稀掺杂GaNxAs1－x(x≤0.03)薄膜的调制光谱研究

利用室温下压电调制反射光(PzR)谱技术系统测量了N掺杂浓度为0.0%—3%的分子束外延生长GaN_xAs_1-x薄膜，并对图谱中所观察的光学跃迁进行了指认.在GaN_0.005As_0.995和GaN_0.01As_0.99薄膜的PzR谱中观察到此前只在椭圆偏振谱中才看到的N掺杂相关能态E₁+Δ₁+Δ_N.当N掺杂浓度达到 关键词： 压电调制反射光谱(PzR) xAs_1-x薄膜')" href="#">GaN_xAs_1-x薄膜 分子束外延(MBE)     

CsNiCl3晶体的光谱精细结构、零场分裂参量及Jahn-Teller效应

应用不可约张量理论构造了三角对称晶场中3d²/3d⁸态离子的45阶可完全对角化的微扰哈密顿矩阵，研究了CsNiCl₃晶体的光谱精细结构、晶体结构、零场分裂参量、Jahn-Telller效应以及自旋单重态对Ni²⁺离子基态能级的影响，理论与实验相符合.在此基础上，进一步研究了以前工作中被忽略的自旋-自旋耦合作用和Trees修正对CsNiCl₃晶体的光谱精细结构和零场分裂参量的影响，发现有四种机理会影响零场分裂参量：1)自旋-轨道耦合机理，2)自旋-自旋耦合机理；3)自旋-轨道与自旋-自旋联合耦合机理；4)自旋-轨道与Trees修正联合耦合机理，其中自旋-轨道耦合机理是最主要的，其他三种机理也是不可忽略的. 关键词： 基态能级 精细结构 零场分裂 自旋-自旋耦合     

980 nm激发下Er3+/Yb3+共掺杂ZrO2-Al2O3粉末的上转换发光特性

通过固相反应法制备了Er3+/Yb3+共掺杂ZrO2-Al2O3粉末的样品,并对样品在980nm激光激发下的上转换发光特性进行了研究.从发射光谱可以发现,在可见光范围内有3个强的发光带,一个位于654nm附近的红光带和两个分别位于545nm、525nm附近的绿光带,分别对应于Er3+离子的以下辐射跃迁:4F9/2→4I15/2、4S3/2→4I15/2、2H11/2→4I15/2.其中又以Er3+离子的4F9/2→4I15/2跃迁产生的红色荧光辐射最强.对其上转换发光机制进行了分析,发现这三个发光过程都是双光子过程.对样品粉末进行了XRD检测,发现ZrO2主要以立方相为主,并且计算得到了这种立方结构的晶格常数.Al2O3固溶于ZrO2中,Al3+嵌入ZrO2后产生氧空位,导致ZrO2晶体的对称性降低,这种结构变化更有利于提高上转换效率,即上转换发光强度增强.     

(111)择优取向的Pb(Zr0.52Ti0.48)O3铁电薄膜的制备及研究

选用不同浓度的Pb(Zr_0.52Ti_0.48)O₃溶胶，用Sol-gel法在Pt/Ti/SiO₂/Si基片上沉积一层厚度不同的Pb(Zr_0.52Ti_0.48)O₃ (PZT52)过渡层，经400℃烘烤、550℃退火等程序后，再用Sol-gel法在PZT52过渡层上沉积Pb(Zr_0.52Ti_0.48)O _{关键词： PZT铁电薄膜 择优取向 过渡层 剩余极化强度}     

The Calibrating Theory in the Network Parameters Measurement of Microwave and MMW Devices

The paper introduces a special system calibration technology in s-parameters measurement of microwave and millimeter wave devices. The 8-term errors module is built by analyzing the signals flowing in the measurement system. Then the calibration technology using non-standard kits is designed on the base. Finally, the experiment using the calibration technology is introduced.     

Challenging Students to View the Concept of Area in Triangles in a Broad Context: Exploiting the Features of Cabri-II

This study focuses on the constructions in terms of area and perimeter in equivalent triangles developed by students aged 12–15 years-old, using the tools provided by Cabri-Geometry II [Labore (1990). Cabri-Geometry (software), Université de Grenoble]. Twenty-five students participated in a learning experiment where they were asked to construct: (a) pairs of equivalent triangles “in as many ways as possible” and to study their area and their perimeter using any of the tools provided and (b) “any possible sequence of modifications of an original triangle into other equivalent ones”. As regards the concept of area and in contrast to a paper and pencil environment, Cabri provided students with different and potential opportunities in terms of: (a) means of construction, (b) control, (c) variety of representations and (d) linking representations, by exploiting its capability for continuous modifications. By exploiting these opportunities in the context of the given open tasks, students were helped by the tools provided to develop a broader view of the concept of area than the typical view they would construct in a typical paper and pencil environment.     

The number of limit cycles of cubic Hamiltonian system with perturbation

In this paper, by using qualitative analysis, we investigate the number of limit cycles of perturbed cubic Hamiltonian system with perturbation in the form of (2n+2m) or (2n+2m+1)th degree polynomials . We show that the perturbed systems has at most (n+m) limit cycles, and has at most n limit cycles if m=1. If m=1, n=1 and m=1, n=2, the general conditions for the number of existing limit cycles and the stability of the limit cycles will be established, respectively. Such conditions depend on the coefficients of the perturbed terms. In order to illustrate our results, two numerical examples on the location and stability of the limit cycles are given.     

高频强泵浦场激发的等离子体参量不稳定性的特性

本文论证了当泵浦波的强度足够强时,在相当普遍的条件下,对均匀等离子体,唯一可以发生的参量不稳定性是类似于弱场的振荡二束不稳定性(OTSI)。对均匀及弱不均匀等离子体,高频强泵浦场激发的参量不稳定性都是绝对不稳定性。同样的性质在磁化等离子体中也可以得到。 关键词：     

激光等离子体2660紫外探针及干涉系统

成功地在六路高功率Nd玻璃激光装置上建立了2660紫外激光探针和适合紫外波段的Normaski干涉仪,首次将可见波长的连续激光应用于紫外干涉仪中靶成像调整和光路准直。利用该紫外光干涉仪,在铜柱状靶(φ500μm)上测量了厚等离子体中高达0.6n。的电子密度。     

Error analysis: a tool for selecting travel demand models

In developing travel demand models it is generally assumed that the base-year data used in developing the parameters, as well as the forecasted data to be used as independent variables for the design year, are of acceptable quality. The purpose of this paper is to present the application of error propagation theory in assesing the predictive quality of one type of travel demand forecasting model (multinomial logit models) and to demonstrate how error considerations can be used as a tool for identifying the optimal model. The general conclusions of this study are that: (1) it is indeed possible to quantify errors in dependent variables in logit models as a consequence of errors in independent variables; and (2) error consideration can be used as a tool for identifying the optimal model from a set of candidate models. Further research is recommended to develop better insights into the phenomenon of error propagation so that the consideration of errors can be a factor in decisions on model selection.