Optimization on fabrication and performance of A-site-deficient La0.58Sr0.4Co0.2Fe0.8O3-δ cathode for SOFC

A-site-deficient perovskite cathode material La_0.58Sr_0.4Co_0.2Fe_0.8O_3 − δ (L58SCF) is coated on the yttria-stabilized zirconia electrolyte by screen-printing technique. Several key fabrication parameters including selection of additives (binder and pore former), effect of coating thickness, sintering temperature and time on the microstructure, and electrochemical performance of cathode are investigated by scanning electron microscopy and electrochemical impedance spectroscopy. We study the microstructure and the electrochemical property of the cathode with different kinds of additives. Results show that the cathode possesses fine microstructure, enough porosity, and ideal electrochemical property when polyvinyl butyral serves as both binder and pore former in the cathode. The cathode with three screen-printing coats (thickness 28 ± 7 μm, weight 6.07 ± 0.72 mg cm⁻²) sintering at 1,000 °C for 2 h shows lower polarization resistance of 0.183 Ω cm² at 800 °C. Based on the optimized parameters, the polarization resistances of the L58SCF–Ce_0.8Gd_0.2O_{1.9 – δ} composite cathode display the R _p values of 0.067 Ω cm² at 800 °C, 0.106 Ω cm² at 750 °C, 0.225 Ω cm² at 700 °C, and 0.550 Ω cm² at 650 °C.     

超高效液相色谱法测定鱼体组织中地克珠利残留量

建立了鱼体血浆、肌肉、皮肤、肝脏、肾脏和鳃组织中地克珠利残留量测定的超高效液相色谱法(UPLC-TUV)。鱼体血浆、肝脏和肾脏组织采用乙酸乙酯提取,50 mmol/L KH2PO4溶液去除组织中的蛋白,正己烷去脂;鱼体肌肉、皮肤和鳃组织采用乙腈提取,用乙酸乙酯从40 g/L NaCl溶液中进行反萃取,正己烷去除脂肪;以乙腈-0.3%乙酸水溶液为流动相,以ACQUITY UPLC BEH C18为分离柱,柱温为30℃,紫外检测波长为280 nm。地克珠利质量浓度在0.05~10.0 mg/L范围内呈线性相关,相关指数r2=0.999。平均回收率为70.3%~93.5%,相对标准偏差为0.81%~8.6%,地克珠利在鱼体肌肉、皮肤、脂肪和腮组织组织中的检出限为25μg/kg,定量限为50μg/kg;地克珠利在鱼体血浆、肝脏和肾脏样品中组织中的检出限和定量限分别为75μg/kg和100μg/kg。方法适用于鱼体各组织中地克珠利残留量的测定。     

水热法合成纳米氧化铜及其对盐酸异丙嗪的电化学传感研究

采用简单的水热法一步反应,制备了尺径均一的纳米氧化铜颗粒并构建了纳米氧化铜修饰电极。结果表明,该修饰电极对盐酸异丙嗪的电化学氧化有显著的电催化作用,研究了各种因素包括pH值、修饰剂用量、扫速以及共存离子等对电极响应的影响,优化了各项测试条件。该方法测定盐酸异丙嗪的线性范围为0.5~150μmol/L,检出限为1.3×10-7 mol/L,同时成功测定了药物中盐酸异丙嗪的含量。     

Monitoring the formation of TTF dimers by Na+ complexation

The formation of the two dimeric species [(TTF)2]+* and (TTF+*)2 can be monitored by complexation of Na+ on a calix[4]arene-TTF assembly.     

A new family of mono- and dicarboxylic ruthenium complexes [Ru(DIP)2(L2)]2+ (DIP = 4,7-diphenyl-1,10-phenanthroline): synthesis, solution behavior, and X-ray molecular structure of trans-[Ru(DIP)2(MeOH)2][OTf]2

A new family of ruthenium complexes of general formula [Ru(DIP)2(L2)]2+, where DIP = 4,7-diphenyl-1,10-phenanthroline, a bidentate ligand with an extended aromatic system, was prepared and fully characterized. When L is a monodentate ligand, the following complexes were obtained: L = CF3SO3(-1) (2), CH3CN (3), and MeOH (4). When L2 is a bidentate ligand, the compounds [Ru(DIP)2(Hcmbpy)][Cl]2 (5) and [Ru(DIP)2(H2dcbpy)][Cl]2 (6) were prepared (Hcmbpy = 4-carboxy-4'-methyl-2,2-bipyridine, H2dcbpy = 4,4'-dicarboxy-2,2'-bipyridine). Complex [Ru(DIP)2(MeOH)2][OTf]2 (4) displayed a trans configuration of the DIP ligands, which is rare for octahedral complexes featuring DIP bidentate ligands. DFT calculations carried out on 4 showed that the cis isomer is more stable by 12.2 kcal/mol relative to the trans species. The solution behaviors of monocarboxylic complex [Ru(DIP)2(Hcmbpy)][Cl]2 (5) and dicarboxylic complex [Ru(DIP)2(H2dcbpy)][Cl]2 (6) were investigated by 1H NMR spectroscopy. VT-NMR, concentration dependence, and reaction with NaOD allowed us to suggest that aggregation of the cationic species in solution, especially for 6, originates mainly from hydrogen bonding interactions.     

