稀溶液中环型聚苯乙烯的激基缔合物荧光效应

采用乙酸乙酯为环型和线型聚苯乙烯的非良溶剂, 确定了Mark-Houwink方程分别为[η]_r=1.91×10~(-2)·M~(0.607)和[η]_l=4.06×10~(-2)·M~(0.572)。研究了环型和线型聚苯乙烯的激基缔合物的荧光效应。通过稀溶液中环型和线型高分子线团在柔顺性上存在着差异, 解释了二者之间在荧光效应方面的差异, 并根据实验结果,确定了(I_E/I_M)c→0～M关系式分别为(I_E/I_M)r,c→0=1.91+3.40×10~(-6)M和(I_E/I_M)l,c→0=2.15+3.05×10~(-6)M。     

电化学合成聚苯胺粉末电极的电化学行为研究

我们曾用慢速动电位扫描法研究化学合成聚苯胺粉末的电化学行为.本文对恒电位电解合成聚苯胺粉末进行了研究.用这种方法制备的粉末由于合成溶液中不含氧化剂因而纯度高.本文还报导了这种聚苯胺粉末电极的交流阻抗测量结果.交流阻抗法曾用于聚苯胺膜的电导和化学合成聚吡咯的电阻测定. 所用盐酸、氟硼酸、硅氟酸、苯胺均为分析纯;苯胺经常压蒸馏提纯;硫酸为超纯;磷酸为分析纯;高氯酸为优级纯.溶液皆用两次蒸馏水配制.     

偶氮胂-DBS用于光度法测定牛血清白蛋白

在室温下,于pH 2.5的Britton-Robinson缓冲溶液中及非离子表面活性剂OP存在下,牛血清白蛋白(BSA)与偶氮胂-DBS的复合物的最大吸收在514 nm波长处,但显色复合物与试剂空白吸光度之差在370 nm处最大,选择在370 nm处测定,反应迅速完成。非离子表面活性剂OP可提高反应灵敏度及复合物稳定性。乙醇可提高体系灵敏度。BSA的质量范围在0~60.0 mg.L-1范围内符合比耳定律,方法表观摩尔吸光率3ε70 nm=8.58×105L.mol-1.cm-1。方法用于测定血清样品中蛋白质的总量,5次测定值的RSD为0.60%,回收率为98.0%。     

Palladium-catalyzed tandem cyclization/Suzuki coupling of 1,6-enynes: reaction scope and mechanism

A palldium(0)-catalyzed tandem cyclization/Suzuki coupling reaction of various 1,6-enyne substrates was developed. This Pd-catalyzed enyne cyclization reaction represents a new process for the synthesis of stereodefined alpha-arylmethylene-gamma-butyrolactones, lactams, multifunctional tetrahydrofurans, pyrrolidines, and cyclopentanes. The mechanism of the reaction was studied by the employment of different enyne isomers and boronic acids; a pi-allyl palladium intermediate was suggested to explain the formation of the cyclic products. The stereochemistry of this reaction can be well explained by a chairlike transition state.     

6291型热变形温度和维卡软化温度测试仪的校准及故障排除

介绍6291型热变形温度和维卡软化温度测试仪的温度校准和位移校准方法，对测试仪的一些常见故障，例如电源故障，主温度传感器故障，电加热系统控制单元故障及测试站的温度偏差较大等进行了分析，并给出了排除故障的方法。     

Ammonia-treated activated carbon as support of Ru-Ba catalyst for ammonia synthesis

Ammonia-treated activated carbon has been studied as a support of Ru-Ba catalyst for ammonia synthesis. It is shown that the introduction of nitrogen leads to a decrease of ammonia synthesis activity for the catalysts with a low Ba/Ru molar ratio, while no significant changes are obtained for the catalysts with a high Ba/Ru molar ratio, confirming that electronegative impurities suppress the activity in ammonia synthesis and consume part of the promoters. This revised version was published online in June 2006 with corrections to the Cover Date.     

硝酸铽与1，1，1′，1′-四(吡啶-2-羧酸酯基)联三甲基丙烷配合物的合成、表征及荧光性质

Solid complex of terbium nitrate with a novel tetrapodal ligand, 1,1,1′,1′-tetra(2-pyridinecarboxylester)-di(trimethylpropane) was prepared. This new complex with the formula of [TbL(NO₃)](NO₃)₂·2H₂O was charact-erized by elemental analysis, molar conductivity, IR spectroscopy and thermal analysis. At the same time, the luminescent property of the complex was also studied.     

Interface characteristics in diffusion bonding of Fe3Al with Cr18-Ni8 stainless steel

Fe3Al and Cr18-Ni8 stainless steel were diffusion-bonded in vacuum and a Fe3Al/Cr18-Ni8 interface with reaction layer was formed. Microstructure in the reaction layer at Fe3Al/Cr18-Ni8 interface was analyzed by means of scanning electron microscope (SEM) and electron probe micro-analyzer (EPMA). The growth of reaction layer with heating temperature (T) and holding time (t) was researched. The results indicate that FeAl, Fe3Al, Ni3Al, and alpha-Fe (Al) solid solution are formed in the reaction layer. These phases are favorable to promote the element diffusion and to accelerate the formation of the reaction layer at Fe3Al/Cr18-Ni8 interface. The growth of reaction layer obeys the parabolic law and its thickness (X) is expressed by X2 = 7.5 x 10(-4)exp(-83.59/RT)(t - t0).     

Baker''''s yeast mediated reduction of substituted acenaphthenequinones: Regio-and enantioselective preparation of mono-hydroxyacenaphthenones

Baker's yeast mediated reduction of acenaphthenequinone within 4-10 h afforded mono-hydroxyacenaphthenone mainly with low enantioselectivity, the substrate and mono-hydroxyacenaphthenone product almost converted to dihydroxyacenaphthene after 48 h. By control of the reaction time and in the presence of DMF as co-solvent, the reduction of 6-substituted acenaphthenequinones under vigorous agitation afforded the corresponding 2-hydroxyacenaphthenones in 24-84% yields with 10-93% ee.     

Thermal characterization and thermal degradation of poly(norbornene-2,3-dicarboxylic acid dialkyl esters) synthesized by vinyl addition polymerization

The thermal properties and degradation behaviors of poly(norbornene-2,3-dicarboxylic acid dialkyl esters) (PNB-dialkyl esters) (alkyl = Me (PNB-Me), Et (PNB-Et), Pr (PNB-Pr), and Bu (PNB-Bu)) were investigated by thermogravimetric analysis (TGA) in dynamic conditions and by infrared (IR) spectroscopy. The PNB-dialkyl esters show good thermal stability up to 350 °C, and the thermal stability decreases in the order Me > Et > Pr > Bu with the increase in size of side chain. The effect of side-chain size on the thermal degradation behaviors of PNB-dialkyl esters is evidenced by one-step thermal degradation profile for PNB-Me while two-step thermal degradation profile for PNB-Et, PNB-Pr, and PNB-Bu. Transformation is deduced to undergo β-hydrogen elimination and formation of anhydride group in the first stage of thermal degradation reaction according to TGA and IR results for PNB-Et, PNB-Pr, and PNB-Bu. The apparent activation energy and thermal degradation model of PNB-dialkyl esters are estimated by means of Ozawa-Flynn-wall method and Phadnis-Deshpande method, respectively.