第三族金属氧化物离子对二氧化碳转化的红外光谱研究

本文利用红外光解离光谱研究了第三族金属氧化物离子对二氧化碳分子的转化机制. 研究表明,对于[ScO(CO₂)_n]⁺体系,在n≤4时,形成了溶剂化结构;在n=5时,形成了碳酸盐结构,实现了二氧化碳的转化. 对于[YO(CO₂)_n]⁺体系,需要4个二氧化碳分子就可以实现二氧化碳的转化. 而在[YO(CO₂)_n]⁺体系中,只发现了溶剂化结构,没有观察到碳酸盐结构. 理论计算表明,[YO(CO₂)_n]⁺体系拥有最小的溶剂化结构向碳酸盐结构转化能垒,[LaO(CO₂)_n]⁺体系拥有最大的溶剂化结构向碳酸盐结构转化能垒. 本文从分子水平揭示了不同金属氧化物离子对二氧化碳分子转化的影响规律.     

AlmNin (m+n=2–4)二元合金团簇结构和稳定性的密度泛函研究

在密度泛函理论的B3PW91水平上, 优化计算了AlmNin (m+n=2–4)团簇的几何结构、团簇基态的结合能、最高占据轨道与最低空轨道之间的能级间隙和可能的分离能. 结果表明, 随着团簇尺寸的增加, 能级间隙呈现奇偶振荡规律; Al2Ni2团簇具有最高的结合能, 易分离成Ni原子和Al2Ni团簇; 含Al的合金团簇最易先分离出一个Al原子, 而含Ni的合金团簇没有这种趋势.     

Coherent beam combination of adaptive fiber laser array with tilt-tip and phase-locking control

We present an experimental study on tilt-tip(TT) and phase-locking(PL) control in a coherent beam combination(CBC) system of adaptive fiber laser array.The TT control is performed using the adaptive fiber-optics collimator(AFOC),and the PL control is realized by the phase modulator(PM).Cascaded and simultaneous controls of TT and PL using stochastic parallel gradient descent(SPGD) algorithm are investigated in this paper.Two-fiber-laser-,four-fiber-laser-,and six-fiber-laser-arrays are employed to study the TT and PL control.In the cascaded control system,only one high-speed CMOS camera is used to collect beam data and a computer is used as the controller.In a simultaneous control system one high-speed CMOS camera and one photonic detector(PD) are employed,and a computer and a control circuit based on field programmable gate array(FPGA) are used as the controllers.Experimental results reveal that both cascaded and simultaneous controls of TT using AFOC and PL using PM in fiber laser array are feasible and effective.Cascaded control is more effective in static control situation and simultaneous control can be applied to the dynamic control system directly.The control signals of simultaneous PL and TT disturb each other obviously and TT and PL control may compete with each other,so the control effect is limited.     

深圳城市气溶胶物理光学特性的观测研究

气溶腔是影响气候变化和空气污染的重要因子,在深圳地区展开气溶胶观测实验,可以获得可靠的光学物理特征,进而有助于准确评估气溶胶在新型超极城市区域的气像和环境效应,本文利用2010年12月至2011年8月太阳光度计、黑碳和浊度计等气溶胶观测资料,分析了新型超级城市深圳地区的气溶胶物理光学特性,深圳地区气溶胶呈明显季节变化,冬、春季由于城市污染性气溶胶的影响,气溶胶光学厚度和Angstrom波长指数都较大,夏季受海盐气溶胶的影响,光学厚度较小Angstrom波长指数也较小,光学厚度与Angstrom波长指数对比表明城市综合性污染是引起深圳气溶胶高光学厚度的主要原因,深圳地区气溶胶的散射系数、吸收系数的平均值(标准偏差)分别为178.7×10-6 m-1 (126.6×10-6m-1和32.5×1O-6m 1 (18.1×10-6m1),均低于珠三角腹地多年观测平均值的二分之一和国内其他大型城市观测值,而单次散射反照率为0.81,与珠三角其他地区得到的结果接近.此外,气溶胶吸收、散射和单次散射反照率呈明显日变化,可能主要受大气边界层变化的影响.     

