Speciation of V, Cr and Fe by capillary electrophoresis-bandpass reaction cell inductively coupled plasma mass spectrometry

Capillary electrophoresis-dynamic reaction cell inductively coupled plasma mass spectrometry (CE-DRC-ICP-MS) for the speciation of iron(III/II), vanadium(V/IV) and chromium(VI/III) is described. Two different CE migration modes were employed for separating the six metal ions using pre-capillary complexation. One is counter-electroosmotic mode in which iron(III/II) and vanadium(V/IV) ions were well separated using a 60 cm x 75 microm i.d. fused silica capillary. The voltage was set at +22 kV and a 15 mmol l(-1) tris(hydroxymethyl)aminomethane (Tris) buffer (pH 8.75) containing 0.5 mmol l(-1) ethylenediaminetetraacetic acid (EDTA) and 0.5 mmol l(-1) ortho-phenanthroline (phen) was used as the electrophoretic buffer. The other is co-electroosmotic mode in which chromium(VI/III) ions were well separated while the applied voltage was set at -22 kV and a 10 mmol l(-1) ammonium citrate buffer (pH 7.7) containing 0.5 mmol l(-1) diethylenetriaminepentaacetic acid (DTPA) and 0.01% polybrene was used as the electrophoretic buffer. The mass spectra were measured at m/z 51, 52 and 56 for V. Cr and Fe, respectively. The interfering polyatomic ions of 35Cl16O+, 40Ar12C+ and 40Ar16O+ on 51V+, 52Cr+ and 56Fe+ determination were reduced in intensity significantly by using NH3 as the reaction cell gas in the DRC. The detection limits were in the range of 0.1-0.5, 0.4-1.3 and 1.2-1.7 ng ml(-1) for V, Cr and Fe, respectively. Applications of the method for the speciation of V, Cr and Fe in wastewater were demonstrated. The recoveries were in the range of 92-120% for various species.     

Influence of extended π-conjugation units on carrier mobilities in conducting polymers

Carrier mobilities in thin films of copolymers with repeat units consisting of oligothiophenes bridged by Si atoms are measured over a range of doping levels, where the numbers of thienylenes in the repeat unit are 7, 8, 10, 12, and 14. The mobilities for these polymer films increased with the increase in doping level and the mobility enhancement followed an increasing order of the π-conjugation length. The magnitude of the mobility increase for the Si polymer comprising 14 thiophene units reached ca. 10⁴, implying that this π-conjugation length is almost sufficient to reproduce transport properties of polythiophenes.     

Determination of atrazine, desethyl atrazine and desisopropyl atrazine in environmental water samples using hollow fiber-protected liquid-phase microextraction and high performance liquid chromatography

A new method based on hollow fiber-protected liquid-phase microextraction (LPME) was developed for the simultaneous determination of atrazine, desethyl atrazine and desisopropyl atrazine in environmental water samples. In LPME, analytes were extracted into 1-octanol immobilized in the micropores of a poly(vinylidene fluoride) porous hollow fiber membrane, and back extracted into the acceptor (4 M HCl) filled in the lumen of the hollow fiber. After LPME, the analytes trapped in the acceptor were analyzed with high-performance liquid chromatography after neutralization. The effect of extraction factors such as sample pH, acceptor pH, salinity, extraction time, stirring rate, and humic acid were studied. Under the optimized conditions, the limits of detection and relative standard deviations were respectively in the range of 0.5–1.0 μg L⁻¹ and 3.9–4.7% (n = 5). The proposed method was applied to determine atrazine, desethyl atrazine and desisopropyl atrazine in wastewater and groundwater samples. The three analytes were below the limits of detection, but good relative spiked recoveries over 90.1 ± 5.9% at 5 μg L⁻¹ spiked level were obtained.     

Migration of 99Tc in a Weak Loess Aquifer: A Field Column Experiment

The migration of ⁹⁹Tc in a weak loess aquifer was investigated in-situ with undisturbed aquifer medium columns. The columns were obtained horizontally at a depth of 3236 m in an Underground Research Facility (URF). Quartz containing ³H (HTO) and ⁹⁹Tc (in the form of ⁹⁹TcO₄ ^-) was introduced into one end of the columns and the columns were covered tightly. Aquifer water was introduced into the columns directly from an experimental shaft in the UFR. Effluents from the columns were collected and the activity of ³H and ⁹⁹Tc were determined with a liquid scintillation analyzer. The breakthrough curves of ³H and ⁹⁹Tc indicate that ⁹⁹Tc migrates a little faster than that ³H does in the aquifer.     

