Effects of fine fuel droplets on a laminar flame stabilized in a partially prevaporized spray stream

A partially prevaporized spray burner was developed to investigate the interaction between fuel droplets and a flame. Monodispersed partially prevaporized ethanol sprays with narrow diameter distribution were generated by the condensation method using rapid pressure reduction of a saturated ethanol vapor–air mixture. A tilted flat flame was stabilized at the nozzle exit using a hot wire. Particle tracking velocimetry (PTV) was applied to measurements of the droplet velocity; the laminar burning velocity was obtained from gas velocity derived from the droplet velocity. Observations were made of flames in partially prevaporized spray streams with mean droplet diameters of 7 μm and the liquid equivalence ratios of 0.2; the total equivalence ratio was varied. In all cases, a sharp vaporization plane was observed in front of the blue flame. Flame oscillation was observed on the fuel-rich side. At strain rates under 50 s⁻¹, the change in the burning velocity with the strain rate is small in fuel-lean spray streams. In spray streams of 0.7 and 0.8 in the total equivalence ratio, burning velocity increases with strain rates of greater than 50 s⁻¹. However, in spray streams with 0.9 and 1.0 in the total equivalence ratio, burning velocity decreases as the strain rate increases. At strain rates greater than 80 s⁻¹, burning velocity decreases with an increased gas equivalence ratio. The effect of mean droplet diameter, and the entry length of droplets into a flame on the laminar burning velocity, were also investigated to interpret the effect of the strain rate on the laminar burning velocity of partially prevaporized sprays.     

Development of measuring magnetic Compton profiles by grazing incidence geometry

A novel technique of measuring a magnetic Compton profile using the grazing angle geometry against a sample surface (Grazing Incidence Magnetic Compton Profile) has been successively developed. Measurements of a magnetic moment and a magnetic Compton profile are possible for a Fe 200 nm film on a thick glass substrate. The estimated thinnest limit for measurements is 100 nm for a Fe film.     

Voice Analysis of Postlingually Deaf Adults Pre- and Postcochlear Implantation

Objectives

To ascertain whether cochlear implantation (CI), without specific vocal rehabilitation, is associated with changes in perceptual and acoustic vocal parameters in adults with severe to profound postlingual deafness.

Hypothesis

Merely restoring auditory feedback could allow the individual to make necessary adjustments in vocal pattern.

Study Design

Prospective and longitudinal.

Methods

The experimental group composed of 40 postlingually deaf adults (20 males and 20 females) with no previous laryngeal or voice disorders. Participants’ voices were recorded before CI and 6–9 months after CI. To check for chance modifications between two evaluations, a control group of 12 postlingually deaf adults, six male and six female, without CI was also evaluated. All sessions composed of the recording of read sentences from Consensus Auditory-Perceptual Evaluation of Voice and sustained vowel /a/. Auditory and acoustic analyses were then conducted.

Results

We found a statistically significant reduction in overall severity, strain, loudness, and instability in auditory analysis. In vocal acoustic analysis, we found statistically significant reduction fundamental frequency (F0) values (in male participants) and F0 variability (in both genders). The control group showed no statistically significant changes in most vocal parameters assessed, apart from pitch and F0 (in female participants only). On comparing the interval of variation of results between the experimental and control groups, we found no statistically significant difference in vocal parameters between CI recipients and nonrecipients, with the exception of F0 variability in male participants.

Conclusions

The patients in our sample showed changes in overall severity, strain, loudness, and instability values, and reductions in F0 and its variability. On comparing the variation of results between the groups, we were able to prove in our study that implant recipients postlingually deaf adults (experimental group), without specific vocal rehabilitation, differed from nonrecipients (control group) in loudness and F0 variability sustained vowel /a/ in male participants.     

Hard magnetic properties of anisotropic Sm-Fe-N magnets produced by compression shearing method

Anisotropic Sm-Fe-N bulk magnets were produced by the compression shearing method using a hardened steel plate and a tungsten-carbide (WC) plate. It was found that the magnets retained the original Sm₂Fe₁₇N₃ phase structure without any appreciable decomposition of the Sm₂Fe₁₇N₃ phase. The anisotropic Sm-Fe-N bulk magnet produced using a WC plate had a higher density and higher crystallographic alignment of the Sm₂Fe₁₇N₃ phase than that produced using a hardened steel plate, and exhibited high maximum energy products of 228 kJ/m³ with a high coercivity of 0.88 MA/m.     

Efficient sum-frequency generation of continuous-wave single-frequency coherent light at 252 nm with dual wavelength enhancement

Highly efficient frequency conversions were conducted to obtain deep-ultraviolet single-mode coherent light by use of two-stage external cavities. A power of 154 mW at approximately 252 nm was obtained with a conversion efficiency of more than 8% by doubly resonant sum-frequency mixing of 373-nm light from the first-stage conversion and 780-nm light from a single-mode Ti:sapphire laser. The output performance of the deep-ultraviolet light source is sufficient for use in the laser cooling of neutral silicon atoms.     

Development of Non-Halogen Flame Retardant Optical Fiber and Optical Fiber Cord

A non-halogen highly flame-retardant 0.9mm optical fiber and 2.0mm simplex optical cord, which are harmonized with the ecosystem, have been developed. The characteristics of them are presented in this paper.     

Sharp photonic Crystal Defect Modes and Their Response to Ultrashort Optical Pulses

Single photonic crystal defects based on an air-bridge structure were fabricated. We obtained sharp defect modes with quality factors higher than 600 and observed their response to ultrashort optical pulses by utilizing two-photon absorption.     

Spurious Shell Closures in the Relativistic Mean Field Model

Following a previous systematic theoretical study of the ground-state properties of over 7000 nuclei from the proton drip line to the neutron drip line in the relativistic mean field model [Prog. Theor. Phys. 113 （2005） 785], which is in fair agreement with existing experimental data, we observe a few spurious shell closures, i.e. proton shell closures at Z = 58 and Z = 92. These spurious shell closures are found to persist in all the effective forces of the relativistic mean field model, e.g. TMA, NL3, PKDD and DD-ME2.     

Thermal stability of ZnO thin film prepared by RF-magnetron sputtering evaluated by thermal desorption spectroscopy

Thermal stability of sputter deposited ZnO thin films was evaluated by thermal desorption spectroscopy (TDS). Desorption of Zn was mainly observed from the films deposited at low O₂/Ar gas ratio and low RF power. In contrast, O₂ desorption was mainly observed from the films deposited at high O₂/Ar gas ratio and high RF power. The amount of desorbed O₂ from the film increased with increasing the O₂/Ar gas flow ratio and the RF power. Furthermore, the desorption temperature of O₂ increased with increasing the RF power during the deposition. Thermal stability of the ZnO films was controlled not only by the O₂/Ar gas flow ratio, but also applied RF power to the target.