Layer structure estimation of three‐dimensional crystal and two‐dimensional molecular film for fluorinated comb copolymers

Comb copolymers containing both hydrogenated and fluorinated side‐chains were prepared by copolymerization using acrylic or methacrylic monomers in several ratios. The crystal structures of these copolymers and layer structures of their organized molecular films were investigated by wide‐angle X‐ray diffraction (WAXD), small‐angle X‐ray scattering (SAXS), and out‐of plane X‐ray diffraction. Further, to selectively estimate the regularity of shorter fluorocarbon side‐chains, organized molecular films of copolymers were investigated by polarized near‐edge X‐ray adsorption fine structure (NEXAFS) spectroscopy. From the results of these measurements, it was inferred that these copolymers formed highly ordered layer structures, and a long spacing was predominantly determined by the arrangement of hydrogenated side‐chains, except in copolymers having extremely high fluorocarbon contents. In the case of the organized molecular films, the fluorinated side‐chains of methacrylate copolymers cannot form a highly ordered arrangement, whereas those of acrylate copolymers were oriented on monolayers. However, in both cases, the hydrogenated side‐chains predominantly formed layer structures in the organized films, and the fluorinated side‐chains did not contribute to the formation of the layer structures. © 2008 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 46: 534–546, 2008     

Classification Performance of a Low Pressure Differential Mobility Analyzer for Nanometer-sized Particles

Size distribution measurements and classification tests by a low pressure differential mobility analyzer (LPDMA) for nanometer-sized silver particles and cesium iodide particles under low pressure conditions (123–300 Torr) were performed using a transmission electron microscope (TEM) and the tandem DMA technique. When the ratio of the sheath gas flow rate and the aerosol gas flow rate was set at 5 : 1, the targeted sizes calculated from the classification voltage applied to the LPDMA at 160 Torr are found to be in good correlation with the count mean Feret diameter obtained from the TEM observation of the particles collected after a classification ranging from 6 to 25 nm, although the targeted sizes set by the LPDMA were approximately 15% greater than the count mean Feret diameter measured by the TEM after classification. The geometric standard deviations of DMA-classified particles measured by TEM and those obtained from the tandem DMA method ranged from 1.08 to 1.17 and from 1.05 to 1.13, respectively. They were slightly greater than the ideal geometric standard deviations (1.05) of the particles classified with the LPDMA, which was calculated by neglecting the broadening effects due to Brownian diffusion. We experimentally demonstrated the validity of our LPDMA system for size measurements and classification of the nanometer-sized particles under low pressure conditions.     

TritonX-100 selective chemosensor based on β-cyclodextrin modified by anthracene derivative

β-Cyclodextrin (CD) modified by 2-(9-anthracenecarboxamido)phenyl group (Ant-CD) was synthesized and their complexation behavior was investigated by UV and fluorescence spectroscopy. Fluorescence intensity of Ant-CD was dramatically enhanced ca. 10-fold by the addition of TritonX-100 (TX-100) in water below the critical micelle concentration. Ant-CD also showed ca. 4-fold fluorescence increasing in the addition of analogous materials, n-octylbenzenesulfonate in water. These results indicate that Ant-CD can act as a highly sensitive and selective chemosensor for TX-100. Ant-CD and TX-100 formed a pseudorotaxane supramolecular complex. This result was supported by ¹H-¹H NOESY NMR measurement.     

Characterization of Ultra‐Thin Temperature‐Responsive Polymer Layer and Its Polymer Thickness Dependency on Cell Attachment/Detachment Properties

Ultra thin poly(N‐isopropylacrylamide) (PIPAAm) modified glass coverslips (PIAPAm‐CS) using electron beam irradiation exhibited a clear relationship between the polymer thickness and thermal cell adhesion/detachment behavior. The polymer thickness dependency and the characteristic of ultra thin PIPAAm layer, has been illustrated in terms of the molecular motion of the modified PIPAAm chains. PIPAAm‐CSs surfaces with various area‐polymer densities and thicknesses were characterized by AFM and protein adsorption assay. The newly obtained results gave a further insight into the illustration. Finally, the future application of intelligent surfaces was discussed for fabricating tissue and organ.

