Separation of B6 vitamers with micellar liquid chromatography using UV and electrochemical detection

Separation of six vitamers of vitamin B6 was performed by RP-HPLC using micellar mobile phase, UV and electrochemical detection. Effect of temperature, type and amount of organic modifier in mobile phase on efficiency and asymmetry factor showed that, the appropriate conditions were temperature of 35 degrees C and 3.0-5.0% (v/v) 1-butanol in mobile phase. Variations of selectivity factor versus 1-butanol concentration, pH of mobile phase, and SDS concentration was investigated and the following optimized conditions were selected for the separation: 3.0% (v/v) 1-butanol, pH=5.5 and 65 mM SDS in mobile phase. Electrochemical behavior of vitamers in optimized mobile phase was investigated using cyclic voltammetry, and potential of +1.2 V versus Ag/AgCl(Sat.) was chose as working potential. Finally, separation of B6 vitamers using UV detection at 254 nm and electrochemical detection at +1.2 V was compared.     

Vapor–liquid equilibria of binary tri-potassium citrate + water and ternary polypropylene oxide 400 + tri-potassium citrate + water systems from isopiestic measurements over a range of temperatures

Water activity measurements have been carried out on the aqueous solutions of both tri-potassium citrate (K₃Cit) and polypropylene oxide (PPO) 400 + K₃Cit over a range of temperatures at atmospheric pressure. The data obtained is used to calculate the vapor pressure as a function of temperature and concentration. The effect of temperature on the constant water activity lines of aqueous PPO + K₃Cit systems has been studied and it was found that, at higher temperatures the higher concentration of polymer is in equilibrium with a certain concentration of the salt. Also it was found that the vapor pressure depression for an aqueous PPO + K₃Cit system is more than the sum of those for the corresponding binary solutions. The experimental water activities have been correlated successfully with the segment-based local composition Wilson model. The agreement between the correlation and the experimental data is good.     

Dispersive solid-phase extraction of risperidone from plasma samples using graphene oxide aerogels and determination with liquid chromatography

A graphene oxide-based aerogel was synthesized and applied to the extraction and the determinations with the high-performance liquid chromatography-ultraviolet detector. After the characterization of the produced graphene-aerogel, it was utilized as a dispersive solid-phase extraction sorbent for risperidone extraction from plasma samples. Aerogels are materials with a large surface area-to-mass ratio and plenty of core with functional groups which can easily attach to the analytes to extract them to the second phase. The suggested method determined risperidone in plasma samples in the wide dynamic range from 20 ng/ml to 3 μg/ml. The limits of detection and quantification of the developed method were calculated as 2.4 and 8.2 ng/ml, respectively. As a novel feature, the developed method has no need to precipitate plasma proteins, improving the analytical performance of the analysis. Also, for the first time, the produced materials were utilized for the extraction of risperidone from the plasma samples. The obtained results revealed that the developed approach could be employed as an accurate method for the quantification of risperidone in real plasma samples.     

Preparation and validation of [67Ga]Ga-phytate kit and Monte Carlo dosimetry: an effort toward developing an impressive lymphoscintigraphy tracer

Journal of Radioanalytical and Nuclear Chemistry - Radiocolloides are essential for the detection of metastatic lymph nodes in breast cancer. In this study [67Ga]Ga-phytate, as an long-lived...     

Crack-free,thick rhodium deposition on copper substrate using Rhodex solution

Summary Rhodium electrodeposition on a copper substrate was investigated for ¹⁰³Pd production. The electrodeposition was carried out by the commercially available Rhodex plating baths. The optimum conditions of the electrodeposition for complete depletion of Rh were: 6.2 g/l rhodium, DC current density of 12.83 mA ^. cm^-2 and 60 °C temperature.     

Gas-chromatographic fatty-acid fingerprints and partial least squares modeling as a basis for the simultaneous determination of edible oil mixtures

Partial least squares modeling and gas-chromatographic fatty-acid fingerprints are reported as a method for the simultaneous determination of cottonseed, olive, soybean and sunflower edible oil mixtures. In this work, two sets of three- and four-component combinations of oils were prepared, hydrolyzed and the obtained free fatty acids analyzed by gas chromatography (GC) without any further derivatization. The normalized percentages of the myristic (14:0), palmitic (16:0), palmitoleic (16:1), stearic (18:0), oleic (18:1), linoleic (18:2) and linolenic (18:3) acids were chromatographically measured in samples and used for constructing calibration matrix. The cross-validation method was used to select the number of factors and the proposed methods were validated by using two sets of synthetic oil mixture samples. The relative standard error for each oil in mixture samples was less than 10%. This approach allows determining possible adulteration in each of the four edible oils.     

