掺杂Eu2O3的SrTiO3及SnO2光致发光

用具有大能隙的本征半导体(SrTiO₃及SnO₂)粉末作本体,分别掺杂1%(原子百分数)的Eu₂O₃;所得物质表现出Eu³⁺离子的线发射光谱特性,但相对发光强度及光谱形状有相当大的变化。X射线衍射结构分析显示Eu³⁺在SrTiO₃晶格里是处在间隙位置,而它在SnO₂晶格里则形成新物相Eu₂Sn₂O₇。     

Phase Relations at 1500°C in the Ternary System ZrO2–Gd2O3–TiO2

Phase relations at 1500°C in the ternary system ZrO₂–Gd₂O₃–TiO₂ have been determined by the powder X-ray diffraction of samples prepared by standard solid state reaction. A large area of this ternary oxide system centered on the Gd₂Ti₂O₇–Gd₂Zr₂O₇ join was shown to exhibit the pyrochlore and defect fluorite structures. The pyrochlore structure was observed for stoichiometries as far from the ideal M₄O₇ as M₄O_6.7 and M₄O_7.4, although the degree of disorder seemed much higher at these stoichiometries. On further deviation from the ideal M₄O₇ stoichiometry a smooth transition to fluorite average structure was observed for Zr-rich compositions. None of the other binary phases were observed to show significant extent of solid solution into the ternary region.     

Electrical characterization of highly Titania doped YSZ

The defect fluorite region of the ternary system ZrO₂-Y₂O₃-TiO₂ encompasses compositions which offer both, good electronic and oxygen ion conductivity which enable good catalytic activity for the direct oxidation of methane in a solid oxide fuel cell (SOFC). The electrical properties of compositions Y_xTi_yZr_1−(x+y)O_2−x/2 (with x=0.15, 0.2, 0.25 and y=0.15, 0.18) were characterised in order to find the composition with highest ionic and electronic conductivity. High titanium dopant concentrations (Y) of 15 and 18 atom%, near the solubility limit of Ti⁴⁺ in the fluorite structure, have been introduced to achieve a high electronic conductivity at low oxygen partial pressure. The yttrium content x has been varied between 15 and 25 atom% to find the fluorite composition with the highest ionic conductivity for each titanium level. In the pO₂-range from 0.21 to 10⁻¹³ atm the conductivity is predominantly ionic and constant over that range. The maximum ionic conductivity is 0.01 Scm⁻¹ for the compositions, which contain 15 atom% yttrium. Substantial electronic conductivity is introduced into the system at low oxygen pressures below 10⁻¹³ atm via reduction of Ti⁴⁺ ions to Ti³⁺. The maximum electronic conductivity of 0.2 Scm⁻¹ at 930 °C has been measured for a sample with 18 atom% titanium. The slope of all log(σ) vs. log(pO₂) plots follows a pO ₂ ^−1/4 -dependence. Paper presented at the 5th Euroconference on Solid State Ionics, Benalmádena, Spain, Sept. 13–20, 1998.     

Proton conductivity of Al(H2PO4)3–H3PO4 composites at intermediate temperature

Composites of Al(H₂PO₄)₃ and H₃PO₄ were synthesised by soft chemical methods with different Al/P ratios. The Al(H₂PO₄)₃ obtained was found to have a hexagonal symmetry with parameter a = 13.687(3)Å, c = 9.1328(1)Å. The conductivity of this material was measured by a.c. impedance spectroscopy between 100 °C and 200 °C in different atmospheres. The conductivity of pure Al(H₂PO₄)₃ in air is in the order of 10^? 6–10^? 7 S/cm between 100 and 200 °C. For samples containing small excess of H₃PO₄, much higher conductivity was observed. The impedance responses of the composites were found to be similar with AlH₂P₃O₁₀·nH₂O under different relative humidity. The conductivity of Al(H₂PO₄)₃–H₃PO₄ composite with Al/P = 1/3.5 reached 6.6 mS/cm at 200 °C in wet 5% H₂. The extra acid is found to play a key role in enhancing the conductivity of Al(H₂PO₄)₃–H₃PO₄ composite at the surface region of the Al(H₂PO₄)₃ in a core shell type behaviour. 0.7% excess of H₃PO₄ can increase the conductivity by three orders of magnitude. These composites might be alternative electrolytes for intermediate temperature fuel cells and other electrochemical devices. Conductivity (9.5 mS/cm) changed little, when the sample was held at 175 °C for over 100 h as the conductivity stabilised.     

