Energy Recovery from Municipal Solid Waste in Small Communities

The heating values of municipal solid waste generated in three towns with a population of less than 50 000, situated in Galicia (Spain), were measured with a static bomb calorimeter. Samples of raw refuse were burnt either as received or after sorting of the different combustible components. A study was made of samples from controlled and uncontrolled landfills. The calorific values were compared with those corresponding to a commercial residual derived fuel in order to study the possibility of using municipal solid waste as a source of recovered energy. This revised version was published online in July 2006 with corrections to the Cover Date.     

Inexpensive device for measurements with ion-selective and pH electrodes

The design and construction of a simple device for measuring ionic concentrations (or pH) with ion-selective electrodes are described. The automated system includes a special electronic circuit with an operational amplifier, a signal conditioner and a personalcomputer. A digital multimeter can be used if automation is not required. The results obtained in tests with iodide-, chloride- and nitrate-selective electrodes and glass electrodes show very good agreement with those obtained with sophisticated commercial apparatus.     

Extraction and spectrophotometric determination of titanium(IV) with alizarin and fluoride

The characteristics of the mixed-ligand titanium(IV)-fluoride-alizarin complex, including the optimum conditions of formation and extraction into methyl isobutyl ketone, are described. A simple and sensitive procedure for spectrophotometric determination of titanium has been developed. At pH 9.5-10.3 titanium reacts with alizarin in the presence of fluoride to form a red-violet complex that is completely extractable into methyl isobutyl ketone, and has its absorption maximum at 513 nm. The molar absorptivity at 513 nm is 7.0 x 10(4)l.mole(-1).cm(-1). Beer's law is obeyed up to 22 mug of titanium in 30 ml of solution. The method has been used for the determination of titanium in an oxide mixture and aluminium alloy samples.     

Labelling of organotin compounds for fluorimetric detection

A systematic study of the fluorescence of complexes of some flavone derivatives with organotin compounds in hexane and in an aqueous micellar medium on Triton X-100 is reported. Some relationships between fluorescence intensity and the structure of the fluorogenic reagent or that of the organotin compound can be deduced, and the most suitable reagent for each organotin species can be chosen on the basis of sensitivity and selectivity. Results point out that flavone derivatives are appropriate post-column derivatization reagents for organotin compounds in liquid chromatography.     

Determination of sulfametoxazole, sulfadiazine and associated compounds in pharmaceutical preparations by capillary zone electrophoresis

A capillary zone electrophoresis method is presented to separate sulfadiazine, sulfamethoxazole, trimethoprim, bromhexine and guaiacol by using a fused-silica capillary (60.2 cm x 75 microm I.D.). The separation was carried out at 30 kV and 25 degrees C in a 15 mM phosphate buffer adjusted to pH 6.2 as electrolyte. Under these conditions, the run time was 6 min and the limits of quantification were about 1 mg/l for every component. The method was applied to pharmaceutical preparations and the results provided recoveries close to 100%.     

thermal stability of epoxy systems badge (n=0)/1,2-dch and badge (n=0)/ 1,2-dch/vinylcyclohexene dioxide

The thermal degradation of the epoxy system diglycidyl ether of bisphenol A (BADGE n=0)/1,2-diamine cyclohexane (DCH) containing different concentrations of an epoxy reactive diluent was studied by thermogravimetric analysis in order to determine the reaction mechanism of the degradation process and to compare it with the results for the same system without diluent. The value of the activation energy, necessary for this study, was calculated using various integral and differential methods. Values obtained using the different methods were compared to the value obtained by the Flynn-Wall-Ozawa"s method (between 193-240 kJ mol^-1 depending on the diluent concentration) with does not require a knowledge of the nth order reaction mechanism. All the experimental results were compared to master curves in the range of Doyle"s approximation (20-35% of conversion). Analysis of the results suggests that the reaction mechanism could be F₂, F₃, or A₂ type. This revised version was published online in July 2006 with corrections to the Cover Date.     

高效液相色谱与原子荧光光谱联用分析汞化合物形态的研究

建立了高效液相色谱与原子荧光光谱联用测定汞化合物形态的分析方法。实验对淋洗液组分浓度、氧化剂和还原剂浓度、载气流速及紫外消解管长度等操作条件进行了优化,获得了令人满意的分析结果。在优化的分离检测条件下,20μg/L的汞化合物标准溶液平行7次进样分析,甲基汞、无机汞和乙基汞的色谱峰高的相对标准偏差(RSD)分别为2.0%、2.9%和2.4%;3种汞化合物的线性范围为10~1000μg/L,25μL进样检出限分别为3、2和4μg/L。用建立的方法测定了脉红螺样品中甲基汞的含量,甲基汞和乙基汞的加标回收率分别为90%和92%。     

Gas-phase structure of protonated histidine and histidine methyl ester: combined experimental mass spectrometry and theoretical ab initio study

Gas-phase H/D exchange experiments with CD3OD and D2O and quantum chemical ab initio G3(MP2) calculations were carried out on protonated histidine and protonated histidine methyl ester in order to elucidate their bonding and structure. The H/D exchange experiments show that both ions have three equivalent fast hydrogens and one appreciably slower exchangeable hydrogen assigned to the protonated amino group participating in a strong intramolecular hydrogen bond (IHB) with the nearest N(sp2) nitrogen of the imidazole fragment and to the distal ring NH-group, respectively. It is taken for granted that the proton exchange in the IHB is much faster than the H/D exchange. Unlike in other protonated amino acids (glycine, proline, phenylalanine, tyrosine, and tryptophan) studied earlier, the exchange rate of the carboxyl group in protonated histidine is slower than that of the amino group. The most stable conformers and the enthalpies of neutral and protonated histidine and its methyl ester are calculated at the G3(MP2) level of theory. It is shown that strong intramolecular hydrogen bonding between the amino group and the imidazole ring nitrogen sites is responsible for the stability and specific properties of the protonated histidine. It is found that the proton fluctuates between the amino and imidazole groups in the protonated form across an almost vanishing barrier. Proton affinity (PA) of histidine calculated by the G3(MP2) method is 233.2 and 232.4 kcal mol(-1) for protonation at the imidazole ring and at the amino group nitrogens, respectively, which is about 3-5 kcal mol(-1) lower than the reported experimental value.     

Reversal of stereoselectivity in [5 + 2] pyrone--alkene cycloadditons using a sulfoxide-to-sulfoximine switch. Enantiodivergent synthesis of 8-oxabicyclo[3.2.1]octane systems

[reaction: see text] Switching from a sulfinyl to a sulfonimidoyl group allows the reversal of the sense of asymmetric induction in thermal [5C + 2C] intramolecular pyrone-alkene cycloadditions. Removal of the sulfoximine unit from the resulting cycloadducts yields optically active oxabicyclic systems that are enantiomeric to those obtained using the sulfinyl chiral auxiliary.     

Excess enthalpies of ethylbenzene + alkane systems at 25°C. An interpretation in terms of the Prigogine-Flory-Patterson model

The molar excess enthalpies for the ethylbenzene + n-decane and ethylbenzene + n-tetradecane systems have been measured at 25°C over the complete concentration range. These results and others from the literature for alkanes + ethylbenzene, and alkanes + toluene have been discussed in terms of the Prigogine-Flory-Patterson theory.