The influence of La2O3 and TiO2 on NiO/MgO/α-Al2O3

Summary The effect of La₂O₃ and TiO₂ on product selectivity, methane conversion and coke formation over NiO/MgO/ α -Al₂O₃ catalyst were studied in a simultaneous steam and CO₂ reforming of methane to syngas. La₂O₃ and TiO₂ were added to the catalyst via incipient wetness impregnation and bulk precipitation techniques and catalyst activity was tested in a fixed bed quartz reactor. Results reveal that although the addition of these oxides has no effect on the product selectivity and methane conversion, but can reduce coke formation on the surface of the catalysts as it can enhance the mobility of lattice oxygen anions. The results further show that the catalysts prepared by bulk precipitation technique decrease the coke formation more effectively.     

Hemilabile Ligands as Mechanosensitive Electrode Contacts for Molecular Electronics

Single‐molecule junctions that are sensitive to compression or elongation are an emerging class of nanoelectromechanical systems (NEMS). Although the molecule–electrode interface can be engineered to impart such functionality, most studies to date rely on poorly defined interactions. We focused on this issue by synthesizing molecular wires designed to have chemically defined hemilabile contacts based on (methylthio)thiophene moieties. We measured their conductance as a function of junction size and observed conductance changes of up to two orders of magnitude as junctions were compressed and stretched. Localised interactions between weakly coordinating thienyl sulfurs and the electrodes are responsible for the observed effect and allow reversible monodentate?bidentate contact transitions as the junction is modulated in size. We observed an up to ≈100‐fold sensitivity boost of the (methylthio)thiophene‐terminated molecular wire compared with its non‐hemilabile (methylthio)benzene counterpart and demonstrate a previously unexplored application of hemilabile ligands to molecular electronics.     

Covalent bonding of magnetic Fe3O4 nanoparticles to aminopropyl‐functionalized magnesium phyllosilicate clay: Synthesis and cytotoxic potential investigation

Stable water dispersion of Fe₃O₄ magnetic nanoparticles (NPs) were successfully synthesized by using 3‐glycidoxypropyltrimethoxysilane (GPTMS) and Mg‐phyllo (organo) silicate known as aminoclay (AC) containing pendant amino groups with the approximate composition (R₈Si₈Mg₆O₁₆(OH)₄, R = CH₂CH₂CH₂NH₂). The Fe₃O₄‐GPTMS magnetic NPs with an epoxy functional group are suitable for forming a covalent bond with the amine group of aminoclay in an epoxy ring opening reaction. Appropriate Fe₃O₄‐GPTMS‐aminoclay (FG‐AC) magnetic composite are promising carriers for the targeting and delivery of platinum‐based anticancer drugs. Analysis of the cytotoxicity of the nanostructures on a K562 leukemia cell line using a colorimetery assay shows that both the FG‐AC and cis‐platin/FG‐AC magnetic composite were biocompatible. The nanostructures characterizations were investigated by Fourier transform infrared spectroscopy, X‐ray diffraction, transmission electron microscopy and energy dispersive analysis of X‐ray techniques. Magnetic measurement revealed that the saturated magnetization of the FG‐AC nanocomposite reached 7.6 emu/g and showed the characteristics of magnetism.     

The Role of Bi3+ in Promoting and Stabilizing Iron Oxo Clusters in Strong Acid

Metal oxo clusters and metal oxides assemble and precipitate from water in processes that depend on pH, temperature, and concentration. Other parameters that influence the structure, composition, and nuclearity of “molecular” and bulk metal oxides are poorly understood, and have thus not been exploited. Herein, we show that Bi³⁺ drives the formation of aqueous Fe³⁺ clusters, usurping the role of pH. We isolated and structurally characterized a Bi/Fe cluster, Fe₃BiO₂(CCl₃COO)₈(THF)(H₂O)₂, and demonstrated its conversion into an iron Keggin ion capped by six Bi³⁺ irons ( Bi₆Fe₁₃ ). The reaction pathway was documented by X‐ray scattering and mass spectrometry. Opposing the expected trend, increased cluster nuclearity required a pH decrease instead of a pH increase. We attribute this anomalous behavior of Bi/Fe(aq) solutions to Bi³⁺, which drives hydrolysis and condensation. Likewise, Bi³⁺ stabilizes metal oxo clusters and metal oxides in strongly acidic conditions, which is important in applications such as water oxidation for energy storage.