双掺(Tm3+,Tb3+)LiYF4激光器1.5 μm波长激光阈值分析

由速率方程推出了双掺（Tm^3 ,Tb^3 ）离子准四能级系统的激光阈值解析式，讨论了Tm^3 和Tb^3 离子之间的相互作用。分析了1.5μm波长附近的激光阈值和Tm^3 、Tb^3 离子的掺杂原子数分数及晶体长度的关系。结果表明，对于对应Tm^3 离子^3H4→^3F4跃迁的约1.5μm波长的激光，激活离子Tm^3 的掺杂原子数分数过大时，交叉弛豫作用将使系统阈值迅速增加。Tb^3 离子的加入，一方面能抽空激光下能级，起到降低阈值的作用；另一方面亦减少了激光上能级的寿命，使阈值升高。故Tb^3 离子有最佳掺杂原子数分数。对于Tm原子数分数为y=0.01的Tm:LiYF4晶体，Tb^3 离子的最佳掺杂原子数分数为0.002左右，同时表明，激光阈值与晶体长度有关。最佳晶体长度与Tm^3 、Tb^3 离子的掺杂原子数分数以及晶体的衍射损耗和吸收损耗有关。     

Real time estimation of CO2 laser weld quality for automotive industry

Laser welding is one of the most precise welding processes in joining sheet metals. In laser welding, performing real time evaluation of the welding quality is very important to enhance the efficiency of the welding process. In this study, the plasma and spatter, which are generated during laser welding, are measured using UV and IR photodiodes. The factors that influence weld quality are classified into five categories; optimal heat input, slightly low heat input, low heat input, partial joining due to gap mismatch, and nozzle deviation. The data number deviated from reference signals and their standard deviations were also considered to evaluate the qualities. A system was also formulated to perform real time evaluations of the weld quality using a fuzzy multi-feature pattern recognition with the measured signals.     

Comparison of stimulated-emission-pumping fluorescence dip spectrometry and conventional fluorescence spectrometry in application to supersonic jet spectrometry

Summary A supersonic jet spectrum of 9,10-dichloroanthracene is measured by stimulated-emission-pumping fluorescence dip spectrometry and conventional fluorescence spectrometry. The performance obtained is compared for these spectrometric methods, providing same information concerned with the energy level of the ground state. The former is more preferential for measurement of a high-resolution spectrum, since the spectral resolution is determined by the linewidth of the dumping laser. On the other hand, the latter is more preferential for measurement with better sensitivity at the expense of the spectral resolution, since the fluorescence throughput can be improved by increasing the slit width of the monochromator.Dedicated to Professor Dr. Wilhelm Fresenius on the occasion of his 80th birthday     

Fractionation and composition of the carbohydrates of leaf vegetables

The qualitative and quantitative compositions of the carbohydrates of the leaf vegetables Lactuca sativa L., Spinacea oleracea L., and Rumex acetosa L. have been studied.M. V. Lomonosov Odessa Technological Institute of the Food Industry. Translated from Khimiya Prirodnykh Soedinenii, No. 3, pp. 349–351, May–June, 1993.     

An investigation of the membranotropic properties of the plant toxin thionin isolated fromPyrularia pubera

It has been shown by the ESR of spin probes that thionin initially interacts with with negatively charged membranes electrostatically and then passes into the membranes to a depth comparable with the length of the hydrophobic sections of the protein loops.Institute of Bioorganic Chemistry, Academy of Sciences of the Republic of Uzbekistan, Tashkent. Brigham Young University, Provo, Utah, USA. Translated from Khimiya Prirodnykh Soedinenii, No. 4, pp. 594–597, July–August, 1993.     

End unit effect on the Tg of differentiated series of perfluoro-poly (oxymethylene-co-oxyethylene) oligomers

Twelve series of linear oligomers of four different degrees of polymerization (x_n = 8.77−41.55), having a common perfluorinated random copolymeric chain as molecular body and two equal foreign end units of one of the types listed in Table 1, have been synthesized by derivatization of base samples of one of them having a diolic---CH₂OH functionality. The glass transition temperature T_g of all the series was measured and thus examined as a function of x_n. A clear end unit effect is observed, dominantly determined in every series by chemical nature and structure of the end units, quantitatively expressed at any x_n by different positive or negative T_g deviations from the common asymptotic T_g∞ value. The results are also discussed in terms of copolymer end effect and of relation between T_g and end copolymeric composition.     

Mechanical properties of polyester polymer-concrete

The properties of a polymer-concrete composed of polyester matrix and locally available rock aggregate are investigated. The formula of the concrete is found by an experimental-calculation approach in such a way as to attain a closer packing of the aggregate particles on the one hand, and to ensure the needed processing characteristics (placeability) of the mix on the other. It is shown experimentally that the material obtained has a rather high compression strength. Under prolonged compression loads, the polymer-concrete exhibits a noticeable creep behavior with a linear relation between the creep strains and stresses. After the action of half the ultimate load over 3000 h, the total strains exceed the instantaneous ones by 2.0 to 2.2 times. The accumulation of irreversible strains is also observed; however, their contribution to the total strain is small. It is found that the stress-strain relation can be represented by the equation of linear hereditary creep theory.Institute of Polymer Mechanics, University of Latvia, Riga, LV-1006, Latvia. Translated from Mekhanika Kompozitnykh Materialov, Vol. 35, No. 2, pp. 147–162, March–April, 1999.