Sonochemically synthesized core-shell structured Au–Pd nanoparticles supported on γ-Fe2O3 particles

A sample of Au–Pd bimetallic nanoparticles supported on γ-Fe₂O₃ was synthesized in a sonochemically one-pot process. The structural analyses of the synthesized sample were performed by the techniques of X-ray Absorption Fine Structure (XAFS), X-ray Diffraction (XRD), Transmission Electron Microscopy (TEM) and UV–vis spectrometry. Results indicated that the synthesized sample formed a core-shell structure in which a gold core was surrounded by a thin palladium shell. The reaction rate constant for the hydrogenation of cyclohexene of the present sample showed higher value than that of Pd nanoparticles supported on γ-Fe₂O₃ and core-shell structured Au–Pd nanoparticles supported on SiO₂. The present sample is a promising catalyst material which has a high catalytic activity.     

A new effect of ultrasonication on the formation of BaTiO3 nanoparticles

A new effect of ultrasonic irradiation on the formation of BaTiO₃ particles was identified. Ultrasonication caused the aggregation of the original 5–10 nm BaTiO₃ particles in the same crystal axis and accelerated the formation of BaTiO₃ particles significantly. Furthermore, narrow size distribution was obtained for the aggregated particles under ultrasonic irradiation.     

An active resonator system for CW-ESR measurement operating at 700 MHz

An active resonator system operating at 700 MHz, which can attain a high Q for CW-ESR measurements of a high loss sample, was developed. This system consisted of a loop-gap resonator (LGR), a receiver coil, an excitation coil, and a phase tunable amplifier. A part of the RF power at the LGR was picked up by the receiver coil, amplified, and irradiated to the LGR again by the excitation coil, which made up a feedback circuit. Because the feedback circuit provided the energy that canceled the loss in the resonator, the Q of the active resonator system increased. When a sample tube (inner diameter, 20 mm; axial length, 31 mm) containing a nitroxide radical and physiological saline solution was placed in the resonator, the Q could be varied from 55 to 4000. It was possible to obtain a Q of the active resonator system with sample that was higher than that of the value of the LGR without a sample in a no-feedback condition. The ESR signal intensity increased up to 7 times with the increase in Q. The sensitivity increased up to 50%, which was a much smaller advance than that of the Q, because the noise level also increased with the increase in signal intensity.     

Micromachining and surface processing of the super-hard nano-polycrystalline diamond by three types of pulsed lasers

Laser beam micromachining was applied to super-hard nano-polycrystalline diamond (NPD) synthesized by the direct conversion of graphite at high pressure and high temperature. Three types of pulsed lasers were tested: nanosecond near-infrared, nanosecond near-ultraviolet, and femtosecond near-infrared lasers. The latter two were also applied for synthetic single crystal of diamond to compare the results with those of the NPD. It was demonstrated that the nanosecond near-infrared laser was the most efficient device for rough shaping of the NPD, while the ultraviolet and femtosecond lasers give satisfactory results for precise surface finishing of it. The properties of the laser-processed surfaces were analyzed by scanning and transmission electron microscopy, laser scanning microscopy, and micro Raman spectroscopy. These analyses demonstrated that the three types of lasers play different and complementary roles, and that their combination is the best suitable solution for micromachining of the hardest diamond into any desired shapes.     

