Contribution à la phytochimie du genre Gentiana. XXVI.. Identification d'une nouvelle di-O-glucosyl cinnamoyl-C-glucosylflavone extraite des feuilles de Gentiana X marcailhouana RY.

Phytochemistry of Genus Gentiana. XXVI. Identification of a New Di-O-glucosyl Cinnamoyl-C-glucosylflavone in the Leaves of Gentiana X marcailhouana RY . A new di-O-glucosyl cinnamoyl-C-glucosylflavone has been identified as 4′-O-β-D -glucosyl-2″-O-[2-O-β-D -glucosyl-2,4,5-trihydroxy-(E)-cinnamoyl]isoorientin ( 1 ).     

Derivatives and reactions of glutacondialdehyde V : The crystal and molecular structure of 5-hydroxy-trans-2, trans-4-pentadienal acetate. The charge distribution in the glutacondialdehyde anion

The structure of 5-hydroxy-trans-2, trans-4-pentadienal acetate has been determined, using three-dimensional diffractometercollected X-ray data. The compound has the all-trans configuration with the atoms C-1 to C-5 in a plane. The charge distribution in the acetate and in the glutacondialdehyde anion have been calculated using the CNDO/2 approximation. In both compounds higher negative charges were found on carbon atoms C-2 and C-4 than on C-1, C-3 and C-5.     

Programmable gate delayed ion mobility spectrometry-mass spectrometry: a study with low concentrations of dipropylene-glycol-monomethyl-ether in air

The concept of using a short ionisation event, in this case a pulsed corona discharge, in conjunction with programmed gate delay is described. This technique is proposed for the selective study of different ionisation processes within the reaction region of an ion mobility spectrometer. The utility of such an approach was tested in a study of the ionisation of dipropylene-glycol-monomethyl-ether (DPM); a compound commonly used to test the operation of ion mobility spectrometers. Dipropylene-glycol-monomethyl-ether at a concentration of 113 microg m(-3) in air, with a water level of 75 mg m(-3) in air, was analysed using a switchable, high resolution ion mobility spectrometer, operating in the positive mode at 40 degrees C at ambient pressure. The ion mobility spectrometer was fitted with a pulsed corona discharge ionisation source, doped with ammonia at a concentration of 1.3 mg m(-3) in the reaction region, and interfaced to a mass spectrometer. Synchronisation of the ionisation event to the operation of the shutter grids for the drift region enabled different parts of the product ion population to be injected into the drift tube, and programming the gate delays produced a map of the gate delay verses drift time response surface. Ammonium bound dipropylene-glycol-monomethyl-ether was observed, [(DPM)NH4]+ (m/z 166) as well as the ammonium bound dimer [(DPM)2NH4]+ (m/z 314), the same as those observed with a 63Ni source. Two other species were also observed, but their molecular identity was not elucidated. One of them m/z 146, also observed with 63Ni, formed ammonium bound ions [(m/z 146)NH4]+ (K0= 1.49 cm2 V(-1) s(-1)), ammonium bound dimer ions [(m/z 146)2NH4]+(K0= 1.18 cm2 V(-1) s(-1)) and a mixed cluster ion with DPM [(m/z 146)(DPM)NH4]+(K0= 1.18 cm2 V(-1) s(-1)); while the other, m/z 88 a decomposition product, formed ammonium bound monomer [(m/z 88)NH4]+(K0= 1.68 cm2 V(-1) s(-1)), dimer ions [(m/z 88)2NH4]+(K0= 1.40 cm2 V(-1) s(-1)) and a mixed cluster ion containing DPM and ammonium, [(DPM)(m/z 88)2NH4]+(K0= 1.40 cm2 V(-1) s(-1)). The assignment of responses to these ions required the additional dimensionality in the data provided from the gate delay studies. The relationships evident in the programmable gate delay data enabled these ions to be differentiated from alternative assignments of possible nitrogen clusters, formed at the interface of the mass spectrometer.     

