Mechanical Properties of Breast Cancer Cell Membrane Studied with Optical Tweezers

Membrane tethers are extracted from breast cancer cells using a force generated by an optical trap. It is experimentally obtained that the radius of tether is about 0.1μm and the static tether force is about 8.5 pN. Calculations based on the experimental measurements give a bending modulus for the tether of 1.35 x 10^-19 N.m and a surface membrane tension of 6.76 x 10^-6 N/m in the breast cancer cell. The treatment with cytochalasin D results in the decreasing bending modulus and decreasing apparent surface tension. When the membrane protein caveolin is over-expressed, similar cases occur in bending modulus and apparent surface tension. In addition, the viscous resistance coefficient of the membrane is calculated to be 1.15pN.s/μm according to the dynamic tether forces obtained under different pulling velocities.     

Transient saturation absorption spectroscopy excited near the band gap at high excitation carrier density in GaAs

Transient saturation absorption spectroscopy in GaAs thin films was investigated using femtosecond pump and supercontinuum probe technique at excitation densities higher than 1×10^{19}cm^{-3}. The Coulomb enhancement factor of the electron－hole plasma results in a spectrum hole at the pump wavelength. Two distinct transmission peaks at two sides of the pump wavelength are observed, arising from the bleaching of transitions from the heavy- and light-hole bands to the conduction band. The dynamic process of the transient saturation absorption is fitted using a bi-exponential function. The fast decay process is dominated by the carrier-phonon scattering and the slow process may be attributed to the electron－hole recombination.     

A Novel UWB Antenna with Small Side-Leakage

A successful design for a UWB (ultra-wideband antennas) antenna based on NRD-guide (nonradiative dielectric waveguide) with small side-leakage is presented. The rule of the theoretical selection of its parameters, if NRD-guide is used as the UWB antennas, is studied firstly, then the temporal propagation characteristics of the NRD-guide and the radiation characteristics for an tapered open-ended NRD-guide are calculated by FDTD (finite-difference time-domain) method.     

A diode-pumped passively Q-switched Nd:GdVO4 laser with a GaAs saturable absorption

We have demonstrated a passively Q-switched operation of Nd:GdVO₄ laser in which a GaAs crystal is used as the saturable absorber for the first time as far as we know. A maximum average output power of 1.64 W was obtained at an incident pump power of 12 W, the corresponding optical conversion efficiency and peak power were 13.7% and 116.8 W, respectively. The maximum peak energy obtained in the experiment by 50% transmission couple was 19 μJ.     

Spectral Characteristics of White Organic Light-emitting Diodes Based on Novel Phosphorescent Sensitizer

采用新型贵金属铱的配合物bis(1,2-dipheny1-1H-benzoimida-zole)iridium (acetylacetonate)作为磷光敏化剂,与荧光染料4-(dicyanomethylene)-2-t-butyl-6-(1,1,7,7-tetramethyljulolidyl-9-en-yl)-4H-pyran共同掺杂到聚合物主体材料poly(N-vinylcarbazole)中,以N,N'-diphenyl-N,N'-bis(1-naphthyl) (1,1'-biphenyl)-4,4'-diami-ne作为蓝光发光层,制备了白色有机电致发光器件. 通过对掺杂体系的紫外-可见吸收光谱、光致发光光谱以及电致发光光谱的表征,分析了该磷光敏化体系的能量转移机制. 结果表明,在该聚合物磷光荧光双掺杂体系中,由于磷光与荧光材料之间的不完全的F?rster能量传递过程,导致电致发光光谱中同时存在磷光材料三线态到基态与荧光材料单线态到基态的辐射衰减发光. 该掺杂体系成功实现了白光发射,随着偏置电压的升高,器件的CIE色坐标有微小的红移,但都非常接近等能白光点,器件表现出了很好的色纯度.     

Effects of sintering temperature and Bi2O3 content on microstructure and magnetic properties of LiZn ferrites

The effects of sintering temperature and Bi₂O₃ content on the microstructure and magnetic properties of lithium–zinc (LiZn) ferrites prepared by a conventional ceramic method were investigated. The results show that the densification behavior and grain growth rate were greatly improved by the addition of Bi₂O₃, because a liquid phase sintering occurred during the sintering process at high temperature due to the low-melting point of Bi₂O₃ (825 °C). X-ray diffraction (XRD) patterns of the slightly doped samples did not reveal the appearance of any phase other than spinel LiZn ferrite. However, the secondary phase of perovskite BiFeO₃ was detected for Bi₂O₃ content of more than 0.25 wt%. The studies further show that Bi oxide was present at grain boundary, and promoted the grain growth as reaction center at lower temperature. A high saturation magnetization, squareness ratio, minimum ferromagnetic resonance linewidth and low coercive force were obtained for the sample with 1.00 wt% Bi₂O additive at lower sintering temperature (1100 °C).     

