Dithiol-mediated immobilization of CdS nanoparticles from reverse micellar system onto Zn-doped silica particles and their high photocatalytic activity

Cds nanoparticles, prepared in a reverse micellar system, were immobilized directly onto alkanedithiol-modified Zn-doped silica particles, which were themselves prepared via hydrolysis of tetraethylorthosilicate in the presence of Zn(NO(3))(2) followed by contact with dithiol molecules. The resulting CdS-Zn-SiO(2) composite was then used as a photocatalyst for the generation of H(2) from 2-propanol aqueous solution. Under UV irradiation (lambda>300 nm), a high photocatalytic activity was observed for the CdS-Zn-SiO(2) composite material. This is effected by electron transfer from the photoexcited ZnS (dithiol-bonded Zn on SiO(2)) to CdS nanoparticles. The photocatalytic activity is increased with a decrease in the number of methylene groups in the dithiol molecules, according to the rank order 1,10-decanedithiol <1,6-hexanedithiol <1,2-ethanedithiol.     

Simultaneous determination of hypoxanthine,inosine, inosine-5′-phosphate and adenosine-5′-phosphate with a multielectrode enzyme sensor

A multielectrode enzyme sensor for the simultaneous determination of adenosine-5′-phosphate (AMP), inosine-5′-phosphate (IMP), inosine (HXR) and hypoxanthine (HX)in fish meat was developed by assembling four enzyme sensors for AMP, IMP, HXR and HX in a flow cell. These compounds were determined from oxygen consumption according to the following reactions: AMP $\text{AD}$ IMP $\text{NT}$ HXR $\text{NP, PO}{}^{\mathrm{3?}}{}_4$ HX $\text{XO, O}{}_2$ Uric acid where AD is AMP deaminase, NT is 5′-nucleotidase, NP is nucleoside phosphorylase and XO is xanthine oxidase. Enzymes were covalently bound to a membrane prepared from cellulose triacetate, 1,8-diamino-4-aminomethyloctane and glutaraldehyde. Sensors for HX, HXR, IMP and AMP were prepared by attaching membranes of XO, XONP, XO NPNT, and of XONPNT and AD, respectively, to four oxygen electrodes. Samples extracted from sea bass, bream, flounder, abalone and arkshell were analyzed within 5 min, from the simultaneous response curves of the four electrodes. Results obtained by the multisensor system were in good agreement with those determined by each single electrode.     

Evaluation of homogeneity of binary blends of poly(3-hydroxybutyrate) and poly(L-lactic acid) studied by near infrared chemical imaging (NIRCI).

The homogeneity of blends of poly((R)-3-hydroxybutyrate) (PHB) and poly(L-lactic acid) (PLLA) was evaluated by the near infrared chemical imaging (NIRCI) technique. NIRCI can nondestructively investigate a sample over a wide field of view within a few minutes to acquire a large number of spatially resolved NIR spectral data. NIRCI may be combined with multivariate analysis not only for qualitative analysis but also for statistically based quantitative analysis. The score images derived from the partial least squares regression (PLSR) analysis directly show that PHB/PLLA blends are highly homogeneous. The standard deviations (STD) of the histograms, indicating the distribution of the score values, show small values for the blends. These results qualitatively and quantitatively show the high level of homogeneity of PHB/PLLA blends. The predictions of the spatially averaged concentrations of the blend components obtained from PLSR results show values similar to the actual contents for the blends. The small errors of the predictions are also explained by STD values.     

Ab initio through‐space/bond interaction analysis of the long C–C bonds in Bi(anthracene‐9,10‐dimethylene) photoisomers

The bi(anthracene‐9,10‐dimethylene) photoisomer has remarkably long C–C single bonds. To examine the lengthening of the C–C bond, we propose a novel procedure for quantitatively analyzing orbital interactions in a molecule at the level of the ab initio molecular orbital method. In this procedure, we can cut off the specific through‐space/bond interactions in a molecule by artificially increasing the absolute magnitude of the exponents in a Gaussian function. Then, the spatial orbital interactions were perfectly cut off, and, each term that makes up the total energy, that is, the nuclear–electron attractions, the electron–electron repulsions, and the nuclear–nuclear repulsions cancel each other. Several model molecules of the photoisomer were analyzed by this procedure. It was found that the orbital interaction between the p orbital on the benzene ring and the σ* orbital on the C–C bond in question, σ→σ* electron transfer through π orbital, weakens the C–C bond efficiently when these orbitals were located in the “periplanar” conformation. © 2001 John Wiley & Sons, Inc. Int J Quantum Chem, 2001     

Preparation of α-trialkylsilyl ketones from α-phenylseleno derivatives via their silyl enol ethers

On treatment with metallic lithium in the presence of dimethylaminonaphthalene, trialkylsilyl enol ethers of α-phenylseleno ketones were converted into the corresponding α-trialkylsilyl ketones in good yields.     