Stabilization of γ‘ phase in Bi<Subscript>4</Subscript>V<Subscript>2-x</Subscript>Fe<Subscript>x</Subscript><Superscript>II</Superscript>O<Subscript>11-1.5x</Subscript> series

Summary This work reports the room-temperature stabilization of the Bi₄V_2-xFe_x^IIO_11-1.5x γ ‘ phase, a promising ionic conductive material that finds application in solid oxide fuel cell and oxygen sensor devices. The Fe(II) cation proved to be a better stabilizer than Fe(III), which was previously used, since a lower substitution degree of V⁵⁺ is needed for the former. Powder X-ray diffraction, Fourier-transform infrared spectroscopy and differential scanning calorimetry were used in these experiments.     

Development of a quality control method for the characterization of oligonucleotides by capillary zone electrophoresis-electrospray ionization-quadrupole time of flight-mass spectrometry

A capillary zone electrophoresis-negative electrospray ionization-quadrupole time of flight-mass spectrometric method was developed for the characterization of oligonucleotides after synthesis, using model compounds. The major difficulty is the adduction of metal cations to the polyanionic backbone of the oligonucleotide sample, resulting in complex spectra and decreased sensitivity. Several approaches were investigated to circumvent this problem. Separation was performed in an ammonium carbonate buffer. During separation, the interfering metal ions were exchanged for ammonium ions, which are less tightly bound to the oligonucleotide when ionized. The influence of the addition of piperidine and imidazole or trans-1,2-diaminocyclohexane-N,N,N',N'-tetraacetic acid (CDTA) to the running buffer for further reduction of cation adduction was investigated. Addition of CDTA to the buffer system resulted in a deconvoluted spectrum with very little adducts. On-line sample stacking proved vital to preconcentrate the samples. The pH and the concentration of the ammonium carbonate buffer as well as the electrophoresis voltage were optimized to achieve the best signal response for the oligonucleotides and a maximum reduction of the cation adducts as well as a short analysis time. Finally, the sheath liquid composition was examined for further improvement of the signal. The developed method was used to analyze different oligonucleotides (5000-9200 Da) in light of its use as a final quality control method for oligonucleotides in terms of purity and sequence homogeneity of the synthesized products. In all cases, very little adducts were observed in the deconvoluted spectra, and the relative errors of the measured molecular masses ranged from 3 to 35 ppm.     

Synthesis of meso-tetra-(3,5-dibromo-4-hydroxylphenyl)-porphyrin and its application to second-derivative spectrophotometric determination of lead in clinical samples

A new very sensitive and selective chromogenic reagent, meso-tetra-(3,5-dibromo-4-hydroxylphenyl)porphyrin [T(DBHP)P], was synthesized and studied for the determination of trace lead in detail. In 0.10 mol l-1 NaOH medium, lead reacts with T(DBHP)P to form a 1:2 yellow complex, which gives a maximum absorption at 479 nm; 0-0.48 microgram ml-1 Pb(II) obeyed Beer's law. The molar absorptivity of the complex and Sandell's sensitivity are 2.5 x 10(5) 1 mol-1 cm-1 and 0.000812 microgram cm-2, respectively. Second-derivative spectrophotometry is better than conventional spectrophotometry in sensitivity and selectivity, and its limit of quantification, limit of detection and relative standard deviation are 0.70 ng ml-1, 0.21 ng ml-1 and 1.0%, respectively. Ca (3250-fold), Mg (2000-fold), Sr (1000-fold), Ba (750-fold), Al (1000-fold), Bi (500-fold), Fe (2000-fold), Co (750-fold), Ni (1000-fold), Cu (750-fold), Zn (1250-fold), Cd (2500-fold) and Ag (550-fold) do not interfere with the determination of lead. The chromogenic system is remarkably superior to other reagents, especially porphyrin compounds. The influence caused by oxygen in air or in solution can be easily eliminated by adding Na2SO3. The reaction is very stable, the stability constant of the complex being 1.2 x 10(45). The chromogenic reaction is completed within 1 min at room temperature when 8-hydroxylquinoline is used as catalyst. The proposed method has been applied to the direct determination of trace lead in clinical samples. The accuracy and precision are both very satisfactory.     