The effect of oxygen vacancy on the oxide ion mobility in LaAlO3-based oxides

The electrical property of (La_1−xSr_x)_1−z(Al_1−yMg_y)O_3−δ (LSAM; x≤0.3, y≤0.15 and z≤0.1) was measured using the DC four-probe method as a function of temperature (500–1000°C) and oxygen partial pressure (1–10⁻²² atm). Among LSAMs, (La_0.9Sr_0.1)AlO_3−δ showed the highest ionic conductivity, σ_i=1.3×10⁻² S cm⁻¹ at 900°C. A simultaneous substitution at A and B sites or A site deficiency is expected to create larger oxygen vacancy and higher ionic conductivity. However, it showed a negative effect. The effect of the vacancy increase did not effect monotonously the ionic conductivity. It was found that the concentration of oxygen vacancy, [V_O], influences not only the oxide ion conductivity, σ_i, but also the mobility, μ_v, of [V_O]. These properties exhibit a maximum at around [V_O]=0.05. With the increase in [V_O], the activation energy, E_a, of the ionic conduction dropped from 1.8 to ca. 1.0 eV at [V_O]=0.05 and became almost constant at [V_O]>0.05. The dependency of the pre-exponential term, μ⁰_v, and E_a on [V_O] was analyzed and their effect on μ_v and σ_i was discussed with respect to crystal structure and defect association. It was estimated that the crystal structure mainly governs these properties. The effect of defect association could not be ignored but is considered to be a complicated correlation.     

A Semiconductor Waveguide-Type Optical Frequency Shifter

A waveguide-type optical frequency shifter based on a rotating half-wave plate is proposed. The underlying principle can be used to realize a bit-rate-free and modulation-code-free optical frequency shifter. The waveguide was formed along the ≪1 1 1> direction on a GaAs (1 1 0) substrate by molecular beam epitaxy (MBE) and reactive ion beam etching (RIBE). A 10-MHz optical frequency shift with 16 V_p-p applied voltage and 22.5% shift efficiency is demonstrated.     

A first-order system approach for diffusion equation. II: Unification of advection and diffusion

In this paper, we unify advection and diffusion into a single hyperbolic system by extending the first-order system approach introduced for the diffusion equation [J. Comput. Phys., 227 (2007) 315–352] to the advection–diffusion equation. Specifically, we construct a unified hyperbolic advection–diffusion system by expressing the diffusion term as a first-order hyperbolic system and simply adding the advection term to it. Naturally then, we develop upwind schemes for this entire   system; there is thus no need to develop two different schemes, i.e., advection and diffusion schemes. We show that numerical schemes constructed in this way can be automatically uniformly accurate, allow O(h)$O(h)$ time step, and compute the solution gradients (viscous stresses/heat fluxes for the Navier–Stokes equations) simultaneously to the same order of accuracy as the main variable, for all Reynolds numbers. We present numerical results for boundary-layer type problems on non-uniform grids in one dimension and irregular triangular grids in two dimensions to demonstrate various remarkable advantages of the proposed approach. In particular, we show that the schemes solving the first-order advection–diffusion system give a tremendous speed-up in CPU time over traditional scalar schemes despite the additional cost of carrying extra variables and solving equations for them. We conclude the paper with discussions on further developments to come.     

Reinvestigation of the thermoelectric properties of Ag8GeTe6

High‐density polycrystalline samples (above 98% of the theoretical density) of Ag₈GeTe₆ were prepared by solid‐state reactions of Ag₂Te, GeTe, and Te, followed by hot‐pressing. The thermoelectric properties were measured at temperatures ranging from room temperature to around 700 K. The thermal conductivity values were extremely low (0.25 Wm^–1 K^–1 at room temperature), and consequently Ag₈GeTe₆ exhibited a relatively high thermoelectric figure of merit, ZT = 0.48 at 703 K. (© 2008 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)     

Lie superalgebraic approach to super Toda lattice and generalized super KdV equations

We propose a super Lax type equation based on a certain class of Lie superalgebra as a supersymmetric extension of generalized (modified) KdV hierarchy. We are able to construct an infinite set of conservation laws and the consistent time evolution generators for generalized modified super KdV equations. Thefirst few of the conserved currents, the (modified) super KdV equation and the super Miura transformation are worked out explicitly in the case of twisted affine Lie superalgebraOSp(2/2)⁽²⁾.Partially supported by the Grant-in-Aid for Scientific Research from the Ministry of Education, Science and Culture (#01540246 and #01790203).RIFP will be known as Yukawa Institute for Theoretical Physics from June 8, 1990