Interparticle interactions in agglomerates of alpha-Fe2O3 nanoparticles: influence of grinding

We have chemically prepared a sample of antiferromagnetic alpha-Fe2O3 nanoparticles by a gel-sol technique. M?ssbauer spectra of the as-prepared sample showed that superparamagnetic relaxation was suppressed due to strong magnetic interparticle interactions even at room temperature. However, subsequent grinding of the sample by hand in a mortar for some minutes resulted in fast superparamagnetic relaxation of some of the particles. The effect was even more dramatic if the alpha-Fe2O3 powder was ground for a longer time or together with nonmagnetic eta-Al2O3 nanoparticles. Similar effects were found after low-energy ball milling. Thus it is found that the agglomeration of the nanoparticles during preparation under wet conditions results in strong magnetic interparticle interaction, but a relatively gentle mechanical treatment is sufficient to break up the agglomerates, resulting in much weaker interactions. We show that these effects can also be seen when a soil sample containing magnetic nanoparticles is ground.     

多壁碳纳米管负载铂的甲苯加氢脱芳催化剂

以多壁碳纳米管(CNTs)为载体制备了负载型Pt催化剂Pt/CNTs并将其用于催化甲苯加氢脱芳(HDA)反应.结果表明,在1.0%Pt/CNTs催化剂上,在0.4MPa,373K,PhCH3/H2摩尔比=6/94和GHSV=120L/(h.g)的反应条件下,甲苯转化率可达100%,比反应速率为0.0523mmol/(s.m2),分别是γ-Al2O3和AC负载各自最佳Pt负载量催化剂1.4%Pt/γ-Al2O3和2.4%Pt/AC上相应值的1.17和1.18倍.甲苯加氢产物全部为甲基环己烷,其他可能的加氢产物均在气相色谱检测限以下.催化剂的表征研究揭示,用CNTs代替γ-Al2O3或AC作为载体并不会引起所负载Pt催化剂上甲苯HDA反应的表观活化能发生明显变化.与γ-Al2O3或AC负载的相应催化剂相比,一方面,CNTs负载的Pt催化剂易于在较低温度下还原活化,并且其工作态催化剂表面催化活性Pt物种(Pt0)所占表面Pt摩尔分率有所提高;另一方面,CNTs负载的Pt催化剂对H2具有较高的吸附/活化和储存能力.这些促进效应对催化剂HDA活性的提高都有重要贡献.     

CdSe/ZnS-labeled carboxymethyl chitosan as a bioprobe for live cell imaging

A simple and convenient method for the construction of CdSe/ZnS-labeled polysaccharides as bioprobes were developed, which are highly biocompatible and photostable, and have been proven to be suitable for live cell imaging.     

分数导数结合傅里叶最小二乘拟合处理含噪音的重迭信号

提出了一种含噪音重迭信号的综合处理方法 :先用傅里叶最小二乘法拟合噪音数据 ,然后对拟合后的信号求 2 .5次导数 ,在对模拟数据研究的基础上 ,讨论了求导后峰位漂移及其影响因素 ,给出了一个用于矫正峰位值的经验公式。用该方法对模拟和实际的紫外含噪音重迭信号进行处理 ,结果良好     

锐钛矿型纳米TiO2介孔粉体表面织构的研究

以硫酸钛和尿素为原料,聚乙二醇-1000为空间构造剂,104℃下经尿素水解均匀沉淀法研制颗粒分散均匀、粒径可控的高热稳定性锐钛矿型纳米TiO2介孔粉体,并对其晶相、颗粒大小、比表面积、形貌和孔道结构进行了表征.结果表明,未经任何热处理的TiO2粉体即为锐钛型晶相,颗粒为均匀分散的类球型颗粒,且颗粒间形成直通型的介孔孔道,其孔径在10～30nm之间.控制焙烧温度可以达到控制颗粒大小及形貌的目的,经850℃焙烧5h的样品仍保持锐钛矿型晶相,未出现向金红石型晶相转变的迹象.     