1H(17F,α)14O反应截面测量

14O （α,p）17F是天体X射线暴中重要的突破反应。本工作通过厚靶方法测量其逆反应1H （17F,α）14O的反应截面来研究这一关键反应。本实验工作是在日本东京大学原子核科学研究中心（CNS）的低能次级束流线（CRIB）上完成的,后续的扣除本底实验是在兰州放射性束流线（RIBLL1）上完成的。CRIB实验是通过2H （16O,n）17F转移反应产生17F次级束,经过CRIB分离提纯之后,利用该次级束轰击氢气靶。在氢气靶后布置了三套望远镜探测器系统,用以探测不同实验角度的反冲α粒子,在数据处理的过程中经过动力学重构后得到了1H （17F,α）14O反应在质心系能区E_c.m.=2.7~3.4 MeV的反应截面。实验结果在3 MeV以上的高能区与前人的薄靶实验数据是一致的,在低能区本工作获得了新的实验数据,倾向于支持干涉相消的理论预言结果。The 14O(α, p)17F reaction is one of the important breakout reactions in type I X-ray burst. This work reported a new cross section measurement of its reverse reaction of 1H(17F,α)14O. The experiment was performed using the CNS radioactive ion beam separator (CRIB), located at the Center for Nuclear Study (CNS), the University of Tokyo. The sequent background measurement was carried out at Radioactive Beam Line in Lanzhou (RIBLL1). 17F beam was produced via the transfer reaction of 2H(16O, n)17F, subsequently separated and purified by CRIB and bombarded a thick hydrogen H₂ gas target. The recoiling α particles were measured by three △E-E silicon telescopes at three different angles. The total cross sections of 1H(17F,α)14O have been derived at E_c.m.=2.7~3.4 MeV based on an isotropic angular distribution assumption. Our results are consistent with the previous ones in the energy region of E_c.m.>3 MeV, and we also obtained some new data in the low energy region, which partly support the destructive interference between the direct and resonant reaction mechanism predicted by the theory.     

Preparation of thin films using the tape-casting process for use in the solid oxide fuel cell

Solid oxide fuel cells (SOFCs) produce electricity by electrochemically combining hydrogen and oxygen to give water. They operate at high temperatures (typically 1000 °C) allowing natural gas (hydrogen source) to be reformed in the cell rather than in an external reformer, reducing cost. Comparison with current electrical power generation systems, show SOFCs to have increased efficiencies, reduced NO_x and SO_x emissions and improved reliability promising a viable future alternative for electricity production. Thin ceramic films to less than 200 μm are necessary for reduced all resistance. Tape casting is one method for production of thin ceramic (or metallic) films. In this paper, tape casting was used to produce both dense and porous thin films of 8-mol% Yttria stabilised Zirconia (YSZ). The films were fired both separately and together in a monolithic multi-layered block in order to determine the feasibility of using this method for the production of all components of the SOFC. The effects of organic content, addition of pore-forming agents and firing temperature on the microstructure of the films were investigated. Each individual layer produced was between 40–60 μum thick, with the highest density being>97% and the highest porosity obtained at 30% (produced by addition of a pore former). No de-lamination was observed upon heating the multi-layers. Paper presented at the 8th EuroConference on Ionics, Carvoeiro, Algarve, Portugal, Sept. 16–22, 2001.     

Synthesis and electrical characterisation of different doped magnesium titanates

The synthesis and characterization are reported for the cubic spinel titanate Mg_(2−x)Ni_xTiO₄ (x≤0.25) and Mg_(2−x)Mn_xTiO₄ (x≤1). Single phase samples were observed for Mg_(2−x)Ni_xTiO₄ and with x≤0.4 for Mg_(2−x)Mn_xTiO₄. AC measurements were carried out on four different compositions (x=0.01, 0.03, 0.04 and 0.15) in the Mg_(2−x)Ni_xTiO₄ series and for Mg_1.9Mn_0.1TiO₄. For all these compounds, increasing conductivity with temperature and Arrhenius conductivity dependence are observed, the activation energy is around 0.28 eV for the Ni compounds and is 0.184 eV for Mg_1.9Mn_0.1TiO₄. The DC conductivity was recorded over a range of oxygen partial pressures (10⁻¹⁹ to 1 atm) at 930 °C. The Mg_(2−x)Ni_xTiO₄ compounds show a n-type behaviour whereas the Mg_(2−x)Mn_xTiO₄ show a p-type behaviour at high p(O₂) and n-type at low p(O₂). The stability under reduced conditions was checked and discussed for the different synthesized compounds. Paper presented at the 5th Euroconference onSolid State Ionics, Benalmádena, Spain, Sept. 13–20, 1998.     

