Effect of trabecular bone material properties on ultrasonic backscattering signals

In this study, ultrasonic backscattering signals in cancellous bones were obtained by finite difference time domain （FDTD） simulations, and the effect of trabecular material properties on these signals was analyzed. The backscatter coefficient （BSC） and integrated backscatter coefficient （IBC） were numerically investigated for varying trabecular bone material properties, including density, Lame coefficients, viscosities, and resistance coefficients. The results show that the BSC is a complex function of trabecular bone density, and the IBC increases as density increases. The BSC and IBC increase with the first and second Lame coefficients. While not very sensitive to the second viscosity of the trabeculae, the BSC and IBC decrease as the first viscosity and resistance coefficients increase. The results demonstrate that, in addition to bone mineral density （BMD） and microarchitecture, trabecular material properties significantly influence ultrasonic backseattering signals in cancellous bones. This research furthers the understanding of ultrasonic backscattering in cancellous bones and the characterization of cancellous bone status.     

膜流动电位测试中Ag-AgCl电极的制备及稳定性研究

膜的动电特性研究中,往往采用流动电位方法。该方法中,Ag-Ag Cl测试电极的质量是影响测试准确性的关键要素。本文采用正交试验设计和方差分析,着重考察电解法制备Ag-Ag Cl电极过程中,电流强度(I)、氯化时间(t)、电解质溶液浓度(CHCl)、电极来源(n)、烘烤温度(T)、活化电极溶液浓度(CKCl)等因素对Ag-Ag Cl电极稳定性的影响。得到Ag-Ag Cl电极的最优制备参数为:电流密度3.0m A/cm2,氯化时间50min,盐酸浓度0.1mol·L-1,烘烤温度120℃,活化电极溶液(KCl)浓度0.001mol·L-1;最显著影响因素为电极来源,显著影响因素为氯化时间和烘烤温度。对最优条件组合下制备的AgAg Cl电极,进行了稳定性实验,结果表明:制备的电极具有较好的稳定性,24h内电极电位漂移量小于0.10mv,7天内电极电位漂移量小于0.2mv;在聚偏氟乙烯中空纤维超滤膜流动电位测试中,流动电位与流动压差具有良好的线性和可重复性,回归曲线R20.99,变化规律符合Helmholtz-Smoluehowski公式,可以较好满足膜的流动电位测试要求。     

金的化学状态对Au／CoCeOx催化剂CO氧化性能的影响

以CoCeOx复合氧化物为载体,采用沉积沉淀法制备了负载型的金催化剂,并通过不同温度的预处理控制Au的化学状态. 使用粉末X射线衍射、高分辨透射电子显微镜、程序升温还原和X射线光电子能谱对催化剂进行了表征,考察了在室温条件下该系列催化剂的一氧化碳氧化性能. 结果表明, Au/CoCeOx催化剂的CO氧化性能与催化剂表面Au 的含量成正比, Au 可能是反应的主要活性物种. 添加水汽对反应有一定的促进作用,但由于Au 不能稳定存在,特别是当催化剂表面Au 的含量过高时,在水汽的作用下Au 迅速发生歧化反应,使得催化剂的性能下降.     

Effect of selected signals of interest on ultrasonic backscattering measurement in cancellous bones

This study examined how the signals of interest (SOI) effect on the backscattering measurement numerically based on 3-D finite-difference time-domain (FDTD) method. High resolution microstructure mappings of bovine cancellous bones provided by micro-CT were used as the input geometry for simulations. Backscatter coefficient (BSC), integrated backscatter coefficient (IBC) and apparent integrated backscatter (AIB) were calculated with changing the start (L1) and duration (L2) of the SOI. The results demonstrated that BSC and IBC decrease as L1 increases, and AIB decreases more rapidly as L1 increases. The backscattering parameters increase with fluctuations as a function of L2 when L2 is less than 6 mm. However, BSC and IBC change little as L2 continues to increase, while AIB slowly decreases as L2 continues to increase. The results showed how the selections of the SOI effect on the backscattering measurement. An explicit standard for SOI selection was proposed in this study and short L1 (about 1.5 mm) and appropriate L2 (6 mm-12 mm) were recommended for the calculations of backscattering parameters.     

