页岩矿物不同润湿性表征与吸附微观机理

无机矿物作为页岩气吸附的重要载体,其表面性质对甲烷吸附能力有着重要影响,而润湿性作为固体重要表面性质之一,对矿物气体吸附能力的影响不可忽视.文章以蒙脱石和石英作为研究对象,通过对矿物表面甲基化(-CH₃)和羟基化(-OH)处理来改变其润湿性,以探究无机矿物表面润湿性对甲烷吸附能力的影响.采用分子动力学方法研究矿物体系的润湿性,用接触角对润湿性进行定量表征,并构建纳米狭缝,结合巨正则蒙特卡罗方法模拟润湿性改变前后,CH₄在矿物中的吸附变化.研究结果表明,水滴在羟基化矿物表面迅速破裂并铺展在矿物表面,而在甲基化表面铺展程度较小,普遍呈半球形.羟基化蒙脱石和石英表面的润湿接触角分别为12.7°和26.5°,均小于其甲基化表面接触角62.5°和85.7°.甲基化矿物甲烷吸附量均高于其羟基化,气体几乎大都以吸附状态位于孔隙壁面,随着矿物亲水性的减弱,其对甲烷吸附能力增强.     

掺铥氟磷玻璃的结构、热学性质和光谱性质

制备了不同Al(PO3)3含量的掺铥系列氟磷玻璃,研究了其结构、热稳定性和光谱性质。随着Al(PO3)3含量的增加,该系列玻璃的密度降低,折射率增加,差热分析表明,转变温度、析晶起始温度、析晶峰温度和熔化温度增加。Al(PO3)3摩尔浓度在7%~9%时析晶稳定性最佳。采用归一化的拉曼光谱分析了材料的结构和声子状况,对于该系列氟磷玻璃,Al(PO3)3含量的增加不会影响声子能量,但使声子密度增大。测试了样品的吸收光谱,Tm3 的3H6→3F4在第三通信窗口的L波段有明显吸收。与在其它玻璃基质中相比,Tm3 的3F4能级对应能量偏高,3H4能级对应能量偏低,使得3H4→3F4跃迁波长较大,接近于增益迁移光纤放大器的放大波长。扎得奥菲而特(Judd-Ofelt)理论分析表明随着Al(PO3)3含量增加,离子强度参量Ω2增大,Ω6保持相对稳定,Tm3 的能级寿命降低。     

Very high coercivities of top-layer diffusion Au/FePt thin films

The Au/FePt samples were prepared by depositing a gold cap layer at room temperature onto a fully ordered FePt layer, followed by an annealing at 800 °C for the purpose of interlayer diffusion. After the deposition of the gold layer and the high-temperature annealing, the gold atoms do not dissolve into the FePt Ll₀ lattice. Compared with the continuous FePt film, the TEM photos of the bilayer Au(60 nm)/FePt(60 nm) show a granular structure with FePt particles embedded in Au matrix. The coercivity of Au(60 nm)/FePt(60 nm) sample is 23.5 kOe, which is 85% larger than that of the FePt film without Au top layer. The enhancement in coercivity can be attributed to the formation of isolated structure of FePt ordered phase.     

新型宽谱电磁脉冲试验系统

 研制了一套新型宽谱电磁脉冲试验系统,该系统采用全电感隔离型重复频率Marx发生器产生高压冲击脉冲,经双极脉冲形成线馈入宽带天线进行宽谱辐射。介绍了发生器工作原理和双极脉冲形成原理。实验结果表明：发生器输出脉冲电压500 kV,脉冲前沿20 ns,重复频率20 Hz,宽谱辐射因子195 kV,辐射中心频率200 MHz,频谱宽度37%。该试验系统结构紧凑、操作灵活,并具有方位辐射方向360°旋转和运程控制等功能。     

Single atom entropy squeezing for two two-level atoms interacting with a binomial field

In this paper we consider a system of two two-level atoms interacting with a binomial field in an ideal cavity. We investigate the time evolution of the single atom entropy squeezing, atomic inversion and the linear entropy for the present system. Furthermore, the relationship between the entropy squeezing and the entanglement is investigated. It is shown that the amounts of the nonclassical effects exhibited in the entropy squeezing are dependent on the different initial conditions. The entropy squeezing can give information on the corresponding linear entropy.     

