金银花的毛细管电泳指纹图谱研究

采用毛细管区带电泳法,以50 mmol/L硼砂(含20 mmol/L β-环糊精(CD),用磷酸调pH 8.0)为背景电解质,运行电压12 kV,紫外检测波长254 nm,重力进样15 s（高度8.5 cm）,建立了金银花药材水提取液的毛细管电泳指纹图谱(CEFP)。将13个不同产地的金银花药材供试液的CEFP进行比较,以电泳峰出现率100%计,确定金银花的共有指纹峰为18个。该CEFP具有较好的精密度和重现性,分离效能高且成本低廉。提出了指纹图谱宏观含量相似度R、投影含量相似度C和定量相似度P的概念,可从总体上评价药材化学组分的整体含量情况。从两个方面评价各产地药材与对照CEFP间的总体相似性,合格药材应具备以下两个条件：(1)代表化学成分分布相似性的定性相似度(S)≥0.90;(2)描述药材整体化学成分含量的定量相似度(R,C,P,Q)应在80%～120%。以此二类相似度指标控制金银花的质量,建立了指纹图谱评价的又一新方法。     

Ag@AgBr光催化剂的制备及其可见光催化降解亚甲基蓝反应性能

采用沉积-沉淀及光还原法制备了Ag@AgBr等离子体光催化剂,利用X射线衍射、扫描电镜和紫外-可见漫反射光谱对其进行了表征,并考察了该等离子体光催化剂在可见光(λ420nm)下的催化性能,探讨了催化剂用量、pH值、亚甲基蓝初始浓度、H2O2添加量、循环使用及捕获剂对Ag@AgBr催化性能的影响.结果表明,当亚甲基蓝的初始浓度为10mg/L,催化剂用量为1g/L,pH=9.8时,光照12min后,亚甲基蓝的降解率高达96%,且样品经5次循环使用后活性基本保持不变;而少量H2O2的添加对光催化活性影响不大,过量的H2O2会降低光催化活性;乙二胺四乙酸捕获空穴后比异丙醇捕获·OH后的光催化活性降得更低.同时,对Ag@AgBr等离子体光催化剂可见光降解亚甲基蓝的催化机理进行了分析.     

纳米力学进展(续)

概述2002年度在纳米力学方面的若干新进展.在纳观计算力学方面,讨论了在微结构质流演化算法、纳米结构中应变的量子效应算法、LMPM并行算法等方面的进展.在纳观实验力学范畴,着重介绍了立体刻蚀的微加载系统.然后,我们展述了在纳米晶体力学、纳米管力学和纳米压痕力学等方面的新进展.      

咪唑类氮氧自由基的ESR波谱的酸度相关性-pH自旋探针应用研究之一

根据咪唑类氮氧自由基的结构特性合成了一系列的pH自旅探针,其ESR波谱参数均在一定范围内与介质的酸性呈明显的相关性.可望为较精确地测量化学胶束、细胞等微观体系的pH值开辟一个新的途径.本文研究了灵敏变化的pH范围与取代基的关系,得到了5种自旅探针的ESR参数-pH曲线、pKa值以及Hanmmett相关图,分析了如何通过改变取代基合成出不同pH变化范围并适用于不同生物和化学体系的pH自旅探针,最终达到付诸应用的目的.     

光纤微位移法测量固体线膨胀系数

本文绘出了一种金属固体线膨胀系数的测量方法,即采用光纤位移传感器的方法（光纤微位移法）来测量固体的线膨胀系数．测量了黄铜的线胀系数,分别用逐差法和线性回归法处理了实验数据,并与标准值进行了比较．     

Upconversion fluorescence property of Er/Yb-codoped novel bismuth-germanium glass

Infrared-to-visible upconversion fluorescence property of Er³⁺/Yb³⁺-codoped novel bismuth-germanium glass under 975 nm LD excitation has been studied. Intense green and red emissions centered at 525, 546 and 657 nm, corresponding to the transitions ²H_11/2→⁴I_15/2, ⁴S_3/2→⁴I_15/2, and ⁴F_9/2→⁴I_15/2, respectively, were observed at room temperature. The quadratic dependence of the 525, 546 and 657 nm emissions on excitation power indicates that a two-photon absorption process occurs. The structure of the bismuth-germanium glass has been investigated by peak-deconvolution of FT-Raman spectrum, and the structural information was obtained from the peak wavenumbers. This novel bismuth-germanium glass with low maximum phonon energy (∼750 cm⁻¹) can be used as potential host material for upconversion lasers.     

