John’s Ellipsoid and the Integral Ratio of a Log-Concave Function

We extend the notion of John’s ellipsoid to the setting of integrable log-concave functions. This will allow us to define the integral ratio of a log-concave function, which will extend the notion of volume ratio, and we will find the log-concave function maximizing the integral ratio. A reverse functional affine isoperimetric inequality will be given, written in terms of this integral ratio. This can be viewed as a stability version of the functional affine isoperimetric inequality.     

Short Loop Decompositions of Surfaces and the Geometry of Jacobians

Given a Riemannian surface, we consider a naturally embedded graph which captures part of the topology and geometry of the surface. By studying this graph, we obtain results in three different directions.     

Al2O3/K2O-containing non-stoichiometric lithium disilicate-based glasses

The crystallisation kinetics of experimental glasses in 3 different systems: (A) Li₂O–SiO₂, (B) Li₂O–Al₂O₃–SiO₂ and (C) Li₂O–K₂O–Al₂O₃–SiO₂ were studied under non-isothermal conditions. The DTA results revealed a stronger tendency to crystallisation of binary compositions in comparison to the ternary and quaternary compositions comprising Al₂O₃ and K₂O which present the lower crystallisation, i.e. the crystallisation propensity follows the trend A > B > C. The devitrification process in the Li₂O–SiO₂ and Li₂O–Al₂O₃–SiO₂ systems began earlier and the rate was higher in comparison to that of glasses in the quaternary Li₂O–K₂O–Al₂O₃–SiO₂ system. Thus, addition of Al₂O₃ and K₂O to glasses of Li₂O–SiO₂ system was demonstrated to promote glass stability against crystallisation. However, the activation energy for crystallisation was shown to depend also on the SiO₂/Li₂O ratio with the binary system showing a decreasing trend with increasing SiO₂/Li₂O ratio, while the opposite tendency was being observed for compositions with added Al₂O₃ and K₂O.     

Low‐Level Laser Therapy Restores the Oxidative Stress Balance in Acute Lung Injury Induced by Gut Ischemia and Reperfusion

It remains unknown if the oxidative stress can be regulated by low‐level laser therapy (LLLT) in lung inflammation induced by intestinal reperfusion (i‐I/R). A study was developed in which rats were irradiated (660 nm, 30 mW, 5.4 J) on the skin over the bronchus and euthanized 2 h after the initial of intestinal reperfusion. Lung edema and bronchoalveolar lavage fluid neutrophils were measured by the Evans blue extravasation and myeloperoxidase (MPO) activity respectively. Lung histology was used for analyzing the injury score. Reactive oxygen species (ROS) was measured by fluorescence. Both expression intercellular adhesion molecule 1 (ICAM‐1) and peroxisome proliferator‐activated receptor‐y (PPARy) were measured by RT‐PCR. The lung immunohistochemical localization of ICAM‐1 was visualized as a brown stain. Both lung HSP70 and glutathione protein were evaluated by ELISA. LLLT reduced neatly the edema, neutrophils influx, MPO activity and ICAM‐1 mRNA expression. LLLT also reduced the ROS formation and oppositely increased GSH concentration in lung from i‐I/R groups. Both HSP70 and PPARy expression also were elevated after laser irradiation. Results indicate that laser effect in attenuating the acute lung inflammation is driven to restore the balance between the pro‐ and antioxidants mediators rising of PPARy expression and consequently the HSP70 production.     

Selenides and diselenides containing oxadiazoles: a new class of functionalised materials

A simple and efficient procedure for the synthesis of a new class of organoselenium liquid crystal compounds was developed. The coupling of aryl bromides with elemental selenium was catalysed using copper oxide nanopowder in the presence of potassium hydroxide employing dimethyl sulfoxide as the solvent. This is the first report of the synthesis and characterisation of liquid crystal-based diselenides. Their mesophases were characterised by polarising optical microscopy and differential scanning calorimetry. Compounds 1, 2 and 4b exhibited the smectic A phase. In addition, these compounds showed weak blue fluorescence in solution (λ_{max. em.} 350–405 nm) and a Stokes shift of around 90 nm.     

