熔盐包层设计与氚增殖比的计算

通过对聚变堆设计包层进行先后的一维、三维氚增殖比计算与分析,确定合适的模块材料、明确的模块划分以及相应的模块厚度,最终找到了合适的满足氚自持(TBR=1.3162)的熔盐设计包层。     

THE ANNEALING FEATURES OF Ta/Si MULTILAYER FILMS

The Ta/Si multilayers on (100) Si substrate have been studied over the annealing temper-ature range from 500 to 900℃ by X-ray diffraction and cross-section transmission electron microscopy. The periodicity of the multilayers becomes worse with increasing annealing tem-perature and disappears at 750℃. At 600℃, two kinds of modulation wavelength coexist because the size of several TaSi₂ grains is larger than the contracted original modulation wavelength. The films are contracted after annealing. The largest contraction, at least 40nm decreasing in thickness, occurs at 600℃. When the annealing temperature is lower than 600℃, h-TaSi₂ grains grow randomly and the growth is not affected by the substrate. At temperatures higher than 750℃, h-TaSi₂ grows preferentially in [001] direction parallel to [100] axis of Si substrate. The appearance of texture depends on whether the atomic diffusion is short range or long range at the corresponding annealing temperature.     

BEPCⅡ高频发射机和环流器的调整和测试

北京正负电子对撞机升级改造工程(BEPCⅡ)将采用的频率500MHz、输出功率250kW的高频发射机和环流器已安装、调整、测试和验收完毕,这是国内建立的第一套500MHz/250kW发射机系统.本文将详细介绍机器的调测试的原理和各项测量内容及结果, 并比较设计指标和要求,来阐述此发射机的实际技术指标和测试性能.     

Gd3+对Ca0.8Zn0.2TiO3:Pr3+红色发光材料的敏化作用

采用溶胶-凝胶法在较低温度下合成了红色发光材料Ca0.8Zn0.2TiO3:0.002Pr3 ,xGd3 .金属离子预先溶解含有柠檬酸的乙二醇溶液中.XRD表明在800℃灼烧2h形成了钛酸盐的晶体.荧光检测结果表明所合成样品的特征激发峰为330nm、特征发射峰为614nm,分别对应于O(2p)→Ti(3d)带间跃迁和Pr3 的1D2→3H4的特征发射.样品的发光强度随x的不同而不同,发光强度增强了29%-69%.当x＝0.0005时,即nPr3 :nGd3 ＝4∶1时样品的红色发光强度最强,发光强度增强了69%.     

高绝缘体中的极化子

应用特殊的锁相放大器,在-20℃至180℃范围内测量了三种高绝缘体的表面和体电导,观察到传导极化子的跳跃导电和能带导电;LiNbO₃,中两种导电态的转变温度为38℃,传导极化子可以被陷阱俘获而成为束缚极化子。后者不是载流子,但在外电场作用下能产生位移运动而提供超低频电极化效应。LiNbO₃和LiTaO₃的表面存在大量铁电屏蔽电荷,但它们的表面传导电流却不比玻璃的大,而是提供了特别大的位移电流。显得这些屏蔽电荷是处于束缚极化子态,在45,75 关键词：     

两个双能级原子与辐射场的喇曼相互作用

研究了两个双能级原子与单模辐射腔场的喇曼相互作用。分别计算了两个原子与光场之间具有不同耦合常数和两个原子虽与光场具有相同耦合常数但同时考虑了原子间偶极-偶极相互作用两种情形下的辐射谱。分析了两个原子与辐射场之间耦合常数的相对大小和两原子间偶极作用的计入对辐射谱的影响。 关键词：     

Particle-number conserving analysis for the 2-quasiparticle and high-K multi-quasiparticle states in doubly-odd 174,176Lu

Two-quasiparticle bands and low-lying excited high-K four-, six-, and eight-quasiparticle bands in the doubly-odd ^{174, 176}Lu are analyzed by using the cranked shell model (CSM) with the pairing correlations treated by a particle-number conserving (PNC) method, in which the blocking effects are taken into account exactly. The proton and neutron Nilsson level schemes for ^{174, 176}Lu are taken from the adjacent odd-A Lu and Hf isotopes, which are adopted to reproduce the experimental bandhead energies of the one-quasiproton and one-quasineutron bands of these odd-A Lu and Hf nuclei, respectively. Once the quasiparticle configurations are determined, the experimental bandhead energies and the moments of inertia of these two- and multi-quasiparticle bands are well reproduced by PNC-CSM calculations. The Coriolis mixing of the low-K (K=|Ω₁-Ω₂|) two-quasiparticle band of the Gallagher-Moszkowski doublet with one nucleon in the Ω = 1/2 orbital is analyzed.     

远程控制在大功率固体激光加工系统中的应用

针对目前大功率固体激光加工系统的特点,结合相关产品使用的网络构架,研制开发了一套基于Internet的远程监控系统。它是一种将网络技术与系统监控相结合,在异地通过Internet实时监控系统的运行状态,并为系统的故障诊断提供依据的技术。该系统具有高效性、准确性和实时性等特点。在设计方面采用了先进的软件构架,可以实时监控激光加工系统的操作情况和参数状态;查询激光加工系统的当前数据和历史数据,并对开放权限的数据进行修改;通过和用户在线沟通完成疑难问题的解答。     

射频离子源束流特性分析

介绍了为HL-2A 装置设计的引出束功率为1MW 的射频离子源研制情况。目前,在测试平台上,该离子源已经成功引出了束能量和束电流分别为35keV 和12.4A、束质子比为79%、脉宽为100ms 的氢离子束,达到了其设计束功率的44%。用红外热成像的方法测量了离子束能量密度分布。结果表明,在距离引出系统地电极 1.3m 处,束密度分布遵循高斯分布。引出束的最佳导流系数为1.689×10^–6A•V^-3/2 左右,随射频功率改变有较小的变化。根据这些实验结果,采取了相关改进措施来改善离子源的引出束性能。