基于光导开关的Blumlein型PFN能量转换效率

为了驱动低能重复频率高阻抗X光管,采用低感陶瓷电容构建了一套电长度约33.5 ns、阻抗约8 的Blumlein型脉冲形成网络（BPFN）,在匹配负载条件下研究了采用GaAs光导开关（PCSS）作为脉冲输出开关时PCSS工作场强、激光触发能量与能量转换效率的关系。实验表明:PCSS截止场强为3.21～4.94 kV/cm,在工作场强高于20 kV/cm时,截止场强引起的能量损失对能量转换效率的影响不大;PCSS较高的导通电阻是影响PFN能量转换效率的主要因素,随着工作场强、激光触发能量的上升,能量转换效率呈指数上升趋势。     

Influence of annealing temperature on microstructure and optical properties of sol-gel derived tungsten oxide films

Tungsten oxide (WO₃) thin films have been extensively studied for their interesting physical properties and a variety of potential applications in electrochromic devices. In order to explore the possibility of using these in electrochromic devices, a preliminary and thorough study of the optical properties of the host materials is an important step. Based on this, the influence of annealing temperature on the structural, surface morphological, optical and electrochromic properties has been investigated in the present work. The host material, WO₃ films, has been prepared from an ethanolic acetylated peroxotungstic acid sol containing 5 wt.% oxalic acid dehydrate (OAD) by sol-gel technique. The monoclinic structure and textured nature change of the films with the temperature increasing have been investigated by X-ray diffraction analysis. The surface morphology evolution of the films has been characterized by SEM. The shift in absorption edge towards the higher wavelength region observed from optical studies may be due to the electron scattering effects and the optical band filling effect that reveals the crystallization of the film. The amorphous film shows better optical modulation (ΔT = 76.9% at λ = 610 nm), fast color-bleach kinetics (t_c ∼ 4 s and t_b ∼ 9 s) and good reversibility (Q_b/Q_c = 90%), thereby rendering it suitable for smart window applications.     

Encapsulation of nanocrystals with responsive gels for spatial optical identification

A tripeptide (β-AspFF) gelator was designed and synthesised using solid-phase peptide synthesis. The as-prepared gelator formed a stable and clear multi-responsive gel in toluene solution. Encapsulating the quantum dots with β-AspFF effectively increased stability and antioxidisation ability which are beneficial for optical identification.     

Nanocrystalline cellulose/fluorinated polyacrylate latex via RAFT‐mediated surfactant‐free emulsion polymerization and its application as waterborne textile finishing agent

A simple method for nanocrystalline cellulose (NCC)/fluorinated polyacrylate was developed by RAFT‐mediated surfactant‐free emulsion polymerization, in which the nanocomposites formed a core‐shell spherical morphology. The influence of the content of NCC‐g‐(PAA‐b‐PHFBA) (AA was acrylic acid, HFBA was hexafluorobutyl acrylate) on the properties of latex and film were systematically studied. The monomer conversion, the tensile strength, and water–oil repellency of film increased first and then decreased, the latex particle size decreased first and then decreased, when the content of NCC‐g‐(PAA‐b‐PHFBA) increased from 1 to 6 wt %. Elongation at break and thermal stability distinctly decreased when the content of NCC‐g‐(PAA‐b‐PHFBA) gradually increased. XPS showed that the fluorine‐containing groups well concentrated at the film–air interfaces during the annealing process. SEM analysis revealed that the treated fiber had a rugged surface, and the treated fabric had an excellent water repellency. In addition, this green grafting method in water offered a new perspective for the fabrication of exceptional NCC‐based nanocomposites with NCC as the core and also helped to promote the potential applicability of NCC in a range of multipurpose applications. © 2019 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2019 © 2019 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2019, 57, 1305–1314