Adsorption from Ternary Liquid Mixtures on Partially Dehydroxylated Silica Gel

The formation of mixed adsorbed layers has been tested for ternary mixtures containing a specifically adsorbed component—acetone and binary solvent benzene +n-hepane. The specific excess adsorption isotherms from the liquid phase were measured on silica gel samples partially dehydroxylated. The competition of liquid components for silica surface is discussed on the basis of changes in the mixed solvent composition.     

Pyrolysis-gas chromatography-mass spectrometry of cured phenolic resins

A previously described pyrolysis device with a movable reaction zone was used in the present work for thermal degradation of cured novolac and resol resins. After the pyrolysis the usual major components were identified, as well as relatively low-volatile aromatic compounds which were revealed after their separation in a capillary chromatographic column. Among the latter components, for both types of cured resins, xanthene and its methyl derivatives were found. The isomers of bis(hydroxyphenyl)methane were found in considerable quantities only in the case of partially cured novolac resins which contained any linear sequences in their structure.     

Atom-transfer radical polymerization of poly(ethylene oxide) macromonomers in aqueous media

Soluble comb-shaped and swelling network polymers based on monomethacrylate (M = 2080) and bismethacrylate (M = 4000) poly(ethylene oxide) macromonomers, have been synthesized by the controlled atom-transfer radical polymerization in aqueous media. PEG 2000 methyl ether ethyl-2-bromoisobutyrate and 2-bromoisobutyrate, in combination with CuBr, CuBr₂, and 2,2′-bipyridyl, have been used as initiators. The length of the main chain of comb-shaped polymers, as estimated with multidetector chromatography, is in good agreement with the calculated values in the 15–20 range at M _w /M _n = 1.42–1.89. The polymerization of the methacrylate macromonomer proceeds at a high rate and with a nearly quantitative conversion. The replacement of 10–80 mol % CuBr with CuBr₂ appreciably decelerates polymerization and decreases polydispersity to 1.14–1.21, while the experimental and calculated values of chain lengths remain equal. This finding indicates a higher level of process control. The polymer networks thus prepared manifest Gaussian elastic behavior, as is evident from the relationship between the elastic modulus G and the swelling degree Q that is consistent with the classical prediction G ～ Q ^m , where m = ?1/3. Within the framework of the accepted model of networks of this type, this fact suggests the short length of polymethacrylate chains. In addition, the relationship between the time of attainment of the gelation point and the composition of the initiation system agrees with the atomtransfer controlled polymerization mechanism. The efficiencies of various radical polymerization methods for controlling the network structure are compared.     

The magnetizability of excited-state hydrogen: temperature-independent paramagnetism in the B1Σ+u state

Components, of the magnetizability tensor for the B¹Σ⁺_u and a ³Σ⁺_g states ot the hydrogen molecule have been calculated for fixed bond lengths near equilibrium. Explicitly correlated “generalised James-Coolidge” type wavefunctions were used. It is found thilt in the B 1Σ⁺_u state the molecular magnetizability is a positive quantity.     

A Stopped-flow Study on the Kinetics and Mechanism of CO2 Uptake by the cis-[Cr(1,10-phenanthroline)2(OH2)2]3+ Complex Ion

The kinetics of the reaction between gaseous CO₂ and the cis-[Cr(phen)₂(OH₂)₂]³⁺ ion leading to the formation of the carbonato complex ion, have been studied over the pH and temperature ranges: 3 < pH < 6 and 5 < T < 25 °C, respectively, at a constant ionic strength of 1 m (NaClO₄). Investigations were carried out using the stopped-flow spectrophotometry technique in the UV–Vis range: 340–700 nm. The major reactant species in the pH range studied was cis-[Cr(phen)₂(OH)(OH₂)]²⁺ ion, which underwent reaction with CO₂ to form cis-[Cr(phen)₂(OH₂)(HCO₃)]²⁺ ion. Subsequently, slower ring closure of the latter species to form the bidentate carbonato chelate was observed. The possible mechanism has been discussed and the activation parameters ΔH^† and ΔS^† were also determined for the reaction studied.     

Adsorption of<Emphasis Type="Italic"> N</Emphasis>-dodecyl-<Emphasis Type="Italic">N</Emphasis>,<Emphasis Type="Italic">N</Emphasis>-dimethyl-3-ammonio-1-propanesulfonate (DDAPS), a model zwitterionic surfactant,on the Au(111) electrode surface

Electrochemical measurements including cyclic voltammetry, differential capacity, and chronocoulometry have been used to characterize the adsorption behaviors of the zwitterionic surfactant N-dodecyl-N,N-dimethyl-3-ammonio-1-propanesulfonate (DDAPS) on the Au(111) electrode surface. The thermodynamics of the ideally polarized electrode have been employed to determine the Gibbs excess and the Gibbs energy of adsorption. The results show that the adsorption of DDAPS has a multistate character. The first two states are observed at potentials close to zero charge. At low bulk DDAPS concentrations, it corresponds to the formation of a film of nearly flat adsorbed molecules. At higher concentrations it is converted into a hemimicellar state. The second state is formed at negative potentials and charge densities close to 0 C cm^–2. It corresponds to a film of tilted molecules oriented with the hydrocarbon tail towards the metal and the polar head toward the solution.Dedicated to Professor Zbigniew Galus on the occasion of his 70^th birthday and in recognition of his many contributions to electrochemistry.     

