亚细胞器诱导的2,4,6-三硝基甲苯阴离子自由基的ESR研究

本文在无氧条件下利用ESR分别观察了肝脏和晶状体的微粒体及线粒体酶在NADPH存在下还原三硝基甲苯(TNT)的过程,检测到参数为g=2.0048±0.0005,A_对位~N=1.215mT,A~N=0.800±0.010mT,A~H=0.122±0.0206mT的自由基信号,并通过电子计算机对ESR谱的模拟证明该自由基信号为TNT硝基阴离子自由基,根据其超精细分裂常数认为,其不配对电子的电子云密度主要分布在对位硝基上。     

Diffusion via splitting and remeshing via merging in vortex methods

The technique of splitting a fat vortex element (with a core width larger than some threshold) into some thin ones in order to fix the convergence problem of the core‐spreading vortex methods is convenient and efficient. In particular, it keeps the method purely Lagrangian. In the present investigation, the splitting process is further viewed as part of the physical diffusion process. A new splitting method in which several weaker child vortices surround a thinned but still strong parent vortex is proposed. It is found that because of the survival of the parent vortex, the error arising from the splitting events can be largely reduced. The computational amount on the other hand is kept reasonably large by merging similar and close‐by vortices. The merging scheme designed herein not only involves fewer restrictions but also allows merging vortices of opposite rotations through the viewpoint of remeshing. The validity and accuracy of these techniques, proposed particularly for simulations undergoing lots of splitting and merging events, are verified by successfully simulating the interactions between two Burgers vortices under an external straining field. Copyright © 2005 John Wiley & Sons, Ltd.     

一类广义长短波方程的整体适定性

In the present paper,we investigate the well-posedness of the global solution for the Cauchy problem of generalized long-short wave equations.Applying Kato's method for abstract quasi-linear evolution equations and a priori estimates of solution,we get the existence of globally smooth solution.     

管肋式辐射器排热特性的数值分析与优化设计

为得到按单面辐射方式布置的管肋式空间辐射器的排热特性，建立了相应的数学模型．采用数值模拟方法分析了管内流体温度、肋片几何尺寸和等效热沉温度对辐射器排热特性的影响，得到了不同参数值下辐射器单位面积排热量以及特定参数范围内的辐射器肋片最佳宽度和肋片效率．数值模拟结果对辐射器的工程结构设计以及空间站热管理方案的优化分析具有一定的参考价值．     

类氢及碱金属原子激发态寿命的半经典计算公式

根据对应原理,得到了类氢原子能态平均寿命半经典的计算公式τ(n,l),然后利用相对论单通道量子数亏损理论进行推广,得到用来计算考虑总角动量J的激发态寿命公式τ(n,l,l+1/2)和τ(n,l,l-1/2),利用单通道量子数亏损理论得到了碱金属原子n、l远大于1时激发态寿命的半经典公式τ(n.l)=τ0(m+M/nm/v/+M)2v7l(l+1/2)/n4,其计算结果和实验数据符合的很好.     

Self-Assembly of Micro-Parts onto Si Substrates at Liquid-Liquid Interface

We report a new approach for the self-assembly of cuboid micro-parts onto Si substrates to construct three-dimensional microstructures. To perform assembly, the Si substrates are prepared with a deep cavity array as binding sites. An aggregate composed of hundreds of uniformly aligned micro-parts is formed at the C10F18-H2O interface. The micro-parts are arranged by passing the substrate through the aggregate of micro-parts, thus the micro-parts are left on the substrate, and then the substrate is vibrated ultrasonically in the solution, making it possible for the micro-parts to fall into the cavities on the substrate. Finally the substrate is pulled out of the solution after assembly. This technique could give a high yield of up to 70%, providing a new method for micro-assembly.     

Phenylene vinylene‐based electroluminescent polymers with electron transport block in the main chain

We report a new route for the design of soluble phenylene vinylene (PV) based electroluminescent polymers bearing electron‐deficient oxadizole (OXD) and triazole (TZ) moieties in the main chains with the aryloxy linkage. Both series of the PV‐based polymers were prepared by Wittig reaction. By properly adjusting the OXD and/or TZ content through copolymerization, we can achieve an enhanced balance of hole‐ and electron injections, such that the device efficiency is significantly improved. Light‐emitting diodes fabricated from P1, P2, P3, P4, P5, P6, and P7 with the configuration of Indium–Tin Oxide (ITO)/Poly (styrene sulfonic acid) doped poly (ethylenedioxythiophene) (PEDOT)/polymer/Ca/Al, emit bright green light with the maximum peak around 500 nm. For the device using the optimal polymer (P4) as emitting layer, a maximum brightness of 1300 cd/m² at 20 V and a maximum luminance efficiency of 0.325 cd/A can be obtained. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 3469–3478, 2006     

Synthesis and application as polymer electrolyte of hyperbranched polyether made by cationic ring‐opening polymerization of 3‐{2‐[2‐(2‐hydroxyethoxy)ethoxy]ethoxymethyl}‐3′‐methyl‐oxetane

A novel cyclic ether monomer 3‐{2‐[2‐(2‐hydroxyethoxy)ethoxy]ethoxy‐methyl}‐3′‐methyloxetane (HEMO) was prepared from the reaction of 3‐hydroxymethyl‐3′‐methyloxetane tosylate with triethylene glycol. The corresponding hyperbranched polyether (PHEMO) was synthesized using BF₃·Et₂O as initiator through cationic ring‐opening polymerization. The evidence from ¹H and ¹³C NMR analyses revealed that the hyperbranched structure is constructed by the competition between two chain propagation mechanisms, i.e. active chain end and activated monomer mechanism. The terminal structure of PHEMO with a cyclic fragment was definitely detected by MALDI‐TOF measurement. A DSC test implied that the resulting polyether has excellent segment motion performance potentially beneficial for the ion transport of polymer electrolytes. Moreover, a TGA assay showed that this hyperbranched polymer possesses high thermostability as compared to its liquid counterpart. The ion conductivity was measured to reach 5.6 × 10^?5 S/cm at room temperature and 6.3 × 10^?4 S/cm at 80 °C after doped with LiTFSI at a ratio of Li:O = 0.05, presenting the promise to meet the practical requirement of lithium ion batteries for polymer electrolytes. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 3650–3665, 2006     

HER磁镜上硬X射线和热电子测量

一、引言 磁镜运行中,为了要知道它在电子回旋共振加热(ECRH)下形成热电子的参数,我们测量了硬X射线能谱、硬X射线发射的时间特性、不同磁场强度下形成热电子环的位置、以及热电子的脉冲幅度分布等。 HER是中国科学院等离子体物理研究所简单型磁镜装置,它的几何尺寸是,真空室长