Solution chemistry of uranyl ion with iminodiacetate and oxydiacetate: A combined NMR/EXAFS and potentiometry/calorimetry study

The solution chemistry of uranyl ion with iminodiacetate (IDA) and oxydiacetate (ODA) was investigated using NMR and EXAFS spectroscopies, potentiometry, and calorimetry. From the NMR and EXAFS data and depending on stoichiometry and pH, three types of metal:ligand complex were identified in solution in the pH range 3-7: 1:1 and 1:2 monomers; a 2:2 dimer. From NMR and EXAFS data for the IDA system and previous studies, we propose the three complex types are [UO(2)(IDA)(H(2)O)(2)], [UO(2)(IDA)(2)](2)(-), and [(UO(2))(2)(IDA)(2)(mu-OH)(2)](2)(-). From EXAFS spectroscopy, similar 1:1, 2:2, and 1:2 complexes are found for the ODA system, although (13)C NMR spectroscopy was not a useful probe in this system. For the 1:1 and 1:2 complexes in solution, EXAFS spectroscopy is ambiguous because the data can be fitted with either a long U-N/O(ether) value (ca. 2.9 A) suggesting 1,7-coordination of the ligand or a U-C interaction at a similar distance, consistent with terminal bidentate coordination. However, the NMR data of the IDA system suggest that 1,7-coordination is the more likely. The stability constants of the three complexes were determined by potentiometric titrations; the log beta values are 9.90 +/-, 16.42 +/-, and 10.80 +/- for the 1:1, 1:2, and 2:2 uranyl-IDA complexes, respectively, and 5.77 +/-, 7.84 +/-, and 4.29 +/- for the 1:1, 1:2, and 2:2 uranyl-ODA complexes, respectively. The thermodynamic constants for the complexes were calculated from calorimetric titrations; the enthalpy changes (kJ mol(-)(1)) and entropy changes (J K(-)(1) mol(-)(1)) of complexation for the 1:1, 1:2, and 2:2 complexes respectively are the following. IDA: 12 +/- 2, 230 +/- 8; 8 +/- 2, 151 +/- 9; -33 +/- 3, -283 +/- 11. ODA: 26 +/- 2, 198 +/- 12; 20 +/- 2, 106 +/- 8; -24 +/- 2; -219 +/- 8.     

深圳市1408例儿童发中钙,铁,镁含量调查与分析

用火焰原子吸收法检测了深圳市１４０８例１３岁以下儿童发中钙，铁，镁的元素含量，并探讨了元素含量与年龄，性别的关系，结果显示，性别差异有显著意义，钙，镁含量随年龄增长有相似变化。     

Remarkably efficient oxidative coupling of N,N-dialkylarylamines in water mediated by cerium(IV) ammonium nitrate

A highly effective, economical, and environmentally friendly method using of CAN as oxidant and water as solvent for oxidative coupling of N,N-dialkylarylamines was reported.     

Molecular structure and pseudopolymorphism of squamtin A from Annona squamosa

The cyclopeptide, squamtin A (1, formula: C₃₉H₆₀O₁₁N₈S), was found to crystallized in two pseudopolymorphisms, i.e. 1·(H₂O)_3.5 and 1·(H₂O)_3.9. The composition of the amino acids and their linkage sequences are the same. The main differences between the two kinds of crystals lie in the positions and occupancies of the water molecules, the positions of the sulfur atoms and the conformation of the side chains. The absolute configuration of 1 is established by X-ray analysis in combination with the Marfey's analysis of its hydrolysates.     

Determination of panaxadiol and panaxatriol in ginseng and its preparations by capillary supercritical fluid chromatography (SFC).

Capillary supercritical fluid chromatographic (SFC) method has been developed for the determination of panaxadiol and panaxatriol in ginseng and its preparations. 0.1 g ginseng or an appropriate amount of its preparations was hydrolysed by 15% H2SO4 in an ethanol:water (1:1 v/v) solution for 4 h followed by 15% NaOH for 0.5 h. The mixture was extracted by cyclohexane. The cyclohexane extracts were purified by a partition column and concentrated by an adsorption column and then analysed by SFC. Methyltestosterone was used as the internal standard.