Experimental investigation and theoretical modeling of liquid entrainment in a horizontal tee with a vertical-up branch

This article describes a comprehensive literature review of liquid entrainment in horizontal pipes with vertical-up branches. Deficiencies in the available data and correlations were identified. The Air–water Test Loop for Advanced Thermal–hydraulic Studies (ATLATS) was constructed and entrainment onset and steady-state data were collected for a wide range of flow conditions. Using new insights gained from experimental testing, the authors developed a model for predicting the onset of entrainment and steady-state entrainment rate. Previously published correlations, along with the new model, are compared against all available data. The new model shows very good agreement with the onset data, but is not very good at predicting branch quality at high liquid flow rates.     

Effect of decoupled fluid loading on nonlinear vibration of a flat plate

Numerical simulations of nonlinear responses of a flat plate subject to decoupled fluid loading are carried out. Under clamped boundary conditions and subject to forced vibration at its natural frequency corresponding to the (5,1) mode, the various response modes of the plate are determined. It is found that increasing the excitation amplitude, the response changed from periodic to chaotic. In addition, the fluid-wall shear stresses are found to change the response from linear to nonlinear and vice versa depending on their magnitudes. When a static pressure load is combined with fluid-wall shear stresses and low excitation amplitude, the resulting response was chaotic.     

On the orthogonality of natural modes of vibration

The natural modes of a discrete linear system are orthogonal with respect to the mass and stiffness matrices in a generalized sense. However, these modes are usually not orthogonal to each other in the ordinary sense. The purpose of this paper is to document a number of conditions under which the modes are also orthogonal in an ordinary fashion.     

Experimental flow study over a blunt-nosed axisymmetric body at incidence

The flowfield over a blunt-nosed cylinder was examined experimentally at a low subsonic speed for Re=1.88×10⁵ and angles of attack up to 40°. Velocity measurements were carried out (employing a seven-hole Pitot tube) as well as wall static pressure and wall shear-stress measurements. Surface flow visualization was applied using liquid crystals and a mixture of oil–TiO₂. For all the examined cases no flow asymmetries were found. For high angles of attack (20° and above) a separation “bubble” appears at the leeside of the nose area (streamwise flow separation). The basic feature of the circumferential pressure distribution at the after body area for these angles of attack is a plateau close to the suction peak and a fast recovery next to it. One streamwise vortex on each side of the symmetry plane is formed as well as a separation bubble about 90° far from this plane, where the cross-flow primary separation line is located. Each cross-flow primary separation line starts at the leeside nose area and moves towards the windward side along the cylindrical after body. The space between the two primary separation lines close to the wall is characterized by high flow fluctuations on the leeside, compared to the low fluctuations of the windward side.