棒状分子聚合物溶液的微宏观数值模拟

利用微宏观耦合方法模拟了棒状分子聚合物溶液在平板Couette流动中的复杂流变行为,其中微宏观模型通过非均匀Doi理论来描述.数值模拟中,应用有限体积方法耦合求解了介观尺度上的Smoluchowski方程和宏观尺度上的流场守恒方程.数值结果不仅得到了若干种典型的流动类型,而且还预测了另外两种新的复合瑕疵结构.数值试验表明：棒状分子聚合物的流变结构主要依赖于De数、分子相对尺度以及溶液浓度常数的取值;并且De数对分子指向矢的翻滚周期、随流取向角等微观特性也均有明显影响. 关键词： 棒状分子 聚合物溶液 微宏观模拟     

Room-temperature direct-bandgap photoluminescence from strain-compensated Ge/SiGe multiple quantum wells on silicon

Strain-compensated Ge/Si_0.15Ge_0.85 multiple quantum wells were grown on an Si_0.1>Ge_0.9 virtual substrate using ultrahigh vacuum chemical vapor deposition technology on an n⁺-Si(001) substrate. Photoluminescence measurements were performed at room temperature, and the quantum confinement effect of the direct-bandgap transitions of a Ge quantum well was observed, which is in good agreement with the calculated results. The luminescence mechanism was discussed by recombination rate analysis and the temperature dependence of the luminescence spectrum.     

Experimental confirmation of a new reversed butterfly-shaped attractor

This paper reports a new reverse butterfly-shaped chaotic attractor and its experimental confirmation. Some basic dynamical properties, and chaotic behaviours of this new reverse butterfly attractor are studied. Simulation results support brief theoretical derivations. Furthermore, the system is experimentally confirmed by a simple electronic circuit.     

Design of square-shaped heat flux cloaks and concentrators using method of coordinate transformation

A square-shaped heat flux cloak and a square-shaped heat flux concentrator have been designed theoretically according to the invariance symmetry of steady state thermal conductive equation. The direction of heat flux in these devices can be modulated as desired. Using the method of coordinate transformation, the inhomogeneous and anisotropic thermal conductivity in the transformation region have been acquired. Two-dimensional finite element simulations were performed to confirm the theoretical results.     

Structural and electronic properties of cobalt carbide Co2C and its surface stability: Density functional theory study

Density functional theory calculations have been performed to investigate the structural and electronic properties of bulk Co₂C and the stability of low index Co₂C surfaces. We found that the formation of Co₂C is exothermic with the formation energy of ? 0.81 eV/Co₂C with respect to Co under the presence of syngas (mixture of CO and H₂). While formed Co₂C can be decomposed further to metal Co and graphite carbon with modest energy gain of 0.37 eV/Co₂C. This suggests that Co₂C is only metastable in Fischer–Tropsch synthesis, which agrees well with experimental findings. The density of states (DOSs) reveals that the Co₂C is paramagnetic and strong metallic-like. The difference of charge density analysis indicates that the bond of Co₂C is of the mixtures of metallic, covalent, and ionic properties. A variety of low index Co₂C surfaces with different terminations are studied. We find that the surface energy of low index stoichiometric Co₂C highly relies on the surface area, the number of coordination of surface atoms and the surface dipole, with the decreased stability order of (101) > (011) > (010) > (110) > (100) > (001) = (111). Our results indicate that under Co-poor condition, the formation of non ? stoichiometric surface (011) and (111) without terminated cobalt is energetically more favorable, while under Co-rich condition the formation of non ? stoichiometric (111) surface with cobalt overlayer are preferential.     

与偏振无关的双向3×3光开关结构设计

利用传统成熟的偏振控制技术,设计了一种由偏振光分束器、相位型空间光调制器、反射镜和四分之一波片构成的3×3光开关。该光开关具有结构紧凑规整、功能的实现与信号光的偏振态无关以及可以完成双向交换等特点。根据其路由控制表对该3×3光开关交换模块功能的实现进行了分析,结果表明,通过对各相位型空间光调制器状态的调整,控制通过其信号光的偏振态,完成信号光的路由,该交换模块可以完成输入信号光的全排列无阻塞输出与交换。同时,该交换模块具有一定的扩容和重构能力,对于构建大规模的交换矩阵具有一定的作用。