Ion adsorption at the rutile-water interface: linking molecular and macroscopic properties

A comprehensive picture of the interface between aqueous solutions and the (110) surface of rutile (alpha-TiO2) is being developed by combining molecular-scale and macroscopic approaches, including experimental measurements, quantum calculations, molecular simulations, and Gouy-Chapman-Stern models. In situ X-ray reflectivity and X-ray standing-wave measurements are used to define the atomic arrangement of adsorbed ions, the coordination of interfacial water molecules, and substrate surface termination and structure. Ab initio calculations and molecular dynamics simulations, validated through direct comparison with the X-ray results, are used to predict ion distributions not measured experimentally. Potentiometric titration and ion adsorption results for rutile powders having predominant (110) surface expression provide macroscopic constraints of electrical double layer (EDL) properties (e.g., proton release) which are evaluated by comparison with a three-layer EDL model including surface oxygen proton affinities calculated using ab initio bond lengths and partial charges. These results allow a direct correlation of the three-dimensional, crystallographically controlled arrangements of various species (H2O, Na+, Rb+, Ca2+, Sr2+, Zn2+, Y3+, Nd3+) with macroscopic observables (H+ release, metal uptake, zeta potential) and thermodynamic/electrostatic constraints. All cations are found to be adsorbed as "inner sphere" species bonded directly to surface oxygen atoms, while the specific binding geometries and reaction stoichiometries are dependent on ionic radius. Ternary surface complexes of sorbed cations with electrolyte anions are not observed. Finally, surface oxygen proton affinities computed using the MUSIC model are improved by incorporation of ab initio bond lengths and hydrogen bonding information derived from MD simulations. This multitechnique and multiscale approach demonstrates the compatibility of bond-valence models of surface oxygen proton affinities and Stern-based models of the EDL structure, with the actual molecular interfacial distributions observed experimentally, revealing new insight into EDL properties including specific binding sites and hydration states of sorbed ions, interfacial solvent properties (structure, diffusivity, dielectric constant), surface protonation and hydrolysis, and the effect of solution ionic strength.     

Structure and Thermal Stability of a Novel 2‐D Layered Copper(II) Coordination Polymer with the Bidentate Ligand 1, 2, 4‐Triazol‐5‐one

Single crystals of {[Cu(TO)₂(H₂O)₂](NO₃)₂}_n (TO: 1, 2, 4‐triazol‐5‐one) were grown by slow evaporation from aqueous solution. It crystallizes in the orthorhombic space group Pbca, with a = 7.082(1), b = 10.285(1), c = 17.911(3)Å, V = 1304.6(3)ų, Z = 4. The Cu^II distorted octahedra are bridged by bidentate TO ligands into infinite 2‐D interlaced rhombic grid‐like network planes, {[Cu(TO)₂(H₂O)₂]²⁺}_n. Hydrogen bonds, electrostatic interactions, and weak van der Waals' forces assemble these planes and the NO₃^— anions to a layered structure. The title compound decomposes at 153.4 °C to the final products, Cu(CN)₂ and CuO.     

Capillary electrochromatography of peptides on a column packed with tentacular weak cation-exchanger particles

Silica-based, tentacular weak cation-exchanger particles were prepared for use as the stationary phase in the separation of positively charged sample components by capillary electrochromatography (CEC). Silica beads were first silanized with 3-(trimethoxysilyl) propyl methacrylate that served as a heterobifunctional linker, which reacted with 2-acrylarmidoglycolic acid in a second step by radical polymerization in aqueous solution. Baseline separation of basic peptides with good column efficiency was obtained on packed capillary columns by isocratic elution CEC with NaCl as the mobile phase modulator. The retention mechanism in the electrochromatographic process was studied by examining the effect of salt concentration on the migration behavior of the peptides. The chromatographic retention factor k'(lc) for charged sample components in the electrochromatographic process was estimated on the assumption that the overall migration rate of a charged migrant can be taken as the sum of the rate of chromatographic elution and the rate of electrophoretic migration. The estimated k(lc) values from experimental results were plotted against the molal salt concentration on a double logarithmic scale. The linear correlation is in good agreement with the prediction by the theory on the basis of traditional ion-exchange chromatography. The comparison of CEC results, obtained with open tubular and packed capillary columns having the same retentive functions as the stationary phase, supports the notion that variation of the phase ratio in the column offers an additional means to modulate the electrochromatographic migration behavior.     

Synthesis of an optically active intermediate for A-ring of 19-nor- 1α,25-dihydroxyvitamin D3

An optically active intermediate 5 for A-ring of 19-nor-1a,25-dihydroxyvitamin D3 2 has been synthesized in five steps, starting from readily available, inexpensive D( )-xylose 6 with good yield.     

