Photophysics of aromatic molecules with low-lying pi sigma* states: excitation-energy dependence of fluorescence in jet-cooled aromatic nitriles

Excitation-energy dependence of fluorescence intensity and fluorescence lifetime has been measured for 4-dimethylaminobenzonitrile (DMABN), 4-aminobenzonitrile (ABN), 4-diisopropylaminobenzonitrile (DIABN), and 1-naphthonitrile (NN) in a supersonic free jet. In all cases, the fluorescence yield decreases rather dramatically, whereas the fluorescence lifetime decreases only moderately for S1 (pi pi*, L(b)) excess vibrational energy exceeding about 1000 cm(-1). This is confirmed by comparison of the normalized fluorescence excitation spectrum with the absorption spectrum of the compound in the vapor phase. The result indicates that the strong decrease in the relative fluorescence yield at higher energies is due mostly to a decrease in the radiative decay rate of the emitting state. Comparison of the experimental results with the TDDFT potential energy curves for excited states strongly suggests that the decrease in the radiative decay rate of the aminobenzonitriles at higher energies is due to the crossing of the pi pi* singlet state by the lower-lying pi sigma*(C[triple bond]N) singlet state of very small radiative decay rate. The threshold energy for the fluorescence "break-off" is in good agreement with the computed energy barrier for the pi pi*/pi sigma* crossing. For NN, on the other hand, the observed decrease is in fluorescence yield at higher excitation energies can best be attributed to the crossing of the pi pi* singlet state by the pi sigma* triplet state.     

New intra-intermolecular criss-cross cycloaddition of unsymmetrical allenylazines with alkynes leading to three fused five-membered heterocycles

This report describes a new type of intra-intermolecular criss-cross cycloadditions. Thermal reactions of unsymmetrical allenylazines in the presence of alkynes led to three fused five-membered heterocycles in some cases. In the case of unsymmetrical substituted alkynes, a regioselectivity was observed. The molecular structures of all products are discussed. One X-ray crystal structure is also reported.     

The Two-Dimensional Electrides XONa (X=Mg,Ca) as Novel Natural Hyperbolic Materials

In two-dimensional electrides, anionic electrons are spatially confined in interlayer regions with high density, comparable to metals, and they are highly mobile, just as free electrons, resembling hyperbolic metamaterials with metal-dielectric multilayered structures. In this work, two-dimensional electride materials MgONa and CaONa are proposed as good natural hyperbolic materials. By using the first-principles calculations based on density functional theory (DFT), the electronic structures, stabilities, and optical properties of two-dimensional electride materials XONa (X=Mg, Ca) are investigated. Our results show that they are stable in 1-monolayer (1-ML) structures as well as in bulk states. They exhibit hyperbolic dispersions from visible to near infrared spectral range with high qualities up to about 700, which is two orders-of-magnitude larger than the preceding bulk hyperbolic materials. Numerical results reveal that they exhibit negative refraction with low losses. Their high-quality hyperbolic responses over a wide spectral range pave the way of broad photonic applications as natural hyperbolic materials.     

Thermal stability and flammability of styrene–butadiene rubber (SBR) composites

The article presents the effect of attapulgite (ATT) and its synergic action with carbon or silica on the thermal properties and flammability of cross-linked styrene–butadiene rubber. It has been shown that ATT is active filler improving the thermal and mechanical properties of composites containing this aluminosilicate. The decreased flammability of vulcanizates containing ATT compared to that of unfilled vulcanizates results from good insulating properties of the ATT used. The considerable reduction in the flammability of composites containing ATT and carbon nanofiber or silica is connected, first of all, with the formation of a homogeneous boundary layer.     

Effect of viscosity of a liquid membrane containing oleyl alcohol on the pertraction of butyric acid

Solvent formulation is important in the optimization of the mass-transfer through supported liquid membranes (SLM) in pertraction and membrane extraction. Oleyl alcohol (OA) is frequently used as the solvent or diluent in the extraction of carboxylic acids. A disadvantage of OA is its relatively high viscosity of 28.32 mPa s at 25°C. This can be decreased by the application of a less viscous OA diluent, e.g. dodecane. The relationship between the ratio of the distribution coefficient of butyric acid (BA), D _F, and the viscosity of OA-dodecane solvents, µ, as extraction and transport characteristics, and the overall mass-transfer coefficient, K _p, through SLMs was analyzed. Dependence of the D _F/µ ratio on the OA concentration showed a maximum at the OA concentration of 15 mass % to 30 mass %. The OA concentration dependence of K _p for SLMs exhibited also a maximum at about 30 mass % and 20 mass % of OA at the BA concentration driving force of 0.12 kmol m^?3 and 0.3 kmol m^?3, respectively. Shifting of the maximum in K _p dependences towards lower OA concentrations by increasing the BA concentration driving force is in agreement with the D _F/µ ratio dependence. Using pure OA as the solvent or diluent is not preferable and a mixture of a low viscosity diluent with the OA concentration below 40 mass % should be used. The presented results show the potential of the D _F/µ ratio in the screening and formulation of solvents in extraction and SLM optimization.     