Improved method for isotopic and quantitative analysis of dissolved inorganic carbon in natural water samples

We present here an improved and reliable method for measuring the concentration of dissolved inorganic carbon (DIC) and its isotope composition (delta(13)C(DIC)) in natural water samples. Our apparatus, a gas chromatograph coupled to an isotope ratio mass spectrometer (GCIRMS), runs in a quasi-automated mode and is able to analyze about 50 water samples per day. The whole procedure (sample preparation, CO(2(g))-CO(2(aq)) equilibration time and GCIRMS analysis) requires 2 days. It consists of injecting an aliquot of water into a H(3)PO(4)-loaded and He-flushed 12 mL glass tube. The H(3)PO(4) reacts with the water and converts the DIC into aqueous and gaseous CO(2). After a CO(2(g))-CO(2(aq)) equilibration time of between 15 and 24 h, a portion of the headspace gas (mainly CO(2)+He) is introduced into the GCIRMS, to measure the carbon isotope ratio of the released CO(2(g)), from which the delta(13)C(DIC) is determined via a calibration procedure. For standard solutions with DIC concentrations ranging from 1 to 25 mmol . L(-1) and solution volume of 1 mL (high DIC concentration samples) or 5 mL (low DIC concentration samples), delta(13)C(DIC) values are determined with a precision (1sigma) better than 0.1 per thousand. Compared with previously published headspace equilibration methods, the major improvement presented here is the development of a calibration procedure which takes the carbon isotope fractionation associated with the CO(2(g))-CO(2(aq)) partition into account: the set of standard solutions and samples has to be prepared and analyzed with the same 'gas/liquid' and 'H(3)PO(4)/water' volume ratios. A set of natural water samples (lake, river and hydrothermal springs) was analyzed to demonstrate the utility of this new method.     

New Reactions of N‐tert‐Butylimines; Formation of N‐Heterocycles by Methyl Radical Elimination on Flash Vacuum Thermolysis of N‐Benzylidene‐ and N‐(2‐Pyridylmethylidene)‐tert‐butylamines

Thermal reactions of N‐benzylidene‐ and N‐(2‐pyridylmethylidene)‐tert‐butylamines ( 5 and 13 ) under FVT conditions have been investigated. Unexpectedly, at 800 °C, compound 5 yields 1,2‐dimethylindole and 3‐methylisoquinoline. In the reaction of 13 at 800 °C, 3‐methylimidazo[1,5‐a]pyridine was obtained as the major product. Mechanisms of these reactions have been proposed on the basis of DFT calculations. Furthermore, UV‐photoelectron spectroscopy combined with FVT has been applied for direct monitoring and characterization of the thermolysis products in situ.     

Coumarinylmethyl Caging Groups with Redshifted Absorption

The small and synthetically easily accessible coumarinylmethyl backbone has been modified to generate a family of photolabile protecting groups with redshifted absorption. We relied on introducing electron‐donating groups in the 7 position and electron‐withdrawing groups in the 2‐, and 2‐ and 3 positions. In particular, we showed that the diethylamino‐thiocoumarylmethyl and the diethylamino‐coumarylidenemalononitrilemethyl are relevant for uncaging with cyan light. They both exhibit a significant action cross section for uncaging in the 470–500 nm wavelength range and a low light absorption between 350 and 400 nm. These attractive features are favorable to perform chromatic orthogonal photoactivation with UV and blue‐cyan light sources, respectively.     

Comparison of direct mass spectrometry methods for the on‐line analysis of volatile compounds in foods

For the on‐line monitoring of flavour compound release, atmospheric pressure chemical ionization (APCI) and proton transfer reaction (PTR) combined to mass spectrometry (MS) are the most often used ionization technologies. APCI‐MS was questioned for the quantification of volatiles in complex mixtures, but direct comparisons of APCI and PTR techniques applied on the same samples remain scarce. The aim of this work was to compare the potentialities of both techniques for the study of in vitro and in vivo flavour release. Aroma release from flavoured aqueous solutions (in vitro measurements in Teflon bags and glass vials) or flavoured candies (in vivo measurements on six panellists) was studied using APCI‐ and PTR‐MS. Very similar results were obtained with both techniques. Their sensitivities, expressed as limit of detection of 2,5‐dimethylpyrazine, were found equivalent at 12 ng/l air. Analyses of Teflon bag headspace revealed a poor repeatability and important ionization competitions with both APCI‐ and PTR‐MS, particularly between an ester and a secondary alcohol. These phenomena were attributed to dependency on moisture content, gas/liquid volume ratio, proton affinities and product ion distribution, together with inherent drawbacks of Teflon bags (adsorption, condensation of water and polar molecules). Concerning the analyses of vial headspace and in vivo analyses, similar results were obtained with both techniques, revealing no competition phenomena. This study highlighted the equivalent performances of APCI‐MS and PTR‐MS for in vitro and in vivo flavour release investigations and provided useful data on the problematic use of sample bags for headspace analyses. Copyright © 2013 John Wiley & Sons, Ltd.     

Calorimetric Estimation Employing the Unscented Kalman Filter for a Batch Emulsion Polymerization Reactor

Reaction calorimetry is a very useful tool to monitor exothermic polymerization reactions as it is based on the estimation of the heat generated by the reaction. The objective of this work is to analyze the performance of an unscented Kalman filter (UKF) for online monitoring of batch vinyl acetate emulsion polymerization reactions. Reactions are performed in isoperibolic and isothermal conditions. The UKF is compared to an extended Kalman filter that has a very poor performance. The results show that the UKF is able to provide good estimates for the conversion, for the reactor and jacket temperatures, for the overall heat transfer coefficient between the reaction medium and the jacket, and for the heat loss from the jacket to the surroundings.