Temperature effects on surface activity and application in oxidation of toluene derivatives of CTAB-SDS with KMnO4

The γ_cmc values of CTAB-SDS decrease from 63.67 mN/m at 10‡C to 36.38 mN/m at 90‡C, slightly lower than those of either CTAB or SDS. Correspondingly, the CMC of CTAB-SDS decreases almost by half. The increase of surface activity of CTAB-SDS can be attributed to the relatively weak electrostatic interaction at high temperature, which is supported by the increase of solubility of CTAB-SDS with rise in temperature. Catalytic effect on oxidation of toluene derivatives with potassium permanganate follows the order CTAB-SDS > SDS > CTAB. This is not caused by the dissociative effect of CTAB-SDS with low surface activity at low temperature, as seen from the fact that almost all oxidative products can be retrieved for different toluene derivatives and surfactants by mimicking the conditions of reaction. In the emulsifications of toluene derivatives at 90‡C, the time that turbid water layers of surfactant solutions take to become clear is the same as that of the catalytic effect on oxidation of toluene derivatives. Thus, it can be inferred that surfactants can improve the oxidation yields of toluene derivatives by increasing the contact between two reacting phases.     

Comparison of stimulated-emission-pumping fluorescence dip spectrometry and conventional fluorescence spectrometry in application to supersonic jet spectrometry

Summary A supersonic jet spectrum of 9,10-dichloroanthracene is measured by stimulated-emission-pumping fluorescence dip spectrometry and conventional fluorescence spectrometry. The performance obtained is compared for these spectrometric methods, providing same information concerned with the energy level of the ground state. The former is more preferential for measurement of a high-resolution spectrum, since the spectral resolution is determined by the linewidth of the dumping laser. On the other hand, the latter is more preferential for measurement with better sensitivity at the expense of the spectral resolution, since the fluorescence throughput can be improved by increasing the slit width of the monochromator.Dedicated to Professor Dr. Wilhelm Fresenius on the occasion of his 80th birthday     

Three-dimensional atom probe study of the segregation behaviour of Ni91Pt9 alloy after sputtering

To investigate local ordering and segregation phenomenon in a Ni91Pt9-alloy after sputtering and annealing a 3D optical atom probe (OAP) has been used. The specimen tips have been prepared from polycrystalline samples. To sputter the samples a separate preparation chamber with a scannable Ar-sputter-gun is connected to the OAP vessel. When necessary, the sample can be electrically heated to induce segregation and cure the altered layer. After a heat treatment of a Ni91 at. %Pt 9 at.% specimen at 1100 K the surface of a (111)-oriented specimen is enriched in platinum by a factor of two in relation to the bulk. The phenomenon of short-range ordering has been investigated on the surface and in the subsurface volume. A 3D reconstruction of this annealed NiPt specimen shows regions with high concentration of platinum that gives an indication at short-range ordering. Uniform sputtering of the tip without a heat treatment induces a decisive depletion of Pt on the surface and the following subatomic layers. The atom-probe results of specimens in thermal equilibrium are in close agreement to further surface sensitive results obtained from Ion Scattering Spectroscopy (ISS) and Auger Electron Spectroscopy (AES).     

O′-β′复相Sialon陶瓷中相组成的控制

用Si₃N₄,SiO₂和Al₂O_?作原料,以Y₂O_?为添加剂,研究了O’-β’所在的四个相容性区中组成,于1400—1800℃之间,O’和β’的形成动力学。O’于1400℃开始生成,1600℃达到最大形成量。高于1600℃,O’减少乃至消失。研究发现,O’的这种不稳定性,并非自身热分解的结果。Al含量的增加,液相出现和β’的形成,才是导致O’-Sialon溶解而消失的原因。 此外,认为Si₃N₄-O’(x=0.3)-Y₂Si₂O₇-YAG相容性区,是在制备具有合理的O’-β’平衡相组成的复相陶瓷时,可供实际选用的组成区。     

Error analysis: a tool for selecting travel demand models

In developing travel demand models it is generally assumed that the base-year data used in developing the parameters, as well as the forecasted data to be used as independent variables for the design year, are of acceptable quality. The purpose of this paper is to present the application of error propagation theory in assesing the predictive quality of one type of travel demand forecasting model (multinomial logit models) and to demonstrate how error considerations can be used as a tool for identifying the optimal model. The general conclusions of this study are that: (1) it is indeed possible to quantify errors in dependent variables in logit models as a consequence of errors in independent variables; and (2) error consideration can be used as a tool for identifying the optimal model from a set of candidate models. Further research is recommended to develop better insights into the phenomenon of error propagation so that the consideration of errors can be a factor in decisions on model selection.     

Correlations between dynamical properties and features of potential energy surfaces for the light atom transfer reactions O+HCl→OH+Cl AND Cl+HCl→ClH+Cl

A three-dimensional quasiclassical trajectory study of the dynamics of the light atom transfer reaction O(³P) + HCl(ν=0)→ OH + Cl was carried out employing two LEPS potential energy surfaces (I and II). Attention was focused mainly on three-dynamical properties; the oscillatory behavior of partial cross sections as a function of collision energy; the rotational excitation of the products; and the influence of reagent rotation on reactivity. Distinct differences were found between surfaces I and II with respect to these properties. The examination of individual trajectories indicated that there is a significant difference in the nature of these surfaces. While surface I is governed by weak repulsive forces, surface II is governed by strong attractive forces which tend to direct the reactants toward a collinear geometry. The present results confirm conclusions reached from an earlier study of the reaction Cl+HCl→ClH+Cl concerning correlations between dynamical properties and features of potential energy surfaces. For surfaces of the type that we termed HREP, since they are of repulsive nature and they lead to highly rotationally excited products, no significant oscillations of partial cross sections are obtained and reagent rotation promotes the reaction. On the other hand, for surfaces of the type that we termed COLD (collinearly directing), since they tend to direct the reactants toward a collinear geometry and form rotationally “cold” products, significant oscillations of partial cross sections are obtained and reagent rotation causes a decline in reactivity.     

Naphthyl azomesogens with lateral chloro groups

A homologous series of azomesogens, 2″-[4-(4′-n-alkoxybenzoyloxy)-2-chlorophenylazo] naphthalenes, with lateral chloro groups was synthesised. All the homologues synthesized exhibit enantiotropic nematic mesophase. The mesomorphic properties of the present series are compared with other structurally related series to evaluate the effect of lateral chloro group and its position on mesomorphism This paper was presented at the 10th National Conference on Liquid Crystals held at Bangalore, India during 9–11 October 2003.