Comparison of quantitative methods for analysis of polyphasic pharmaceuticals

Adequate very sensitive quantification methods are needed for the development and are also now required for the monitoring of undesirable solid form(s) as routine tests. The pre-requisite for quantitation are selectivity, sensitivity and most important the purity of standards and their proper storage, what is a challenge for metastable forms. Several analytical techniques are available such as X-ray diffraction, spectroscopy, thermal analysis and microcalorimetry. The different steps of the validation of the analytical methods and problems to be solved are discussed. Examples illustrate the different techniques and compare their possible advantages and limits. The relative standard deviation of measurements should allow for checking the homogenization procedure of mixtures for calibration. The validation should be carried out following ICH guidelines for validation of analytical methods. Comparison of different techniques in adequate concentration range add confidence in the analytical results.     

Temperature influence on hydrogen sorption in palladium limited-volume electrodes (Pd-LVE)

The effect of temperature on hydrogen and deuterium electrosorption into a palladium LVE (limited-volume electrode) has been investigated. A decrease in hydrogen capacity (H/Pd ratio) with increasing temperature has been observed. Temperature strongly influences the plots of measured H(D)/Pd values vs. potential scan rate. In addition, hydrogen absorption was found to be dependent on the composition of the surrounding electrolyte solution. These results have confirmed the hypothesis that two different mechanisms of hydrogen desorption from the palladium electrode take place, namely electrochemical oxidation and non-electrochemical recombination. Further, the ratio between the rate constants for these two processes has been found to change with temperature. Electronic Publication     

Kinetics of thermal decomposition of alkaline phosphates

Summary The thermal behavior of KH₂PO₄, NaH₂PO₄ and Na₂HPO₄ under non-isothermal conditions using TG method with different heating rates was studied. The values of the reaction rate were processed by means of Friedmans differential-isoconversional method. A dependence of the activation energy vs. conversion was observed. Therefore a procedure based on the compensation effect (suggested by Budrugeac and Segal) was applied. A less speculative data processing protocol was offered by the non-parametric kinetics method suggested by Serra, Nomen and Sempere. Three steps were observed by non-isothermal heating: a dehydration, a dimerization and a polycondensation. The differences in the intimate reaction mechanism are determined by the initial number of water molecules.     

E-olefin dipeptide isostere incorporation into a polypeptide backbone enables hydrogen bond perturbation: probing the requirements for Alzheimer's amyloidogenesis

Herein, we report a stereospecific E-olefin dipeptide isostere synthesis that can be used to make gram quantities of the Phe-Phe isostere desired for eliminating a specific backbone H-bond donor and acceptor in the Alzheimer's disease related Abeta peptide. The Phe19-Phe20 E-olefin analogue of Abeta(1-40) was prepared by solid-phase peptide synthesis and was subjected to amyloidogenesis conditions. This analogue can aggregate into spherical morphologies but does not progress on to form protofibrils or fibrils as is the case for the all-amide sequence, providing insight into the structural requirements for amyloidogenesis.     

Interaction of gas phase atomic hydrogen with Pt(111):Direct evidence for the formation of bulk hydrogen species

Employing hot tungsten filament to thermal dissociate molecular hydrogen,we generated gas phase atomic hydrogen under ultra-high vacuum(UHV)conditions and investigated its interaction with Pt(111) surface.Thermal desorption spectroscopy(TDS)results demonstrate that adsorption of molecular hy- drogen on Pt(111)forms surface Had species whereas adsorption of atomic hydrogen forms not only surface Had species but also bulk Had species.Bulk Had species is more thermal-unstable than surface Had species on Pt(111),suggesting that bulk Had species is more energetic.This kind of weakly- adsorbed bulk Had species might be the active hydrogen species in the Pt-catalyzed hydrogenation reactions.     

Photochemistry of condensed isoxazolines

Summary The condensed bridged isoxazolines4 are rearranged on irradiation with a low-pressure mercury lamp exclusively into condensed derivatives of tetrahydropyridine5. The selectivity of the rearrangement is due to a stabilization of the biradical8 by the overlap of the radical-electrons with -electrons of the C=C double bond and the heterocyclic ring. Quantum yields of the photorearrangement, established from the consumption of the starting materials4, were determined.

---

Photochemie kondensierter Isoxazoline

Zusammenfassung Die kondensierten überbrückten Isoxazoline4 werden durch Bestrahlen mit einer Niederdruckquecksilberlampe ausschließlich zu kondensierten Tetrahydropyridinderivaten (5) umgelagert. Die Selektivität der Umlagerung beruht auf der Stabilisierung des Diradikals8 durch Überlappung der ungepaarten Elektronen mit -Elektronen der C=C-Doppelbindung und des Heterocyclus. Aus dem Verbrauch an Ausgangsmaterial (4) wurden Quantenausbeuten der Photoumlagerung bestimmt.

     

Implementation and use of the method of prudent ascent in conformational analysis using molecular mechanics

In two-dimensional conformational analysis the current practice is to perform an energy minimization for all possible combinations of two dihedral angles in the molecule, in a fixed order, and apply a certain dihedral angle step-size. A newly developed method is presented in which the order of the evaluation points on the energy-surface is not fixed, but is dependent on all previous results in a way which we call “the method of prudent ascent.” In this method the most promising calculation is carried out first, thus minimizing the risk of atomic collisions. In order to be able to take care of the many additional degrees of conformational freedom present in, e.g., carbohydrate molecules, all minimizations are performed using a set of different promising starting conformations on the basis of previous calculations, and only the lowest energy result for each point is saved. An application of the method to conformational analysis of methyl-cellobiose and the artificial sweetener trichlorogalactosucrose is also presented.     

State vectors and propagators in many-electron theory. A unified approach

A unitary group formulation of the many-electron problem is employed to give explicit representations of state vectors which are convenient for the discussion of progerties derived from propagatorcalculations. New results are obtained concerning the nature of various random-phase-like approximations and ground state representatives are generated from consistency requirements for the spectral resolution of the polarization propagator. The explicit solution admits the calculation of ground state average values for arbitrary operators and a variational upper bound to the ground state energy.     

Determination of Low Contents of Fenpiverine Bromide by Extraction Spectrophotometry

An ion-pair extraction spectrophotometry method was developed for the determination of fenpiverine bromide in tablets. To determine this substance it was necessary to find experimental conditions that would allow eliminating the influence of other components of the tablets. Attention was paid to the fact that a suitable pH of water phase was necessary to achieve high selectivity.Received December 11, 2002; accepted April 24, 2003 Published online July 28, 2003     

Improving the efficiency and convergence of geometry optimization with the polarizable continuum model: new energy gradients and molecular surface tessellation

New equations are derived and implemented for efficient and accurate computation of solvation energy derivatives for the conductor-like polarizable continuum model (C-PCM) and the isotropic integral equation formalism polarizable continuum model (IEF-PCM). Two new molecular surface tessellation procedures GEPOL-RT and GEPOL-AS that generate near continuous potential energy surfaces are proposed for PCM geometry optimization. The combined use of these new techniques leads to efficient and convergent geometry optimizations with the PCMs.