Separation of polycyclic aromatic hydrocarbons by micellar electrokinetic chromatography with aqueous short-chain alcohol solvent

Micellar electrokinetic capillary chromatography (MEKC) with aqueous organic solvent has been developed to separate polycyclic aromatic hydrocarbons (PAHs). Methanol, ethanol or propanol as an organic modifier was added to sodium dodecyl sulfate (SDS) micellar solution in order to increase the solubility of very hydrophobic solutes in mobile phase. Both methanol and ethanol can be used as co-solvents for the separation of PAHs. Use of ethanol resulted in a shorter analysis time than use of methanol. The separations of some PAHs were unsatisfactory using propanol although the analysis time was much shorter than with ethanol. The influence of ethanol content, SDS concentration and temperature on the separations was studied. Benzene and nine polycyclic aromatic hydrocarbons were successfully separated using 50 mM SDS-20 mM phosphate-5 mM borate, containing 40% (v/v) ethanol at 35 degrees C. The relative standard deviation (R.S.D.) of t(R) ranged from 0.5 to 1.5% for six repeat injections.     

Control of mesoporous structure of aerogels derived from cresol-formaldehyde

Polycondensation of a cresol mixture (C(m)) with formaldehyde (F) in basic aqueous solutions leads to formation of highly cross-linked C(m)F aquagels that can be supercritically dried with carbon dioxide to form organic C(m)F aerogels. Aerogels synthesized with different catalyst contents and reactant concentrations are characterized by low-temperature nitrogen adsorption. The present experimental results suggest that the C(m)F aerogels are typical mesoporous materials and have almost no micropores in bulk. The microstructure of the organic C(m)F aerogels can be controlled and tailored effectively by varying synthesis conditions during the initial sol-gel process. C(m)F organic aerogels with specific surface area as high as 627 m(2)/g and corresponding pore volume 2.06 ml/g have been obtained with a dominant pore size of 30 nm. C(m)F organic aerogels with peaky pore size distributions concentrated at 11 nm have also been prepared.     

The theoretical basis of column chromatography in multicomponent separations. Part 2: Peak capacity. Column systems with good selectivity

The selectivity of a column system, S, defined by equation 28, includes a variation coefficient (β) of plate number with capacity ratio which has a large influence on the peak capacity, as shown in Fig. 18. Some typical chromatograms are given. In order to predict S for a column system from Kovat's Index, equations 40 and 41 are given to calculate the constant of the carbon number rule for squalane at different temperatures or for different stationary phases. The specific retention value of heptane on squalane at different temperatures can be calculated from equation 42. The nonpolarity index, defined by equation 43, was used to calculate the retention value of heptane on various stationary phases. In liquid chromatography, the order of elution may be reversed by changing the composition of the eluent on the same chemically bonded silica (manufactured in China). The linear relations between the log retention values of different kinds of solutes or of a single solute on the silicas of different surface areas when using the same eluent are given.     

One-Pot Formation of Carbonates from the Reactions of Carbonyl Compounds with Samarium Diiodide and Methyl Chloroformate

Treatment of carbonyl compounds with SmI₂ and methyl chloroformate in the presence of molecular sieves provides the cyclic carbonates or biscarbonates of pinacols. This one-pot reaction proceeds rapidly even with aliphatic ketones. The stereochemistry obtained by this procedure is different from that of conventional pinacolic couplings.     

双酚-S-双(3-甲基丙烯酰氧基-2-羟丙基)醚的聚合及其应用

以MMA为起始原料经转变为GMA,再与双酚-S反应合成了一种新的含有砜基的交联剂BisS-GMA。这种双酚-S型交联剂与MMA可以顺利地用紫外光或BPO-胺体系引发聚合。新的双酚-S型交联剂BisS-GMA与双酚-A型交联剂Bis-GMA相比,具有活性高与粘结强度高两个显著优点。它还可以和二氧化硅填料混合组成复合树脂,经光引发或BPO-DHET体系引发聚合,得到的复合树脂其物性已达到国外同类产品的水平。DHET作为促进剂要比DMT性能好,前者配制的交联剂液体组份贮存稳定性好,经半年后而不“失活”,后者配制的液体组份则在较短的时间内“失活”。     

Resolution of the non-steady-state kinetics of the two-step mechanism for the Diels-Alder reaction between anthracene and tetracyanoethylene in acetonitrile

The Diels-Alder reaction between anthracene and tetracyanoethylene in acetonitrile does not reach a steady-state during the first half-life. The reaction follows the reversible consecutive second-order mechanism accompanied by the formation of a kinetically significant intermediate. The experimental observations consistent with this mechanism include extent of reaction-time profiles which deviate markedly from those expected for the irreversible second-order mechanism and initial pseudo first-order rate constants which differ significantly from those measured at longer times. It is concluded that the reaction intermediate giving rise to these deviations cannot be the charge-transfer (CT) complex, which is formed during the time of mixing, but rather a more intimate complex with a geometry favorable to the formation of the Diels-Alder adduct. The kinetics of the reaction were resolved into the microscopic rate constants for the individual steps. The rate constants, as shown in equation 1, at 293 K were observed to be 5.46 M(-)(1) s(-)(1) (k(f)), 14.8 s(-)(1) (k(b)), and 12.4 s(-)(1) (k(p)). Concentration profiles calculated under all conditions show that intermediate concentrations increase to maximum values early in the reaction and then continually decay during the first half-life. It is concluded that the charge-transfer complex may be an intermediate preceding the formation of the reactant complex, but due to its rapid formation and dissociation it is not detected by the kinetic measurements.