A potentiometric microbial sensor based on immobilized escherichia coli for glutamic acid

The sensor consists of immobilized E. coli (which contains glutamate decarboxylase) and a carbon dioxide gas-sensor. Continuous introduction of sample solution into a flow system incorporating the sensor gives a potential which increases until a steady state is reached after 5 min. Measurements can also be made with only a 1- or 3-min introduction period with little loss of sensitivity. Calibration plots of mV measurements vs. logarithmic glutamic acid concentration are linear in the range 100–800 mg l^-1. The sensor is highly selective, stable and reproducible. It has been applied to the determination of glutamic acid in fermentation broths.     

Facile synthesis of polyamide dendrimers from unprotected AB2 building blocks

[structure: see text]. A fast, inexpensive, and highly efficient synthesis of aromatic polyamide dendrimers without the need for protection and deprotection steps has been developed. Dendrons and third-generation polyamide dendrimers were easily prepared by a convergent approach involving activation of a focal point with thionyl chloride, followed by condensation with unprotected AB2 building blocks.     

Mesoscopic structure and properties of liquid crystalline mesophase pitch and its transformation into carbon fiber

The history and present state of the art in the chemistry of mesophase pitch, which is an important precursor for carbon fiber and other high-performance industrial carbons, are reviewed relative to their structural properties. The structural concepts in both microscopic and macroscopic views are summarized in terms of the sp(2) carbon hexagonal plane as a basic unit common to graphitic materials, its planar stacking in clusters, and cluster assembly into microdomains and domains, the latter of which reflect the isochromatic unit of optical anisotropy. Such a series of structural units is described in a semiquantitative manner corresponding to the same units of graphitic materials, although the size and stacking height of the hexagonal planes (graphitic sheets) are very different. Mesophase pitch is a liquid crystal material whose basic structural concepts are maintained in the temperature range of 250 to 350 degrees C. The melt flow and thermal properties are related to its micro- and mesoscopic structure. The structure of mesophase-pitch-based carbon fiber of high tensile strength, modulus, and thermal conductivity has been formed through spinning, and has inherited the same structural concepts of mesophase pitch. Stabilization settles the structure in successive heat treatments up to 3000 degrees C. Carbonization and graphitization enable growth of the hexagonal planes and their stacking into units of graphite. Such growth is governed and controlled by the alignment of micro- and mesoscopic structures in the mesophase pitch, which define the derived carbon materials as nanostructural materials. Their properties are controlled by the nanoscopic units that are expected to behave as nanomaterials when appropriately isolated or handled.     

Thermal analysis graphite intercalation compounds with dichlorides of some d-elements: A.S. Skoropanov,G.S. Petrov,A.A. Vecher,Yu.N. Novikov and M.E. Vol'pin,Thermochim. Acta, 90 (1985) 339-342

Kinetic and thermodynamic aspects of the axial base dissociation of solid Co(salen) (X-py) complexes, X = H (1), 3-Me (2), 4-Me (3), 3,4-Me₂ (4), 3,5-Me₂ (5), 3-NH₂ (6), 3-Cl (7), 3-CN (8), 4-CN (9), have been investigated by means of TG-DSC and isothermal weight-loss measurements. These adducts endothermically dissociate the axial base giving rise to the oxygen-active Co(salen) complex. The axial base dissociation reactions fit the contracting disc equation and the kinetic compensation effect is observed for all the adducts excepting Adducts 4–6. For the remaining adducts the kinetic and thermodynamic stabilities of the Co-(X-py) bond are found to increase linearly with increasing Hammett's substitution constants of X except for Adducts 3 and 9. These results are discussed in terms of the σ and π interactions between cobalt(II) and substituted pyridine. Factors dominating the kinetic bond stability are briefly discussed.     

DNA cleavage reaction of antitumour antibiotic, kapurimycin A3, with deoxytetranucleotide d(CGCG)2

Kapurimycin A3 (kap A3, 1 ), an antitumour antibiotic, alkylates N7 of guanine₂ (G₂) and G₄ of d(C₁G₂C₃G₄)₂ to produce their covalent adducts 2 (64 %) and 3 (7.0 %), respectively. Heating at 90 °C for 5 min degraded both adducts to kap A3 - G adduct (5) with the concurrent release of their respective abasic-site containing oligomers 4 and 6.