A new microbial electrode for BOD estimation

A new microbial electrode using immobilizedClostridium butyricum was prepared for biochemical oxygen demand (BOD) estimation of wastewaters. The current of the electrode was decreased with time until a steady state was reached. The steady state current was in all cases attained within 30-40 min at 37°C, and the maximum current output was obtained at 37°C and pH between 6.2 and 7.0. A linear relationship was obtained between the steady state current and BOD. The steady state current values were reproducible within ±7% of the relative error. The BOD of industrial wastewaters can be estimated by using the microbial electrode. Relative error of the BOD estimation of industrial wastewaters was within ± 10%. The current output of the microbial electrode was almost constant for 30 days.     

A free energy calculation study of the effect of H-->F substitution on binding affinity in ligand-antibody interactions

Changes in binding affinity to catalytic antibody 6D9 of chloramphenicol phosphonate derivatives (CPDs) containing H or F were investigated by performing free energy calculations based on molecular dynamics simulations. We calculated the binding free energy, enthalpy, and entropy changes (DeltaDeltaG, DeltaDeltaH, and -TDeltaDeltaS) attributable to H-->F substitution by comparing results for CPDs containing a trifluoroacetylamino group (CPD-F) or an acetylamino group (CPD-H). The calculated DeltaDeltaG, DeltaDeltaH, and -TDeltaDeltaS values were -2.9, -6.3, and 3.5 kcal mol(-1) and close to experimental values observed for a series of similar ligands, chloramphenicol phosphonates with F and H (-1.4, -3.5, and 2.1 kcal mol(-1)). Therefore, CPD-F binds more strongly to 6D9 than does CPD-H. To clarify the origin of the large difference in DeltaDeltaG, we apportioned the calculated values of DeltaDeltaG and DeltaG for the associated and dissociated states into contributions from various atomic interactions. We found that the H-->F substitution increased the binding affinity mainly by decreasing the hydration free energy and not by increasing favorable interactions with the antibody. The decreased hydration free energy of the ligand was mainly due to unfavorable coulombic interactions between the trifluoroacetylamino group and solvent waters, which increased the free energy of the dissociated state (by about 3.7 kcal mol(-1)). Also, the trifluoroacetylamino group slightly increased the free energy level of the associated state (about 0.8 kcal mol(-1)) because favorable van der Waals interactions compensated for unfavorable coulombic interactions with antibody atoms. In addition, the enthalpy and entropy changes, DeltaDeltaH and -TDeltaDeltaS (computationally -6.3 and 3.5 kcal mol(-1)), originated mainly from a decrease in hydration free energy in the dissociated state. The CPD-F and CPD-H ligands had substantially different structures in the dissociated and complexed states.     

Infrared intensity in dielectric media by an electrostatic model

A change in an infrared intensity in dielectric media is treated by an electrostatic model. The basic model is originally formalized for a dipolar liquid. The model is satisfactorily applied to the infrared intensity of the C-H stretching of chloroform, which changes 22 times large in the liquid state at -43 degrees C as in the gaseous state. A change in the infrared intensity in lithium ammonium tartrate, where a ferroelectric phase transition takes place, is analyzed on the basis of a local polarization above T(c) or a spontaneous polarization below T(c), deducing important quantities on a phase transition. A difference in the infrared intensity of the C-Br stretching of 1,10-dibromodecane between the urea clathrate and the crystalline state is analyzed by evaluating electric fields due to bond moments and oscillating dipoles. These analyses confirm the mechanism of the change in the absolute infrared intensity, which originates from an electrostatic interaction with an electric field applied to a molecule or a functional group closely related to a normal mode.     

Highly (Z)-selective synthesis of beta-monosubstituted alpha,beta-unsaturated cyanides using the peterson reaction

[reaction: see text] The Peterson reaction between (t-BuO)Ph(2)SiCH(2)CN and various aldehydes furnishes the corresponding beta-monosubstituted alpha,beta-unsaturated cyanides with high Z selectivity (Z:E = 92:8 to >98:2).     

Dithiol-mediated immobilization of CdS nanoparticles from reverse micellar system onto Zn-doped silica particles and their high photocatalytic activity

Cds nanoparticles, prepared in a reverse micellar system, were immobilized directly onto alkanedithiol-modified Zn-doped silica particles, which were themselves prepared via hydrolysis of tetraethylorthosilicate in the presence of Zn(NO(3))(2) followed by contact with dithiol molecules. The resulting CdS-Zn-SiO(2) composite was then used as a photocatalyst for the generation of H(2) from 2-propanol aqueous solution. Under UV irradiation (lambda>300 nm), a high photocatalytic activity was observed for the CdS-Zn-SiO(2) composite material. This is effected by electron transfer from the photoexcited ZnS (dithiol-bonded Zn on SiO(2)) to CdS nanoparticles. The photocatalytic activity is increased with a decrease in the number of methylene groups in the dithiol molecules, according to the rank order 1,10-decanedithiol <1,6-hexanedithiol <1,2-ethanedithiol.     