用钐和四氯化钛体系一锅法合成咪唑烷衍生物

在四氢呋喃溶液中,用Sm/TiCl4体系还原亚胺合成了咪唑烷衍生物.发现当没有促进剂1,2-二溴乙烷时,咪唑烷衍生物的产率小于20%,加入1,2-二溴乙烷后,产率大大提高.产物的结构通过IR,1HNMR和MS光谱确证.根据实验结果提出了一个可能的反应机理.     

固相萃取-气相色谱-质谱分析肉样中盐酸克伦特罗的残留量

建立了固相萃取 气相色谱 质谱联机分析肉样中盐酸克伦特罗残留量的方法。对盐酸克伦特罗在C1 8和离子交换固相萃取柱上的保留行为进行了研究 ,发现不同浓度盐酸克伦特罗的固相萃取回收率在 75 %～ 95 %之间 ;肉样中的加标回收率在 70 %～ 83 % ;相对标准偏差在 4 .95 %～ 1 3 .4 % ;最低检出限为 1 μg kg。盐酸克伦特罗的硅烷化产物 ,采用选择离子的模式进行检测 ( 86、2 4 3、2 62、2 77) ,衍生物的峰面积与样品浓度在0 .0 0 2 5 2～ 2 .0 2mg L范围内呈良好的线性关系 ,线性回归系数大于 0 .9999。     

ABS blends with phenoxy: morphology,thermal, mechanical and rheological properties

Blends of ABS (acrylonitrile–butadiene–styrene) with phenoxy(poly(hydroxyether bisphenol A)) were prepared using a Branender single screw extruder. Scanning and transmission electron micrographs (SEM, TEM) showed a typical two-phase morphology; particle-in-matrix (90/10) (ABS/phenoxy by weight), 70/30, 10/90), island/sea (30/70) and co-continuous (50/50) morphologies. The glass transition temperature (T_g) of SAN was almost unchanged in the blends, while the T_g of phenoxy increased by about 5 °C in the blends. The synergistic effect of tensile modulus and strength was noted in ABS-rich blends, where a drastic drop of ductility was seen, and the results were interpreted in terms of rubber particle migration form SAN to phenoxy phase, which was visualized by TEM. Melt viscosity showed yield in ABS-rich blends, and generally followed the log additivity.     

Single Atom Alloy Preparation and Applications in Heterogeneous Catalysis

There have been remarkable progresses in manipulating heterogeneous catalysts' nanostructures in the past decade. The concept of single atom alloy (SAA) was firstly proposed in 2012 when researchers successfully stabilized single Pd atoms on the Cu(111) surface. However, earlier work in 2009, which focused on replacing one Au atom with a Pd atom in thiolate protected Au₂₅ nanoclusters, could also be considered as the pioneer work of single atom alloy. Both kinds of single atom alloys exhibited the potential of maximum utilization of scarce elements and attractive catalytic performances. The well‐defined structures of SAA catalysts make accurate modeling possible, which further realizes the rational design of single atom alloy catalysts. In this review, we summarize the research trajectory of single atom alloys as well as recent achievements in this field. We also introduce several commonly adopted characterization methods for SAA catalysts such as scanning tunneling microscopy (STM), temperature programmed reaction (TPR), extended X‐ray absorption fine structure (EXAFS) spectra, matrix assisted laser desorption/ionization mass spectrum (MALDI‐MS) and differential pulse voltammetry (DPV). Through discussing recent progresses in SAA catalysts, we propose that future researches in this filed should be focused on exploring new kinds of metal nanocrystals and controlling the nanostructure of SAA even more precisely.     

2-芳基硫杂脯氨酸结构特征的研究

对12种2-芳基硫杂脯氨酸进行了红外光谱和核磁共振谱测定,对其中两个化合物作了质谱测定。结果表明,这类化合物固态时主要以两性离子形式存在;有较强的分子离子峰,是一类较稳定的化合物。它们还存在一对非对映异构体,芳环上的取代基对芳环电子云密度的影响较大,而对四氢噻唑环的影响较小。