Trennung,Identifizierung und Bestimmung von Bactericiden auf der Basis von halogenierten Aromaten mittels Gas-Chromatographie

The separation of a mixture of 22 bactericides has been achieved by gas chromatography on columns with silicone rubber W-982 as stationary phase with temperatures between 100° and 300°C. The unchanged compounds as well as their silylation products have been used. The latter are more conveniently used especially for the quantitative determination. To be able to calculate the retention indices after Kovats gas chromatography has been performed isothermally at 180°C for the more volatile compounds and at 250°C for all other bactericides.The retention indices obtained under these conditions are tabulated together with the limits of detection.     

Molecular mechanics (MM2) calculations and cone angles of phosphine ligands

Molecular mechanics (MM2) calculations were performed on 54 conformations of 18 phosphines (PH₃; PH_3−nR_n, where n = 1,…3, and R = Me and Et, n = 1 or 2 and R =ⁱPr, and n = 1 and R =^tBu, PMe₂Et, PMeEt₂, and PPhMe₂, and PPh₂R where R = Me, Et, ⁱPr, ^tBu and Ph). The results are compared to those previously obtained from MINDO/3 and MNDO calculations, and to experimental data. Single conformer cone angles and weighted average cone angles were calculated from MM2 optimized geometries employing Tolman's general definition, and they are compared to Tolman's values, MINDO/3 results, and T.L. Brown's E_R values. Of the cone angle definitions used, the weighted average values are suggested as the best single representation of phosphine ligand sizes. The steric parameters (cone angle and E_R values) alone, and in conjunction with electronic parameters, are correlated with experimental data.     

TRANSFER OF EXCITATION ENERGY BETWEEN PORPHYRIN CENTERS OF A COVALENTLY-LINKED DIMER*

Abstract— Three covalently-linked porphyrin hybrid dimers were synthesized, each containing a metallotetraarylporphyrin [Zn(II), Cu(II), or Ni(II)], and a free base tetraarylporphyrin. Transfer of singlet excitation energy from the metalloporphyrin center to the free base porphyrin center was determined by measuring fluorescence properties. The Zn hybrid dimer displayed excellent intramolecular transfer of energy ( 85%) from the excited singlet state of the Zn(II) chromophore to the free base chromophore. No evidence for such transfer of the excited singlet state energy was found in the Ni(II) or Cu(II) analogues. From our experimental data, the fluorescence quantum yield of the Zn hybrid dimer was the same as for the free base monomer porphyrin (0.11; Seybold and Gouterman, 1969). Thus, the covalent attachment of another fluorescent porphyrin center effectively doubled the antenna size without decreasing the quantum yield even though the fluorescence quantum yield of the Zn(II) containing monomer was substantially less (0.03, according to Seybold and Gouterman, 1969) than that of the free base porphyrin. The donor-acceptor distance and the rate constant for energy transfer were calculated using the Forster equation. Assuming random orientation, a donor-acceptor distance of 15 Å was calculated with an associated rate constant (k_ci) for energy transfer of 1.9 ± 10₉ s_–1.     

2-Amino-4-bromobutanoic Acid

(2S)- and (2R)-2-Amino-4-bromobutanoic acid were prepared starting from N-Boc-glutamic acid α tert-butyl ester. The double tert-butyl protection was necessary to prevent a partial racemisation during Barton’s radical decarboxylation used to transform the γ-carboxylic group into a bromide. This bromide reacted with different nitrogen, oxygen and sulphur nucleophiles to give nonnatural amino acids characterised by basic or heterocyclic side chains. The title compound was also used to prepare a conformationally constrained peptidomimetic.