crystallization behaviour

Cellulose valerate (CV)/poly(ε-caprolactone) (PCL) blends were investigated to clarify the effect of the degree of substitution (DS) of the cellulose ester component on the miscibility. CVs of DS > 2.15 were miscible with PCL in their amorphous states, as judged from the detection of a single T _g by differential scanning calorimetry (DSC). This result and other complementary data for cellulose acetate (CA), propionate (CP), and butyrate (CB) blends with PCL made up a miscibility map as a function of the number N of carbons in the normal acyl substituent as well as of DS. CB of N = 4 and CV of N = 5, the ester side-chains of which make a higher similarity in chemical structure with a repeating unit of PCL, were found to be miscible with the aliphatic polyester at a comparatively lower DS; the critical butyryl DS of ∼1.85 being still lower than 2.15. For PCL-rich compositions of CB(DS > 2.0)/PCL and CV(DS > 2.2)/PCL blends, isothermal melt-crystallization behaviour was characterized by calorimetry and polarized optical microscopy. The CB and CV components gave rise to a marked diminution of the crystallization rate of PCL, as a result of the diluent action of the cellulose esters in the respective miscible, molten mixtures. Through a quantitative analysis of the kinetics, it is suggested regarding the supramolecular morphology that the bulky cellulose esters would be trapped not only on the fold surfaces but also on the growth faces of PCL lamellar crystals, to form a non-crystalline mixed polymer phase in the crystal boundary regions.     

Hydrogen‐Bonding Catalysis of Alkyl‐Onium Salts

The synthetic utility of alkyl‐onium salt compounds is widely recognized in the field of organic chemistry. Among the wide variety of onium salts, quaternary ammonium, phosphonium, and tertiary sulfonium salts have been the most useful compounds in organic syntheses. These compounds have been very useful reagents in the construction of organic building blocks. In addition, onium salts are known as reliable catalysts, which are used to promote important organic transformations by serving as phase‐transfer and ion‐pair catalysts through the activation of nucleophiles. Although phase‐transfer catalysis is a major direction for onium salt catalysis, hydrogen‐bonding catalysis of alkyl‐onium salts, which is promoted via the activation of electrophiles, has recently become a relevant topic in the field of onium salt chemistry. This Minireview introduces new possibilities and future directions for alkyl‐onium salt chemistry based on its use in hydrogen‐bonding catalysis and on its overall utility.     

Angle-controlled arrangement of single-walled carbon nanotubes solubilised by 8-quinolinol metal chelate derivatives on mica

We solubilised SWNTs of short length using a mechanochemical high-speed vibration milling (HSVM) through formation of complexes between the SWNTs and chelate complexes; the mixture formed a network structure on mica.