Interferences in ultratrace speciation of organolead and organotin by gas chromatography with atomic spectrometric detection

Interferences in trace and ultratrace speciation analysis of organotin and organolead compounds in various samples by gas chromatography coupled with atomic absorption spectrometry (AAS) and/or microwave induced plasma atomic emission spectrometry (MIP AES) are investigated. Particular attention is given to the effects of matrix co-extractives and reagents impurities introduced during sample preparation. Their influence on the detection limits is discussed in terms of baseline noise level, blank value, formation of artefacts and signal suppression. Loss of column resolution during the analysis of some matrices is observed.     

Determination of total carbon and total organic carbon from volatile air pollutants

Summary The method developed based on the determination of TC and TOC in the form of the total amount of CO₂ requires application of the proper techniques for the final determination of CO₂. The possibility of using a stream of carrier gas at a convenient flow-rate for desorbing quantitatively CO₂ concentrated on a molecular sieve permits use of a wide variety of known analytical techniques for the final determination of CO₂. Various methods were compared on the basis of both absolute and calibration measurements. The absolute methods chosen were gravimetric (classical or an automated version based on application of a gravimetric automat and automatic recording balance), thermogravimetric analysis and coulometry. The calibration methods included thermal conductivity, the flame-ionization detector (after conversion of CO₂ into methane) and infrared absorption. Usefulness of the methods was evaluated on the basis of comparative statistical analysis of experimental data with respect to precision (Snedecor'sF-test and Bartlett'sU ²-test) and accuracy (Student'st-test).

---

Zusammenfassung Das entwickelte Verfahren zur Bestimmung des TC- und TOC-Gehaltes in Form der gesamten Menge CO₂ erfordert die Anwendung geeigneter Analysentechniken zur Endbestimmung dieser Verbindung. Die Möglichkeit einer Desorption des am Molekularsieb angereicherten CO₂ in einem Gasstrom mit geeignetem Durchfluß erlaubt zur Endbestimmung von CO₂ die Anwendung einer Reihe verschiedener Analysenverfahren. Die Anwendbarkeit verschiedener, auf Absolutverfahren und auch auf relativen Messungen beruhender Methoden wurde vergleichend untersucht. Die folgenden Methoden zur CO₂-Bestimmung wurden gewählt: die Gravimetrie (klassische oder automatisierte unter Einsatz eines Wägeautomaten und einer registrierenden Waage), die Thermogravimetrie und die Coulometrie. Von den relativen Methoden wurden die Thermokonduktometrie, der Flammenionisationsdetektor (nach Umsetzung von CO₂ zu Methan) und das IR-Absorptionsmeßverfahren geprüft. Die Anwendbarkeit der Methoden wurde mit Hilfe statistischer Prüfverfahren beurteilt, wobei die Präzision (SnedecorsF-Test und BartlettsU ²-Test) und die Genauigkeit (Studentst-Test) der erhaltenen Analysenwerte verglichen wurden.

     

Methyl 3‐(4‐methoxyphenyl)prop‐2‐enoate

The title mol­ecule, C₁₁H₁₂O₃, is almost planar, with an average deviation of the C and O atoms from the least‐squares plane of 0.146 (4) Å. The geometry about the C=C bond is trans. The phenyl ring and –COOCH₃ group are twisted with respect to the double bond by 9.3 (3) and 5.6 (5)°, respectively. The endocyclic angle at the junction of the propenoate group and the phenyl ring is decreased from 120° by 2.6 (2)°, whereas two neighbouring angles around the ring are increased by 2.3 (2) and 0.9 (2)°. This is probably associated with the charge‐transfer interaction of the phenyl ring and –COOCH₃ group through the C=C double bond. The mol­ecules are joined together through C—H?O hydrogen bonds between the methoxy and ester groups to form characteristic zigzag chains extended along the c axis.     

Formation and thermal decomposition of aluminium nitroxy compounds

During the reactions of lithium oxide with aluminium nitride, and of lithium nitride with aluminium oxide, the formation has been observed of a previously unknown compound, of composition Li₂AlNO. The course of its thermal decomposition has also been determined.

---

Zusammenfassung Es wurde das Auftreten einer bisher unbekannten Verbindung der Zusammensetzung LiAlNO bei den Reaktionen von Lithiumoxid mit Aluminiumnitrid und Lithiumnitrid mit Aluminiumoxid beobachtet. Der Verlauf der thermischen Zersetzung dieser Verbindung wurde bestimmt.

---

Li₂AlNO. .