GaN基薄膜半导体材料不同非线性效应的竞争关系

采用金属有机化合物化学气相沉积方法生长了未掺杂GaN,p型Mg掺杂GaN,InGaN/GaN多量子阱等薄膜半导体材料,研究了其在800 nm飞秒激光激发下的非线性光学性质.实验结果表明,在800 nm飞秒激光激发下,多光子荧光、二次谐波等非线性光学信号之间存在着竞争关系,反映出不同非线性光学信号对激发光的能量分配存在着竞争,并通过其非线性光学信号强度与激发强度之间的依赖关系进行了验证.同时,本文对其竞争机理进行了初步探究.     

铟镓锌氧薄膜晶体管的悬浮栅效应研究

为了避免光照对铟镓锌氧薄膜晶体管(InGaZnO thin film transistors,IGZO TFTs)电学特性的影响,IGZO TFT要增加遮光金属层.本文研究了遮光金属栅极悬浮时,IGZO TFT的输出特性.采用器件数值计算工具TCAD(technology computer-aided design)分析了IGZO层与栅介质层界面处电势分布,证实了悬浮栅(floating gate,FG)IGZO TFT输出曲线的不饱和现象是由悬浮栅与TFT漏端的电容耦合造成.基于等效电容的电压分配方法,提出了悬浮栅IGZO TFT电流的一阶模型.TCAD数值分析及一阶物理模型结果与测试具有较高程度的符合,较完整地解释了悬浮栅IGZO TFT的电学特性.     

A Fast Algorithm for Wave Propagation from a Plane or a Cylindrical Surface

The newly developed Taylor-Interpolation-FFT (TI-FFT) algorithm dramatically increases the computational speeds for millimeter wave propagation from a planar (cylindrical) surface onto a “quasi-planar” (“quasi-cylindrical”) surface. Two different scenarios are considered in this article: the planar TI-FFT is for the computation of the wave propagation from a plane onto a “quasi-planar” surface and the cylindrical TI-FFT is for the computation of wave propagation from a cylindrical surface onto a “quasi-cylindrical” surface. Due to the use of the FFT, the TI-FFT algorithm has a computational complexity of O(N ² log₂  N ²) for an N × N computational grid, instead of N ⁴ for the direct integration method. The TI-FFT algorithm has a low sampling rate according to the Nyquist sampling theorem. The algorithm has accuracy down to −80 dB and it works particularly well for narrow-band fields and “quasi-planar” (“quasi-cylindrical”) surfaces.     

掺钕微球的受激辐射激光和自受激拉曼散射

采用溶胶-凝胶法在SiO_2微球表面覆盖上一薄层Nd~(3+)掺杂SiO_2,并经电极放电熔融后形成表面光滑的高Q值微球.采用锥光纤将808 nm的抽运激光耦合入钕离子掺杂的高Q值微球形成回廊模,激发产生了1080—1097 nm波段受激辐射激光.由于所产生的激光有足够高的功率密度,在高Q SiO_2微球中激发产生了波长为1120—1143 nm一级自受激拉曼散射激光.推导了锥光纤掺钕微球组合的自受激拉曼散射的输出功率和阈值公式.描述了输出激光的特性:阈值、输出功率、线宽、边模抑制比.     

低阈值单横模852nm半导体激光器

基于波导理论、等效折射率方法,设计并制备了非对称波导隔离双沟结构脊型边发射激光器,最终获得了低闽值单基侧模852 nm激光器.详细研究了不同脊型台深宽比参数设计对激光器侧向模式特性的影响规律,实现了腔面未镀膜情况下脊型波导边发射激光器的单基侧模稳定输出,同时激射波长可以精确调谐到852 nm;工作电流达到150 mA,工作温度30℃;斜率效率最高可达0.89 nW/mA,光谱半宽小于1 nm.研究结果为进一步实现超窄线宽激光器提供了参考和借鉴,并且为实现激光器稳定输出提供了实验基础.