Study of carbon black obtained by pyrolysis of waste scrap tyres

Waste scrap tyres were thermally decomposed under various conditions. Decompositions were followed by the TGA method. Specific heating regimes were tested to obtain optimal structural properties of resulting pyrolytic carbon black produced by pyrolysis of scrap tyres and the process was characterized in temperature interval from 380 to 1,200 °C and heating rate 10, 20 and 50 °C min^?1 under nitrogen atmosphere. The original scrap tyres and pyrolytic carbon black were characterized by Raman and Fourier transform infrared spectroscopy methods. Textural properties were also determined. Effect of temperature and heating rate on process of pyrolysis of scrap tyres was observed. Shifting of temperature of maximum pyrolysis rate to lower value and spreading of DTG peak is caused by increasing heating rate. Temperature 570 °C was sufficient for total scrap tyres pyrolysis. Graphitic and disordered structure was distinguished in the formed carbon black by Raman spectroscopy. With increasing temperature, heating rate and weight loss, the amount of the graphitic structure was reduced at the expense of disordered structure. Destruction of nonporous scrap tyres and formation of porous structure took place at higher temperature. Porous carbon black is formed above 380 °C, specific surface area increased up to 88 m² g^?1 .     

Electrochemical DNA biosensor for human papillomavirus 16 detection in real samples

An electrochemical DNA biosensor for human papillomavirus (HPV) 16 detection has been developed. For this proposed biosensor, l-cysteine was first electrodeposited on the gold electrode surface to form l-cysteine film (CYSFILM). Subsequently, HPV16-specific probe was immobilized on the electrode surface with CYSFILM. Electrochemistry measurement was studied by differential pulse voltammetry method (DPV). The measurement was based on the reduction signals of methylene blue (MB) before and after hybridization either between probe and synthetic target or extracted DNA from clinical samples. The effect of probe concentration was analyzed and the best results were seen at 1000 nM. The hybridization detection presented high sensitivity and broad linear response to the synthetic-target concentration comprised between 18.75 nM and 250 nM as well as to a detection limit of 18.13 nM. The performance of this biosensor was also investigated by checking probe-modified electrode hybridization with extracted DNA from samples. The results showed that the biosensor was successfully developed and exhibited high sensitivity and satisfactory selectivity to HPV16. These results allow for the possibility of developing a new portable detection system for HPVs and for providing help in making an effective diagnosis in the early stages of infection.     

Comparison of Oxidative Aromatic Coupling and the Scholl Reaction

Does the dehydrogenative coupling of aromatic compounds mediated by AlCl₃ at high temperatures and also by FeCl₃, MoCl₅, PIFA, or K₃[Fe(CN)₆] at room temperature proceed by the same mechanism in all cases? With the growing importance of the synthesis of aromatic compounds by double C? H activation to give various biaryl structures, this question becomes pressing. Since some of these reactions proceed only in the presence of non‐oxidizing Lewis acids and some only in the presence of certain oxidants, the authors venture the hypothesis that, depending on the electronic structure of the substrates and the nature of the “catalyst”, two different mechanisms can operate. One involves the intermediacy of a radical cation and the other the formation of a sigma complex between the acid and the substrate. The goal of this Review is to encourage further mechanistic studies hopefully leading to an in‐depth understanding of this phenomenon.     

Modulating Properties of Piroxicam,Meloxicam and Oxicam Analogues against Macrophage-Associated Chemokines in Colorectal Cancer

The mechanisms underlying the antineoplastic effects of oxicams have not been fully elucidated. We aimed to assess the effect of classic and novel oxicams on the expression/secretion of macrophage-associated chemokines (RTqPCR/Luminex xMAP) in colorectal adenocarcinoma cells, and on the expression of upstream the non-steroidal anti-inflammatory drug (NSAID)-activated genes NAG1, NFKBIA, MYD88, and RELA, as well as at the chemokine profiling in colorectal tumors. Meloxicam downregulated CCL4 9.9-fold, but otherwise the classic oxicams had a negligible/non-significant effect. Novel analogues with a thiazine ring substituted with arylpiperazine and benzoyl moieties significantly modulated chemokine expression to varying degree, upregulated NAG1 and NFKBIA, and downregulated MYD88. They inhibited CCL3 and CCL4, and their effect on CCL2 and CXCL2 depended on the dose and exposure. The propylene linker between thiazine and piperazine nitrogens and one arylpiperazine fluorine substituent characterized the most effective analogue. Only CCL19 and CXCL2 were not upregulated in tumors, nor was CXCL2 in tumor-adjacent tissue compared to normal mucosa. Compared to adjacent tissue, CCL4 and CXCL2 were upregulated, while CCL2, CCL8, and CCL19 were downregulated in tumors. Tumor CCL2 and CCL7 increased along with advancing T and CCL3, and CCL4 along with the N stage. The introduction of arylpiperazine and benzoyl moieties into the oxicam scaffold yields effective modulators of chemokine expression, which act by upregulating NAG1 and interfering with NF-κB signaling.