Potentiometric titration of hydrogen peroxide with an electropolished stainless steel electrode

The preparation and use of a stainless steel indicator electrode in the accurate potentiometric titration of aqueous hydrogen peroxide are described. The results agree excellently with those obtained by a standard colorimetric weight-titration procedure. The nature of the titration curves, potential changes and the factors affecting them are discussed. Rapid potentiometric titrations directly to the equivalence-point potential are possible, owing to the nature of the titration curve.     

Diffusion-controlled vinyl polymerization. I. The gel effect

It is well known that the reaction rate and molecular weight of vinyl polymers can change markedly during the course of polymerization and that these changes are due to the influence of diffusion on the termination reaction. The chain length dependence of the termination rate constant has been considered in this work and has resulted in a general method of treating the polymerization kinetics and molecular weight distribution. This method is independent of the form of the chain length dependency and is capable of dealing with both disproportionation and recombination modes of termination. A specific model for the termination rate constant with chain length dependence is proposed and is based on free volume theory and entanglement coupling. Master curves for the characteristics of the reaction rate and molecular weight distribution are presented with the application of this model.     

Double-layer effects on simple electrode reactions III. The reduction of Eu3+ and Cr3+ in the presence of thiocyanate anions. Evidence for ligand bridging

The rates of reduction of Eu³⁺ and Cr³⁺ have been measured in mixed perchlorate + thiocyanate electrolytes at constant ionic strength, using low concentrations of thiocyanate to minimize its association with the cationic reactants. The effect of adsorbed thiocyanate anions on the reduction kinetics of Cr³⁺ resembled those produced by iodide and bromide on both Cr³⁺ and Eu³⁺. However, thiocyanate exhibited an unusual catalytic effect on the reduction of Eu³⁺ which was identified as arising from a reaction pathway involving thiocyanate-bridging between the mercury surface and the Eu³⁺. The diagnostic criteria used to support the proposed mechanism included analysis of the rate—potential behavior and of the effects of competitively adsorbed iodide ions upon the reduction rates.     

Comparison of the structural and chemical composition of giant T-even phage heads.

A study has been made of the structure of the capsids of T4D giant phage produced from mutants in gene 23 and temperature-sensitive mutants in gene 24, and T4D and T2L giant phage formed by the addition of L-canavanine followed by an Larginine chase in the growth medium. All the giant phage capsids have been shown to be built according to the same geometrical architecture. This consists of a near-hexagonal surface net, lattice constant 129.5 A, folded into a left-handed T = 13 prolate icosahedron elongated along one of its fivefold symmetry axes. Their only apparent difference from wild-type T-even phage capsids is their abnormally elongated tubular part. A comparison of the capsomere morphologies and protein compositions of the giant phage capsids showed that all T4D giants are identical but differ from T2L: The T4D capsomere has a complex (6 + 6 + 1)-type morphology, whereas the T2L has a simple 6-type. T2L phage, however, lack two capsid proteins, "soc" and "hoc", present in T4D. The difference in capsomere morphology can therefore be related to the difference in the protein compositions of these two phage. Possible differences between the initiation and means of length regulation of giant phage heads and the aberrant polyheads are discussed.     

Spectrophotometric determination of germanium with Catechol Violet and cetyltrimethylammonium bromide

A ternary complex between germanium, Catechol Violet (CV) and cetyltrimethylanunoniuni bromide is proposed for the determination of germanium. The stoichiometric ratio Ge:CV is 1:2. Beer's law is obeyed from 0.1 to 1.0 ppm of Ge. The method is highly selective. Interference from Sn(IV), Fe(III), Bi(III), Cr(VI), Mo(VI), V(V) and Sb(III) in mg amounts is eliminated by extracting the germanium into carbon tetrachloride from 9M HC1 and then stripping into water before the photometric determination.     

Cyclobutane polymers from acrylonitrile dimer

A wide variety of polyesters and polyamides was prepared from 1,2- and 1,3-disubstituted cyclobutane derivatives. In general, polyamides containing the trans-disubstituted cyclobutane ring were crystalline. Polyesters containing predominantly the trans-isomer tended to be crystalline but those containing mixtures of cis-trans isomers were amorphous. Mechanical properties have been determined wherever possible. Appreciable yields of cyclic dimers were isolated during the preparation of certain polyesters. These cyclic dimers readily polymerized when treated with dibutylzinc. Examination of acrylonitrile dimer (1,2-dicyanocyclobutane) by gas chromatography failed to reveal the presence of any 1,3-dicyanocyclobutanes.     

Double asymmetric induction in benchrotrene derivatives

Attachment of a Cr(CO)₃ moiety to one of the aromatic rings in rigid diaryl ketones of very low prochirality followed by addition of a chiral and optically pure reagent leads to satisfactory asymmetric induction ~40%. Asymmetric induction is smaller in the case of acyclic systems.     

Experimental (NMR) and Computational (MD) Studies on the Inclusion Complexes of 1-Bromoadamantane with alpha-, beta-, and gamma-Cyclodextrin

The inclusion complexes between the most commonly used cyclodextrins (alpha-, beta-, and gamma-CD) and 1-bromoadamantane were prepared and studied experimentally by NMR methods and by molecular dynamics simulations (AMBER force field) with solvation. The NMR results suggest host/guest ratios of 2:1, 1:1, and 1:1 for the complexes with alpha-, beta-, and gamma-cyclodextrin, respectively, as well as defined geometries for the complexes. Averaged geometrical data from the molecular dynamics simulations agree with the complexation geometries deduced experimentally.     

Synthesis of enantiomerically enriched allenes by (-)-sparteine-mediated lithiation of alkynyl carbamates

[reaction: see text]. The alpha-deprotonation of alkynyl carbamates 3 with the chiral base (-)-sparteine (4)/n-butyllithium, transmetalation with ClTi(O(i)()Pr)3, and subsequent substitution with an aldehyde results in the formation of enantioenriched 4-hydroxyallenyl carbamates 11. Stereoselection is determined by dynamic resolution of the lithium/(-)-sparteine complexes by selective crystallization.