Kinetics of proton transfer in a green fluorescent protein: A laser-induced pH jump study

The sub-millisecond protonation dynamics of the chromophore in S65T mutant form of the green fluorescent protein (GFP) was tracked after a rapid pH jump following laser-induced proton release from the caged photolabile compoundo-nitrobenzaldehyde. Following a jump in pH from 8 to 5 (which is achieved within 2 μs), the fluorescence of S65T GFP decreased as a single exponential with a time constant of ∼90 μs. This decay is interpreted as the conversion of the deprotonated fluorescent GFP chromophore to a protonated non-fluorescent species. The protonation kinetics showed dependence on the bulk viscosity of the solvent, and therefore implicates bulk solvent-controlled protein dynamics in the protonation process. The protonation is proposed to be a sequential process involving two steps: (a) proton transfer from solvent to the chromophore, and (b) internal structural rearrangements to stabilize a protonated chromophore. The possible implications of these observations to protein dynamics in general is discussed     

Dynamic mechanical thermal analysis transitions of partially and fully substituted cellulose fatty esters

The main transitions of cellulose fatty esters with different degrees of substitution (DSs) were investigated with dynamic mechanical thermal analysis. Two distinct main relaxations were observed in partially substituted cellulose esters (PSCEs). They were attributed to the glass‐transition temperature and to the chain local motion of the aliphatic substituents. The temperatures of both transitions decreased when DS or the number of carbon atoms (n) of the acyl substituent increased. Conversely, all the transitions of fully substituted cellulose esters occurred within a narrow temperature range, and they did not vary significantly with n. This phenomenon was explained by the formation of a crystalline phase of the fatty substituents. The presence of few residual OH groups in PSCEs was responsible for a large increase in the storage bending modulus, and it eliminated the effect of n on damping. © 2002 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 281–288, 2003     

Cycloaddition of Thiourea to Tri(1-propenyl)amine

Russian Journal of General Chemistry -     

Simulation of Convective Flow of an Electrically Conducting Fluid in a Cavity

A new quasi-hydrodynamic algorithm is proposed for numerical analysis of convective flows in the presence of a homogeneous external magnetic field. The Marangoni convection problem in a square cross-section cavity is solved.     

Viscoelastic properties of nanostructured natural rubber/polystyrene interpenetrating polymer networks

The effects of the blend ratio and initiating system on the viscoelastic properties of nanostructured natural rubber/polystyrene‐based interpenetrating polymer networks (IPNs) were investigated in the temperature range of ?80 to 150 °C. The studies were carried out at different frequencies (100, 50, 10, 1, and 0.1 Hz), and their effects on the damping and storage and loss moduli were analyzed. In all cases, tan δ and the storage and loss moduli showed two distinct transitions corresponding to natural rubber and polystyrene phases, which indicated that the system was not miscible on the molecular level. However, a slight inward shift was observed in the IPNs, with respect to the glass‐transition temperatures (T_g's) of the virgin polymers, showing a certain degree of miscibility or intermixing between the two phases. When the frequency increased from 0.1 to 100 Hz, the T_g values showed a positive shift in all cases. In a comparison of the three initiating systems (dicumyl peroxide, benzoyl peroxide, and azobisisobutyronitrile), the dicumyl peroxide system showed the highest modulus. The morphology of the IPNs was analyzed with transmission electron microscopy. The micrographs indicated that the system was nanostructured. An attempt was made to relate the viscoelastic behavior to the morphology of the IPNs. Various models, such as the series, parallel, Halpin–Tsai, Kerner, Coran, Takayanagi, and Davies models, were used to model the viscoelastic data. The area under the linear loss modulus curve was larger than that obtained by group contribution analysis; this showed that the damping was influenced by the phase morphology, dual‐phase continuity, and crosslinking of the phases. Finally, the homogeneity of the system was further evaluated with Cole–Cole analysis. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 1680–1696, 2003     

Epoxy based coatings on glass: strengthening mechanisms

Glass may be strengthened by epoxy coatings although the strengthening mechanisms remain unclear. Possible strengthening mechanisms are reviewed and are used to analyse strength data for both a solvent based and a water based coating system. The coatings either fill (solvent based coatings), or partially fill (water based coatings) surface cracks and it is shown that closure stresses arising from the thermal expansion mismatch of the coating within these cracks can account for the observed degrees of strengthening. It is also demonstrated that other suggested mechanisms such as flaw healing cannot fully account for the observed degree of strengthening.     

Norm Series in High-Dimensional Local Fields

In the present paper, the notion of norm series with respect to the norm residue symbol is generalized to high-dimensional local fields. Necessary and sufficient conditions for the existence of norm series are obtained. Bibliography: 12 titles.__________Translated from Zapiski Nauchnykh Seminarov POMI, Vol. 305, 2003, pp. 60–83.     

Effect of maltodextrins on the surface activity of small-molecule surfactants

We report on the effect of commercially important polysaccharides (maltodextrins with variable dextrose equivalent (Paselli SA-2, MD-6 and MD-10) on the surface activity at the air–water interface of small-molecule surfactants (sms), possessing different hydrophobic–lipophilic balance ((SSL (Na⁺), the main component is a sodium salt of stearol–lactoyl lactic acid, and PGE (080), polyglycerol ester of C18 fatty acid), and widely used in food products. A marked change of the surface activity of sms was found in the presence of maltodextrins by tensiometry. The combined data of laser multiangle light scattering and mixing calorimetry have suggested that this result is governed by specific complex formation between maltodextrins and sms in aqueous medium. Measurements have been made of the molar mass, the second virial coefficient and the enthalpy of intermolecular interactions in aqueous solutions. The implication of a degree of polymerization of maltodextrins in this phenomenon was shown. The interrelation between the molecular parameters of the formed complexes and their surface activity at the air–water interface has been revealed and discussed.