无外加催化剂条件下芳香醛与活性亚甲基化合物的缩合反应和迈克尔加成反应

在DMF溶剂中,不外加催化剂使芳香醛(1)与2,2-二甲基-1,3-二氧六环-4,6-二酮(2)发生缩合反应生成2,2-二甲基-5-芳亚甲基-1,3-二氧六环-4,6-二酮(3a～f)。在同样条件下,芳香醛与5,5-二甲基-1,3-环己二酮(4)则发生缩合和迈克尔加成反应生成2,2’-芳亚甲基双(3-羟基-5,5-二甲基-2-环己烯-1-酮)(5a～h)。用单晶X-射线分析法确定了产物5b的晶体结构。     

C_（60）的胺加成反应和电喷雾电离质谱（ESI－MS）检测

报道了Ｃ６０与１，３－丙二胺和Ｎ，Ｎ－二甲基－１，３－丙二胺的加合反应，反应产物未经预先离子化处理直接用ＥＳＬ－ＭＳ进行检测。由于反应产物从甲苯溶液中析出，避免了生成多胺基加合物，产物以单加成物为主。当加合反应在空气氛下进行时，有加合氧的产物Ｃ６０Ｏｎ（ＮＨ２—ＣＨ２ＣＨ２ＣＨ２ＮＲ２）ｍ（Ｒ＝Ｈ，ＣＨ３）存在。实验发现：Ｎ，Ｎ－二甲基－１，３－丙二胺比１，３－丙二胺更容易与Ｃ６０发生多胺基加成和氧加成反应。通过控制反应条件可制备Ｃ６０二胺的单加成产物。     

A direct hydrogen-1 and phosphorus-31 nuclear magnetic resonance cation solvation study of Al(ClO4)3, Ga(ClO4)3, In(ClO4)3, UO2(ClO4)2, and UO2(NO3)2 in water-acetone-dimethylsulfoxide and water-acetone-hexamethylphosphoramide mixtures

A competitive solvation study of Al(ClO₄)₃, Ga(ClO₄)₃, In(ClO₄)₃, UO₂(ClO₄)₂, and UO₂(NO₃)₂ in water-acetone-dimethylsulfoxide (DMSO) and water-acetone-hexamethylphosphoramide (HMPT) mixtures has been carried out by direct H¹ and P³¹ nuclear magnetic resonance (NMR) techniques. At low temperature, proton and ligand exchange are slow enough in these systems to permit the observation of signals for bulk and coordinated molecules of water and the organic bases (DMSO and HMPT). Both DMSO and HMPT compete effectively with water for coordination sites in the Al³⁺, Ga³⁺, and In³⁺ systems, with steric effects dominating the HMPT results. Both Al³⁺ and In³⁺ are able to bind a maximum of two to three HMPT molecules, for example. In contrast, UO²⁺ is solvated selectively by the organic molecules to the allowed maximum of 4 molecules per cation. H¹ and P³¹ NMR spectral results support the formation of only the mono-, tri-, and tetra-HMPT solvation complexes.     

A highly regio- and stereoselective nickel-catalyzed ring-opening reaction of alkyl- and allylzirconium reagents to 7-oxabenzonorbornadienes

[Reaction: see text]. An efficient method for the synthesis of cis-2-alkyl- or allyl-1,2-dihydronaphthalenes via a nickel-catalyzed highly regio- and stereoselective ring-opening addition of alkyl- or allylzirconium reagents to 7-oxabenzonorbornadienes is described. Treatment of 7-oxabenzonorbornadienes 1a-c with various alkylzirconium reagents 2a-j (Cp2ZrClCH2CH2R: R = tert-butyl, n-butyl, n-pentyl, -(CH2)3CH=C(CH3)2, -SiMe3, -CH2SiMe3, -(CH2)3Br, cyclopentyl, cyclohexyl, and benzyl) in the presence of NiBr2(dppe) and Zn powder in dry THF at 50 degrees C afforded the corresponding cis-2-alkyl-1,2-dihydronaphthalene derivatives 3a-m in good yields. In addition, allyl zirconium reagents 4a-c also underwent ring-opening reactions with 1a and 1c to give 5a-d in very good yields. The alkylative ring-opening products from 7-oxabenzonorbornadiene can be further converted to naphthalene derivatives 6a-c, via an acid-mediated dehydration, in good to excellent yields. A possible mechanism for the present catalytic reaction was proposed.     

Determination of vitamin C and preservatives in beverages by conventional capillary electrophoresis and microchip electrophoresis with capacitively coupled contactless conductivity detection

The separation and detection of commonly used preservatives (benzoate, sorbate) and vitamin C by both conventional CE and microchip electrophoresis with capacitively coupled contactless conductivity detection is presented. The separation was optimized by adjusting the pH-value of the buffer and the use of hydroxypropyl-beta-CD (HP-beta-CD) and CTAB as additives. For conventional CE, optimal separation conditions were achieved in a histidine/tartrate buffer at pH 6.5, containing 0.025% HP-beta-CD and 0.1 mM CTAB. LOD ranged from 0.5 to 3 mg/L (S/N = 3) and the RSDs for migration time and peak area were less than 0.1 and 2%, respectively. A considerable reduction of analysis time can be accomplished by using microchip electrophoresis without significant loss in sensitivity under optimal separation conditions. A histidine/tartrate buffer at pH 6.5, incorporating 0.06% HP-beta-CD and 0.25 mM CTAB, gave detection limits ranging between 3 and 10 mg/L and satisfactory reproducibilities of < or =0.4% for the migration time and < or =3.5% for the peak area. The methods developed are useful for the quantitative determination of food additives in real samples such as soft drinks and vitamin C tablets.