Structure and magnetic properties of SmCoxTi0.4-1:7 ribbons

SmCo_xTi_0.4 (x=6.6, 7.1, 7.6, 8.1) ribbons have been prepared by melt spinning at a wheel speed of 42 m/s, followed by annealing at 750 °C for 2 h. Both as-spun and as-annealed ribbons possess the disordered TbCu7-type (1:7) phase even when the Sm/(Co,Ti) atomic ratio deviates from 1/7. The c/a ratio increases with increasing Co concentration x, but the unit cell volume decreases. The Curie temperatures show above 700 °C, increasing from 707 °C for x=6.6 to 782 °C for x=8.1. The saturation magnetizations increase almost linearly with increasing Co content. The observed magnetic hardening is believed to arise from the high magnetocrystalline anisotropy of the 1:7 phase and the fine nanograin structure. The intrinsic coercivity of 9797 Oe has been obtained in the melt-spun SmCo_7.1Ti_0.4 ribbons.     

Microemulsion-mediated in-situ synthesis and magnetic characterization of polyaniline/Zn<Subscript>0.5</Subscript>Cu<Subscript>0.5</Subscript>Fe<Subscript>2</Subscript>O<Subscript>4</Subscript> nanocomposite

Polyaniline/Zn_0.5Cu_0.5Fe₂O₄ nanocomposite was synthesized by a simple, general and inexpensive in-situ polymerization method in w/o microemulsion. The effects of polyaniline coating on the magnetic properties of Zn_0.5Cu_0.5Fe₂O₄ nanoparticles were investigated. The structural, morphological and magnetic properties of as-prepared samples were characterized by X-ray diffraction (XRD), Fourier transform infrared (FTIR) spectra, scanning electron microscopy (SEM) and magnetic measurements. The morphology analysis confirmed that polyaniline was deposited on the porous surface of magnetic Zn_0.5Cu_0.5Fe₂O₄. It was shown that the saturation magnetization and coercivity of Zn_0.5Cu_0.5Fe₂O₄ decreased after polyaniline coating, which can be interpreted by the interparticle dipole–dipole interactions that contributed to magnetic anisotropy and changed the magnetic properties of the nanoparticles. PACS  74.25.Ha; 81.05.-t; 81.05.Lg     

Efficient scheme of quantum SWAP gate and multi-atom cluster state via cavity QED

In this paper, we propose a physical scheme to realize quantum SWAP gate by using a large-detuned single-mode cavity field and two identical Rydberg atoms. It is shown that the scheme can also be used to create multi-atom cluster state. During the interaction between atom and cavity, the cavity is only virtually excited and thus the scheme is insensitive to the cavity field states and cavity decay. With the help of our scheme it is very simple to prepare the $N$-atom cluster state with perfect fidelity and probability. The practical feasibility of this method is also discussed.     

Synergistic effect of silver seeds and organic modifiers on the morphology evolution mechanism of silver nanoparticles

Triangular, truncated triangular, quadrangular, hexagonal, and net-structured silver nanoplates as well as decahedral silver nanoparticles were manipulatively prepared starting from silver nitrate and silver seeds in the presence of poly(ethylene glycol) (PEG), poly(N-vinyl pyrrolidone) (PVP), and Tween 80 at room temperature, respectively. UV-vis spectroscopy, XRD, HRTEM, SAED, and FTIR were used to illustrate the crystal growth process and to characterize the resultant silver nanoparticles. It was found that the silver seeds and organic modifiers synergistically affected the morphology evolution of the silver nanoparticles. The co-presence of silver seeds and PEG was beneficial to the formation of triangular and truncated triangular silver nanoplates; the silver seeds and PVP favored the formation of polygonal silver nanoplates; the silver seeds and Tween 80 preferred to the formation of net-structured silver plates. The morphology evolution of the resultant silver nanoparticles was correlated with the crystallinity of the silver seeds and the adsorption ability of the organic modifiers on the crystal surfaces.