Characterization of YSr2Fe3O8 − δ as electrode materials for SOFC

YSr₂Fe₃O_8 − δ was prepared by traditional solid state reaction method and characterized by X-ray diffraction, ac impedance, dc conductivity, dilatometry and thermogravimetric analysis for possible use in solid oxide fuel cells (SOFCs). YSr₂Fe₃O_8 − δ crystallizes with tetragonal symmetry in the space group P4/mmm and found to be stable at high temperatures under H₂ and air. Four probe dc electrical conductivity measurements show that the conductivity increases up to 745 K and then decreases with temperature; the highest conductivity σ_745K = 43.5 S cm^− 1. The n-type conductivity at low oxygen partial pressure (pO₂) changes to p-type at high pO₂. Polarization behavior was investigated measuring the ac impedance response in symmetrical cell arrangements in air with YSZ and GDC electrolytes. Cathodic area specific resistance (ASR) varies with firing temperature. The lowest area specific resistance was observed with a GDC electrolyte fired at 1000 °C. In case of YSZ, ASR increases and in case of GDC, ASR decreases in air when electrode firing temperature decreases. At 800 °C ASRs are 0.20 Ω cm² and 0.65 Ω cm² with GDC and YSZ electrolytes, respectively, in air. Fuel cell measurements with symmetrical electrodes were performed using a thin YSZ electrolyte under H₂ at anode and air at cathode, show that the power density is about 0.035 W/cm² at 900 °C.     

Loudness perception and frequency discrimination in subjects with steeply sloping hearing loss: possible correlates of neural plasticity.

Loudness functions and frequency difference limens (DLFs) were measured in five subjects with steeply sloping high-frequency sensorineural hearing loss. The stimuli were pulsed pure tones encompassing a range of frequencies. Loudness data were obtained using a 2AFC matching procedure with a 500-Hz reference presented at a number of levels. DLFs were measured using a 3AFC procedure with intensities randomized within 6 dB around an equal-loudness level. Results showed significantly shallower loudness functions near the cutoff frequency of the loss than at a lower frequency, where hearing thresholds were near normal. DLFs were elevated, on average, relative to DLFs measured using the same procedure in five normally hearing subjects, but showed a local reduction near the cutoff frequency in most subjects with high-frequency loss. The loudness data are generally consistent with recent models that describe loudness perception in terms of peripheral excitation patterns that are presumably restricted by a steeply sloping hearing loss. However, the DLF data are interpreted with reference to animal experiments that have shown reorganization in the auditory cortex following the introduction of restricted cochlear lesions. Such reorganization results in an increase in the spatial representation of lesion-edge frequencies, and is comparable with the functional reorganization observed in animals following frequency-discrimination training. It is suggested that similar effects may occur in humans with steeply sloping high-frequency hearing loss, and therefore, the local reduction in DLFs in our data may reflect neural plasticity.     

Index summation in real time statistical field theory

We have written a Mathematica program that calculates the integrand corresponding to any amplitude in the closed-time-path formulation of real time statistical field theory. The program is designed so that it can be used by someone with no previous experience with Mathematica. It performs the contractions over the tensor indices that appear in real time statistical field theory and gives the result in the 1-2, Keldysh or RA basis. The program treats all fields as scalars, but the result can be applied to theories with dirac and lorentz structure by making simple adjustments. As an example, we have used the program to calculate the ward identity for the QED 3-point function, the QED 4-point function for two photons and two fermions, and the QED 5-point function for three photons and two fermions. In real time statistical field theory, there are seven 3-point functions, 15 4-point functions and 31 5-point functions. We produce a table that gives the results for all of these functions. In addition, we give a simple general expression for the KMS conditions between n-point green functions and vertex functions, in both the Keldysh and RA bases. PACS 11.10.Wx; 11.15.-q