高电压锯齿波聚束器的设计研制

近些年来,使用锯齿波直接形成的方法建造非谐振型聚束器在国内及国际均得到了广泛的应用。由于电子技术及机械加工工艺的飞速发展和更高功率电子管的出现,可以设计出更高指标的聚束器,进而可以有效提高束线的匹配效率及运行稳定度。对兰州重离子加速器源束线新的高电压锯齿波聚束器的研制进行了详细阐述,由于该聚束器具有目前国际同类型设备中最高的电压、频率以及相对苛刻的现场条件限制,故还对设计中所涉及的工程实施方案进行了有效补充和完善。     

Molecular-Dynamics Simulations of Droplets on a Solid Surface

By using a semi-empirical Lennard-Jones embedded-atom-method potential, we study the influence of many-body forces and atomic size mismatch on the wetting behavior of nano droplets on a solid surface. With molecular dynamics simulations, we find that the contact angle decreases with increasing many-body forces. The increase of atomic size mismatch between solid and liquid results in the decrease of contact angles. Our calculation also shows that the interface structure is strongly affected by the interaction between liquid and solid as well as the atomic size mismatch. For weak solid-liquid interaction, the interface layer of the droplet nearest to the solid exhibits a typical simple liquid structure regardless of the size mismatch. For strong solid-liquid interaction, evident ordering in the interface layer is observed for well matched cases.     

Experiment of C-Band Wavelength Conversion in a Silicon Waveguide Pumped by Dispersed Femtosecond Laser Pulse

We experimentally demonstrate the C-band wavelength conversion using four-wave mixing in a 17-mm-long silicon-on-insulator waveguide pumped by a dispersed mode-locked femtosecond laser pulse. The idler can be observed with an incident average pump power lower than 4 dBm, and about 35 nm of conversion bandwidth from 1530nm to 1565nm is measured by using a 1550-nm pump wavelength. The pulse-pumped efficiency is demonstrated to be higher, by more than 22 dB, than the cw-pumped efficiency. The conversion efficiency variations with respect to the pump and signal powers are also investigated.     

Study of lower emittance dedicated synchrotron radiation mode for the BEPCⅡ

In this paper,a dedicated synchrotron radiation （SR） mode for the BEPCⅡ with an emittance of 85 nm has been designed,including the linear lattice,chromaticity correction and dynamic aperture optimization.The emittance of the new mode is about 60% of the previous mode used for routine operation of the BEPCⅡ .The effect of wigglers on the linear lattice was compensated and the total dynamic aperture including the wigglers’ nonlinear effect was estimated.The preliminary commissioning at the end of 2008 and the formal operation with the new mode confirmed its merits.     

低能Co离子注入单晶ZnO的光致发光特性

采用离子注入法研究了Co离子注入ZnO晶体的光致发光效应。 对离子注入后的样品在Ar气保护下进行退火处理, 退火温度为700 ℃, 退火时间为10 min, 在其光致发光谱中观察到了406和370 nm的紫光发射峰。 对比了Co, Cu离子分别注入的ZnO晶体的光致发光谱, 观测到二者的光致发光谱类似。 同时, 研究了Co离子注入剂量对样品发光性质的影响, 结果表明随注入剂量的增加绿色发光中心逐渐向低能边偏移, 分析认为绿色发光中心的偏移与离子注入后ZnO晶体的禁带宽度发生改变相关。 In this paper, ion implantation techniques were used to study the photoluminescence(PL) of the Co implanted crystal ZnO. After Co ion implanted, the samples were annealed at 700 ℃ for 10 min in Ar gas flow. It was observed violet emission peak of 406 and 370 nm in the PL spectrum. The PL spectra of the ZnO crystal samples which were implanted by Co ions and Cu ions, respectively, have been compared and observed that the PL spectrum of the Co implanted ZnO is similar to that of the Cu implanted ZnO. We studied the influence of implantation dose on the PL of the Co implanted ZnO and found that the green luminescence centre shifted with increasing of implantation dose. It is concluded that the shift of the green luminescence centre is related to the change of ZnO band gap which was caused by ion implantation.     

利用近红外光谱检测多层组织血氧饱和度的研究

利用近红外光谱无创检测生物组织血氧饱和状态,是一种极富研究和应用前景的检测技术,在临床检测中被广泛应用.但常规临床检测应用于指端仅反映局部血氧饱和度信息,在使用中具有局限性,信号的可信度也存在质疑.该文提出了一种采用反射式脉搏血氧饱和度检测技术检测生物多层组织氧合状况的新方法,该方法通过调节入射光强以适应解剖学中生物组织多层结构的检测.应用该方法针对手指结构的实验结果表明,随着入射光强的改变,反映血氧饱和状态的光电脉搏波信号有显著变化.结合手指解剖学分析表明,光电脉搏波信号的变化与手指的多层面组织结构相对应,反映不同层面血氧饱和状态.这一特点表明,通过此法可以针对生物组织的多层结构进行测量.     

共面对称条件下Mg原子(e,2e)反应的三重微分截面的计算

采用修正的扭曲波玻恩近似(DWBA)方法,本文计算了共面对称几何条件下电子碰撞Mg(3s2) 原子(e,2e)反应的三重微分截面.理论方法通过引入Gamow因子来表示(e,2e)反应的后碰撞相互作用(PCI).将计算结果与实验结果及标准DWBA计算结果进行了比较,发现PCI效应起着重要的作用.     

利用电导率测量方法研究不同粒径ZnS高压相变过程

利用在金刚石对顶砧上集成的金属电极,对不同粒径的ZnS材料进行了高压原位电导率测量. 粒径为2 μm的体材料ZnS在15 GPa时,电导率迅速增大5个数量级,表明体材料ZnS此时发生了从闪锌矿到岩盐矿的结构相变. 而粒径6 nm的纳米材料ZnS的结构相变压力为21 GPa. 电导率测量结果还表明纳米 ZnS比体材料ZnS还具有更宽的迟滞区间.     

离子色谱测定土壤中Cl-和SO2-4

介绍了离子色谱法测定土壤中Cl-和SO2-4的可行性以及相关的前处理方法,通过一定前处理方法,减少土壤中杂质对测定的干扰和对色谱柱的污染.有效选取提取液的种类和浓度及提取时间,准确测定了土壤中Cl-和SO2-4含量.Cl-和SO2-4的相对标准偏差分别为2.70%、2.89%,检出限分别为0.1950、0.2230μg·mL-1,平均回收率分别为106.7%,95.8%.方法简便,快速、灵敏度高.     

多模光纤模式场群速与相速的关系

为了从理论上统一射线光学和导波光学关于多模光纤中各模式场传播过程中时延的论述,试从介质波导理论出发,根据模式的特征根U随光纤归一化频率R的变化关系,在弱波导近似下导出了描述模式场相速Vp与群速Vg关系的重要结果:Vp*Vg=(c/n1)2。根据这一结果可以得出结论:对于低阶模式,由于相速Vp慢,所以群速快;高阶模式其相速Vp快,所以群速慢。对于给定的光纤,利用射线光学和波导光学进行了带宽估计,2种理论计算结果的一致性,印证了上述关系的正确性。