吡咯亚胺配体与过渡金属的反应性及其催化烯烃聚合

在经典的Brookhart吡啶双亚胺后过渡金属烯烃聚合催化剂基础上,用吡咯五元环代替吡啶六元环骨架可得到具有不同电子效应的新型吡咯亚胺配体.通过吡咯环特殊的电子效应和位阻效应可设计出种类繁多的有别于吡啶亚胺配体的配合物.综述了吡咯亚胺配体与前过渡金属(Ti,Zr等)、后过渡金属(Fe,Co,Ni,Pd等)、稀土金属(Y...     

On the universality of crossing probabilities in two-dimensional percolation

Six percolation models in two dimensions are studied: percolation by sites and by bonds on square, hexagonal, and triangular lattices. Rectangles of widtha and heightb are superimposed on the lattices and four functions, representing the probabilities of certain crossings from one interval to another on the sides, are measured numerically as functions of the ratioa/b. In the limits set by the sample size and by the conventions and on the range of the ratioa/b measured, the four functions coincide for the six models. We conclude that the values of the four functions can be used as coordinates of the renormalization-group fixed point.     

A Simple and Rapid Label-free Fluorimetric “Turn Off-on” Sensor for Cadmium Detection Using Glutathione-capped CdS Quantum Dots

A convenient label-free fluorescence(FL) nanoprobe for rapid detection of cadmium(Cd) was established using glutathione-capped CdS quantum dots(QDs) and 1,10-phenanthroline(phen). The prepared CdS QDs exhibited a strong FL emission at 536 nm, which could be quenched by phen due to the photoinduced hole transfer(PHT) mechanism. The existence of Cd effectively recovered the FL intensity of CdS QDs, which was due to the easy detachment of phen from the surface of QDs to form[Cd(phen)₂(H₂O)₂]²⁺ in solution. Cd concentrations were linearly correlated with the FL intensity in the range of 0.0625-1.25 μmol/L under the optimized conditions and the detection limit was 0.01 μmol/L. Finally, the Cd concentration was accurately quantified in real water sample using the proposed sensor.     

The Picard Theorem on S-metric spaces

Recently, the notion of an S-metric space is defined and extensively studied as a generalization of a metric space. In this paper, we define the notion of the S∞-space and prove its completeness. We obtain a new generalization of the classical "Picard Theorem".     

超声导波的频散补偿与模式分离算法研究

超声导波已被广泛应用于无损检测与评价,针对超声导波应用中普遍存在的模式混叠与频散问题,本文在采用频谱相位与信号时延函数建模导波频散信号传递系统的基础上,提出了一种单一模式的频散补偿算法。进一步地,通过将选择性频散补偿技术与导波模式分离相结合,本文算法克服了传统补偿算法所不能解决的多模式导波频散问题。板中的Lamb波A0,A1和S0混合模式仿真分析表明,本算法不仅可用于单一导波模式信号合成与频散补偿,而且可在实现多模式混合导波信号选择性频散补偿基础上,解决多模式导波信号中单一模式提取与分离。本文研究有助于超声导波多模式频散信号的分析与处理.     

Barker码激励超声导波在长骨检测中的应用

单脉冲激励的超声导波在长骨中传播时,信号的衰减大,导致接收信号的幅度很小,且噪声严重。Barker码激励能有效增大接收信号幅度,提高信噪比(SNR)。将其应用到超声导波长骨检测中,进行仿真和长骨实验,得到的信号分别用加权匹配滤波器和有限冲激响应-最小均方误差(FIR-LS)逆滤波器进行压缩,并与单脉冲激励的结果进行了对比。结果表明,对于13位的Barker码,采用加权匹配滤波器进行解码时,压缩信号幅度是单脉冲激励接收信号的13倍;而FIR-LS逆滤波器则达到-63.59 dB的峰值旁瓣水平(PSL),更好地抑制噪声。说明可以将Barker码激励超声导波应用于长骨的检测中。