Spectral tuning of InGaAs/GaAs quantum dot infrared photodetectors with bandpass guided‐mode resonance filters

Quantum dot infrared photodetectors can be coupled with micro‐structured filters to create narrowband sensors. Guided‐mode resonance filters based on a high‐index dielectric slab can exhibit bandpass characteristics that are suitable for monolithic integration with focal‐plane arrays. Here, patterned Ge filters were integrated with InGaAs/GaAs quantum dot detectors to linearly tune their 77 K photoresponse peaks from 5.6 µm to 6.2 µm. The dark current was not influenced by these filters but the ability to narrow the photoresponse linewidth was limited by substrate scattering, which is often encountered with front‐side illumination architectures. (© 2014 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)     

气体开关抖动对单模块快脉冲直线型变压器驱动源输出特性的影响

分析了快脉冲直线型变压器驱动源(FLTD)气体开关触发击穿延时的分布规律,利用MAT-LAB软件生成随机序列模拟开关击穿延时和抖动,在FLTD简化二阶电路的基础上,利用MATLAB分析了开关抖动对40个支路并联1 MA,100 ns FLTD模块输出电流脉冲前沿和幅值的影响。模拟计算结果表明:开关理想时,即抖动为0,输出电流峰值为996 kA,峰值时间为90 ns,10%~90%脉冲前沿为54 ns;开关自身抖动与开关之间分散性之和为10 ns时,输出电流脉冲前沿增加约14%,电流峰值下降约2%;开关自身抖动与开关之间分散性之和为20 ns时,输出电流脉冲前沿增加约38%,电流峰值下降约5%。     

环境气体种类对激光烧蚀粒子速度劈裂的影响

采用蒙特-卡罗(Monte Carlo)方法, 模拟了激光烧蚀粒子输运动力学过程, 在环境气体压强为100 Pa的情况下, 研究了环境气体种类(He, Ne, Ar和假想气体等)对烧蚀粒子速度劈裂的影响. 研究结果表明, 在四种环境气体中传输的烧蚀粒子均出现了速度劈裂现象, 形成速度劈裂所需时间按He, Ne, 假想气体和Ar的次序减小. 还研究了环境气体分子的质量和半径对烧蚀粒子速度劈裂的影响, 形成速度劈裂所需时间随环境气体分子半径(或质量)增大而减小. 在假想气体中, 两速度峰强度相等时的强度最小. 结合欠阻尼振荡模型和惯性流体模型, 对劈裂的形成时间进行了解释. 所得结论可为进一步定量研究纳米晶粒生长机理提供基础.     

A novel optical beam splitter based on photonic crystal with hybrid lattices

A novel optical beam splitter constructed on the basis of photonic crystal(PC) with hybrid lattices is proposed in this paper.The band gap of square-lattice PC is so designed that the incident light is divided into several branch beams.Triangular-lattice graded-index PCs are combined for focusing each branch.Computational calculations are carried out on the basis of finite-different time-domain algorithm to prove the feasibility of our design.The waveguide is unnecessary in the design.Thus the device has functions of both splitting and focusing beams.Size of the divided beam at site of full-width at half-maximum is of the order of λ/2.The designed splitter has the advantages that it has a small volume and can be integrated by conventional semiconductor manufacturing process.     

有限自由度系统的定域Lie对称性和守恒量

研究有限自由度系统定域Lie对称性的正问题和逆问题。给出了定域Lie对称性的定义、确定方程、结构方程和守恒量。进一步从定域Lie对称性导出在有限连续群无限小变换下的Lie对称性。最后给出一个例子去说明这些结果。     

用于FED和PDP平板显示高压驱动电路的CMOS器件

在Synopsys TCAD软件环境下,结合中国科学院微电子研究所0.8μm标准CMOS工艺条件对于高压CMOS器件进行了工艺和器件模拟。由于考虑到与标准CMOS工艺的兼容性,高压CMOS器件均采用LDMOS结构;根据RESURF技术,对于器件的漂移区进行了优化。器件模拟结果表明,高压NMOS器件源漏击穿电压为220 V;阈值电压和驱动能力分别为0.8 V和1×10-4A/μm。高压PMOS器件源漏击穿电压为-135 V;阈值电压和驱动能力分别为-9.7 V和1.8×10-4A/μm。高压CMOS器件的研制可为进一步研制FED和PDP平板显示高压驱动电路奠定基础。     

链间耦合对聚合物中双激子态反向极化的影响

从紧束缚模型出发，研究了链间相互作用对双激子态反向极化的影响.结果发现：加链间耦合后，双激子态仍主要局域在一条链中.当简并破缺较小时，反向极化程度随耦合强度的增加大幅提高；当简并破缺较大时，反向极化程度随耦合强度的增加基本不变. 关键词： 反向极化 双激子态 链间耦合     

物联网云平台ZigBee无线通信网络节点设计

随着科学技术的发展,无线通信技术不断成为当今社会的通信方面的主流发展方向;对于一种可以集所有通讯方式的优点为一体,并且可以实现远距离网络通信传输的方式成为现在通讯技术行业的主要研究方向;而文章根据一种基于ZigBee协议的无线网络通信架构进行研究,设计出一种可以满足当今通信需求的硬件平台;其中应用到ZigBee协议中的短距离传输技术和将其与SPI接口连接完成的一种通信技术手段;最后将ZigBee单片机通过USB接口与计算机相连接完成通信无线传输工作;文章中提出了这种平台设计的软件设计方案和硬件设计方案,并且通过软硬件设计,分析出其所具备的优点和未来发展能力;通过对比试验,得出这种无线传播方式有更好的传播效率和节省能源的优势。     

A horn ridge waveguide DFB laser with reduced spatial hole burning for high-speed modulation

In this paper, we propose a DFB laser with a horn ridge waveguide (HRW) to suppress the longitudinal spatial hole burning (LSHB) effect in the lasers cavity, thus to reduce the rolloff at low frequency. The simulation result shows that HRW DFB lasers could significantly suppress the LSHB effect and its modulation bandwidth is increased by 14% comparing with the conventional straight ridge waveguide (RW) DFB lasers when the normalized coupling coefficient (κL) is 3.0. The calculated eye diagrams of HRW DFB lasers under direct 25 Gbps modulation have clearer opening than that of the conventional RW DFB lasers. These superior properties are due to the suppression of the LSHB effect by the HRW structure.     

Variation of the Payne Effect in Natural Rubber Reinforced by Graft-Modified Carbon Black

Carbon black (CB) was modified by liquid grafting and used for natural rubber (NR) reinforcement. Payne effects during NR reinforcement by the graft-modified carbon black (GCB) were analyzed in this paper. The results showed a proportional relationship between filler content and the Payne effect. Rubber compounds with GCB presented weaker Payne effects than their non-modified counterparts. Qualitative analysis of the correlation between filler network structure and filler content was conducted according to the relationship between bound rubber of a rubber compound and shear modulus. The impact of the storage period on the Payne effect was further studied, and the results demonstrated that the longer the storage period of the rubber compound, the stronger the Payne effect tended to be. The mechanisms by which the Payne effects were manifested differed according to the content of the filler in the rubber.