     

Coexistence properties of phase separation and CuPt-ordering in InGaAsP grown on GaAs substrates by organometallic vapor phase epitaxy

CuPt-ordering and phase separation were directly investigated in In_1-xGa_xAs_yP_1-y with a low arsenic content grown by organometallic vapor phase epitaxy on GaAs substrates. CuPt-ordering and phase separation in samples grown at the substrate temperatures of 630 and 690 °C were characterized by transmission electron diffraction and transmission electron microscopy. Although the immiscibility of InGaAsP was enhanced at the lower substrate temperature, the sample grown at 630 °C showed less phase separation than the 690 °C-grown sample. The degree of CuPt-ordering was significantly enhanced in the sample grown at 630 °C. The results demonstrated that the CuPt-ordering originating from surface reconstruction of P(2×4) suppressed the phase separation even in the miscibility gap. The detailed characterization of the phase separation clearly revealed a vertical composition modulation (VCM) in InGaAsP for the first time. The mechanism of the VCM formation is discussed based on the modulated-strain field on the surface.     

Distributivity and stationary reflections

In this paper, we present some relations between generalized distributivity of quotient algebras and Mahlo operations, and show that the distributivity implies some variants of stationary relections.

     

Biaxial nematic phase of crank-like bis(β-diketonato)copper(II) complexes established by X-ray diffraction and Z-value calculations

We have synthesized a series of six novel bis(β-diketonate)copper (II) complexes, 1a, 1b, 2a, 2b, 3a, and 3b, substituted by two bulky substituents in the short molecular axis direction to investigate their mesomorphism. The m,p,m'-trimethoxylphenyl-substituted derivatives, 2a and 2b, and the m,p-dimethoxylphenyl-substituted derivatives, 3a and 3b, did not show mesomorphism, whereas each of the p-methoxyphenyl-substituted derivatives 1a and 1b only showed a nematic phase, which was revealed from polarizing microscopic observations. We established from X-ray diffraction and Z-value calculations that each of the crank-like derivatives 1a and 1b forms a rectangular parallelepiped dimer and shows a biaxial nematic phase.     

Stereoselective synthesis of (Z)-alkene-containing proline dipeptide mimetics

In peptides and proteins, the peptide bond between an amino acid and proline exists as an equilibrium mixture of the cis-imide and trans-imide due to the low energy barrier in their interconversion. This feature greatly influences the structure and function of the proline-containing peptides and proteins. Therefore, restricting the amide bond with an (E)- or (Z)-alkene should provide a promising method for elucidating the structure-activity relationships of the peptide and the proteins. In this report, the regio- and stereoselective synthesis of cis-alanylproline (Ala-Pro) type (Z)-alkene dipeptide mimetic is described. The key steps of this synthesis are to introduce a C3 unit onto a gamma-phosphoryloxy-alpha,beta-unsaturated-delta-lactam with an organocopper-mediated anti-S(N)2' reaction and subsequently construct a five-membered proline-like cyclic structure with an intramolecular Suzuki coupling reaction. Hydrolysis of the amide bond in the resulting bicyclic lactam yields the desired cis-Ala-Pro type (Z)-alkene dipeptide isostere. The presented synthetic methodology should be applicable to the general syntheses of other cis-aminoacylproline type (Z)-alkene dipeptide mimetics.     

Electrochemical analysis of single nucleotide polymorphisms of p53 gene

Single nucleotide polymorphisms (SNPs) of cancer repression gene p53 were analyzed electrochemically with ferrocenyl naphthalene diimide (1) as a hybridization indicator. The SNPs studied were the transition to A from G in the codon for amino acid at positions 175, 248 or 273 and the transversion to C from G in the codon for the amino acid at position 72. Thus, 20-meric oligonucleotides carrying the SNP site were used both as a sample and a probe with the latter immobilized on an electrode. Even one base difference on the p53 gene resulted in a significant difference in the current response of 1 and the magnitude of the response correlated with the amount of the DNA hybrid on the electrode. Moreover, when PCR products of exon 4, on which the P72/R72 SNP resides, of the p53 gene were analyzed by this method, the heterozygote and homozygotes were discriminated with modest precision.     

Ellipticity dependence of high-order harmonic generation from aligned molecules

We report ellipticity dependence of high-order harmonic generation (HHG) from aligned N2, O2, and CO2 molecules. Experimentally, we find that the ellipticity dependence is sensitive to molecular alignment and to the shape and symmetry of the valence orbitals. It is also found that the destructive interference in the recombination process affects the ellipticity dependence. Theoretically, we extend the original Lewenstein model to a more generalized model, which can be applicable to HHG from molecules, by introducing an electron acceleration parameter xi(theta) and by combining the molecular orbital method. The present observations are successfully explained by our model.