The BIOREMA project—part 3: International interlaboratory comparison for bio-ethanol test methods

The main objective of the reference materials for biofuel specifications (BIOREMA) project is the development of two test materials (one bio-ethanol material and one biodiesel material) with well-established reference values. Of a series of three papers, this part describes the material preparation, homogeneity study, stability study, and characterisation of the bio-ethanol material. The test material thus obtained was used in an interlaboratory comparison (ILC) to assess current practices and comparability amongst laboratories providing bio-ethanol testing services. Only 13 participants provided data, resulting in a small dataset for evaluation. Further, it appeared that for a number of laboratories, there was not sufficient material for the determination of all requested parameters. In most cases, as far as the data permit, it can be concluded that the consensus values (based on participant’s results) are in good agreement with the reference or the BIOREMA values (obtained by NMIs participating in the project). For three parameters, namely ethanol content, water content, and density, there is good agreement between the reference and consensus values. For these parameters, the reproducibility standard deviation is close to, or even smaller than, the expanded uncertainty associated with the reference value. A number of parameters show very poor reproducibility, for example, pH_e, electrolytic conductivity, and acidity. The same applies to sodium and copper content, which are very low and therefore challenging parameters to measure accurately. The results of the ILC underpin the need for certified reference materials and demonstrate the requirement for more robust quality control to improve the precision and trueness of the results from testing laboratories.     

UHPLC-DAD Characterization of Origanum vulgare L. from Atacama Desert Andean Region and Antioxidant,Antibacterial and Enzyme Inhibition Activities

The Lamiaceae family is an important source of species among medicinal plants highly valued for their biological properties and numerous uses in folk medicine. Origanum is one of the main genera that belong to this family. The purpose of the study was to determine the phenolic composition of the Origanum vulgare extract and evaluate the antimicrobial, antioxidant, and inhibitory activities of this species that grows in the Andean region of the Atacama Desert. High-performance liquid chromatography was performed to determine the main phenols. Rosmarinic acid was identified as the predominant phenolic compound in this species (76.01 mg/100 g DW), followed by protocatechuic acid, which to our knowledge, no previous study reported similar concentrations in O. vulgare. The oregano extract exhibited a content of total phenolic (3948 mg GAE/100 g DW) and total flavonoid (593 mg QE/100 g DW) with a higher DPPH antioxidant activity (IC₅₀ = 40.58 µg/mL), compared to the same species grown under other conditions. Furthermore, it was found to inhibit α-glucosidase activity with an IC₅₀ value (7.11 mg/mL) lower than acarbose (129.32 mg/mL). Pseudomonas syringae and Pantoea agglomerans (both MIC 0.313 mg/mL and MBC 1.25 mg/mL) were the bacteria most susceptible to oregano extract with the lowest concentration necessary to inhibit bacterial growth. These results open the door for the potential use of this plant to manage chronic diseases, and they expand the knowledge of the species cultivated in arid environmental conditions.     

Mitigating heat dissipation in Raman lasers using coherent anti-stokes Raman scattering

We present a novel technique that intrinsically mitigates the quantum-defect heating in Raman lasers. The basic principle of this so-called "coherent anti-Stokes Raman scattering (CARS)-based heat mitigation" is to suppress the phonon creation in the Raman medium by increasing the number of out-coupled anti-Stokes photons with respect to the number of out-coupled Stokes photons. We demonstrate with the aid of numerical simulations that for a hydrogen and a silicon Raman laser, CARS-based heat mitigation efficiencies of at least 30% and 35%, respectively, can be obtained.     

Ionic Organic Film Sensor for Determination of Phenolic Compounds

This paper describes the development of a new sensor based on an ionic organic film. The amphiphilic molecule, 4‐[(4‐decyloxyphenyl)‐ethynyl]‐1‐methylpyridinium iodide (10PyI), which has liquid‐crystalline properties, was synthesized and applied in the construction of a GCE/10PyI sensor. Analytical parameters for caffeic acid, repeatability (4.8 %), reproducibility (2.8 %), linearity (two ranges: 9.9×10^?7 to 3.8×10^?5 mol L^?1 and 4.7×10^?5 to 9.9×10^?5 mol L^?1) and detection limits (9.0×10^?7 mol L^?1 and 8.7×10^?6 mol L^?1), were determined. The method was successfully applied in the determination of total phenolic compounds (TPC) in mate herb extracts.