Simultaneous determination of hypoxanthine,inosine, inosine-5′-phosphate and adenosine-5′-phosphate with a multielectrode enzyme sensor

A multielectrode enzyme sensor for the simultaneous determination of adenosine-5′-phosphate (AMP), inosine-5′-phosphate (IMP), inosine (HXR) and hypoxanthine (HX)in fish meat was developed by assembling four enzyme sensors for AMP, IMP, HXR and HX in a flow cell. These compounds were determined from oxygen consumption according to the following reactions: AMP $\text{AD}$ IMP $\text{NT}$ HXR $\text{NP, PO}{}^{\mathrm{3?}}{}_4$ HX $\text{XO, O}{}_2$ Uric acid where AD is AMP deaminase, NT is 5′-nucleotidase, NP is nucleoside phosphorylase and XO is xanthine oxidase. Enzymes were covalently bound to a membrane prepared from cellulose triacetate, 1,8-diamino-4-aminomethyloctane and glutaraldehyde. Sensors for HX, HXR, IMP and AMP were prepared by attaching membranes of XO, XONP, XO NPNT, and of XONPNT and AD, respectively, to four oxygen electrodes. Samples extracted from sea bass, bream, flounder, abalone and arkshell were analyzed within 5 min, from the simultaneous response curves of the four electrodes. Results obtained by the multisensor system were in good agreement with those determined by each single electrode.     

Evaluation of homogeneity of binary blends of poly(3-hydroxybutyrate) and poly(L-lactic acid) studied by near infrared chemical imaging (NIRCI).

The homogeneity of blends of poly((R)-3-hydroxybutyrate) (PHB) and poly(L-lactic acid) (PLLA) was evaluated by the near infrared chemical imaging (NIRCI) technique. NIRCI can nondestructively investigate a sample over a wide field of view within a few minutes to acquire a large number of spatially resolved NIR spectral data. NIRCI may be combined with multivariate analysis not only for qualitative analysis but also for statistically based quantitative analysis. The score images derived from the partial least squares regression (PLSR) analysis directly show that PHB/PLLA blends are highly homogeneous. The standard deviations (STD) of the histograms, indicating the distribution of the score values, show small values for the blends. These results qualitatively and quantitatively show the high level of homogeneity of PHB/PLLA blends. The predictions of the spatially averaged concentrations of the blend components obtained from PLSR results show values similar to the actual contents for the blends. The small errors of the predictions are also explained by STD values.     

A New Family of Indoaniline-Derived Calix[4]arenes: Synthesis and Optical Recognition Properties as a Chromogenic Receptor(1)

A new family of indoaniline-derived calix[4]arenes has been synthesized for the purpose of developing a new chromogenic receptor. A condensing reaction of calix[4]arene (1) with 4-(diethylamino)-2-methylaniline hydrochloride (2) in the presence of an oxidizing agent under alkaline conditions affords mono- (3), 1,2-bis- (4), 1,3-bis- (5), and tetrakisindoaniline-derived (6) calix[4]arenes after careful column chromatography. Compound 3 is crystallized from a CHCl(3)-MeOH solution, and the crystal structure was determined by X-ray analysis. The crystal is monoclinic, space group P2(1)/n, Z = 4, a = 19.507(6) ?, b = 18.591(6) ?, c = 8.524(2) ?, beta = 94.69(2) degrees. The final R value for 2406 reflections of F(o) > 3sigma(F(o)) is 0.085. A unique intramolecular hydrogen-bonding network involving the carbonyl oxygen of indoaniline for 3 implied that the quinone carbonyl group as an acceptor of the chromophore can easily be subjected to an electrostatic interaction in the lower rim. Indeed, 1,3-bis(indoaniline)-derived 2,4-bis((ethoxycarbonyl)methoxy)calix[4]arene 7, prepared by the reaction of 5 with ethyl bromoacetate in the presence of NaH, is capable of undergoing an efficient ion-dipole interaction between the binding cation and the two quinone carbonyl groups of the chromophores, so that a selective Ca(2+)-induced pronounced color change (wavelength change > 100 nm) occurs with an association constant on the order of 10(6) in 99% EtOH, making 7 of potential use as an optical sensor for Ca(2+) detection. The IR and NMR studies have indicated that Ca(2+) is encapsulated in the cavity made by the distally located OCH(2)CO(2) groups on the lower rim of the cone-shaped calix[4]arene segment. Interestingly, however, the shape of the cavity in which Ca(2+) has been encapsulated does not have a C(2) axis of symmetry, as inferred from the (1)H-(1)H COSY experiment. On the other hand, 1,2-bis(indoaniline)-derived analogue 8 shows no response with metal ions, which can be interpreted to mean the absence of a cavity for encapsulation on the lower rim.     

Two-dimensional network formation of cardiac myocytes in agar microculture chip with 1480 nm infrared laser photo-thermal etching

We have developed a new method that enables agar microstructures to be used to cultivate cells and that allows cell network patterns to be controlled. The method makes use of non-contact three-dimensional photo-thermal etching with a 1480 nm infrared focused laser beam, which is strongly absorbed by water and agar gel, to form the shapes of agar microstructures. It allows microstructures to be easily formed in an agar layer within a few minutes, with cell-culture holes formed by the spot heating of a 100 mW laser and tunnels by the tracing of a 100 microm s(-1), 40 mW laser. We cultivated rat cardiac myocytes in adjacent microstructures and observed synchronized beating in them 90 min after they had made physical contact. Our results indicate that the system can make and use microstructures for cell-network cultivation in a minimal amount of time without any expensive microfabrication facilities or complicated procedures.     

Hydrogen Effect on Coke Removal and Catalytic Performance in Pre-Carburization and Methane Dehydro-Aromatization Reaction on Mo/HZSM-5

1. Introduction As an effective utilization of methane, the methane dehydro-aromatization was focused in the last decade [1-28]. Over the Mo/HZSM-5 bi- functional catalyst at high reaction temperature, methane can be converted into light aromatics (ben- zene and naphthalene) and hydrogen. Mo active species can activate the C—H bond of methane; and HZSM-5 supplies the acid sites for the oligomeriza- tion and cyclization of hydrocarbons to form aromat- ics, and suppresses the deeper condens…