Developing a hybrid emulsion polymerization system to synthesize Fe3O4/polystyrene latexes with narrow size distribution and high magnetite content

A hybrid emulsion polymerization was formulated for synthesizing Fe₃O₄/polystyrene composite latex. This system, containing binary droplets that are magnetic (Mag)‐droplets with a diameter of 100–200 nm and styrene (St)‐droplets with a diameter of 3–4 μm, was obtained by mixing Mag‐miniemulsion and St‐macroemulsion. With extremely low surfactants concentration (?critical micelle concentration, CMC), the nucleated loci are selectively controlled in the Mag‐droplets, as the result of smaller droplet size and larger surface ratio. Both water‐soluble potassium persulfate (KPS) and oil‐soluble 2,2′‐azobis(2‐isobutyronitrile) was adopted to initiate the polymerization. In the presence of KPS, magnetic polystyrene latices with particles size of 60–200 nm, narrow size distribution, and high magnetite content (86 wt % measured by TGA) were attained successfully. The synthesized magnetic Fe₃O_4/polystyrene latices assembled into well‐ordered hexagonal structure in the surface of a carbon supported copper grid. The influence of various parameters on various aspects of the as‐synthesized Fe₃O₄/polystyrene was investigated in detail: type of initiator on composite morphology, feed ratio of Mag‐miniemulsion and St‐macroemulsion on magnetite content, and hydrophobic agent or amount of surfactant on size and size distribution. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 5285–5295, 2007     

Microstructural evolution of decagonal quasicrystal in the undercooled Al72Ni12Co16 alloy melts

The microstructure evolution of decagonal quasicrystals in Al₇₂Ni₁₂Co₁₆ alloy was investigated by the electromagnetic melting and cyclic superheating method. Single-phase decagonal quasicrystals have been obtained when the undercoolings were larger than 60 K. The decagonal quasicrystals formed at various undercoolings show different microstructural morphologies. Furthermore, grain refinement was found near the undercooling of 120 K. Based on current thermodynamic and dendrite growth theories, a dimensionless superheating parameter was adopted to explain the effect of processing conditions on the microstructure of Al₇₂Ni₁₂Co₁₆ alloy. The result indicate that the fine equiaxied microstructure of decagonal quasicrystal (D-phase) formed near on undercooling of 120 K originates from the break-up of dendrites.     

Surface and interfacial properties of PVDF/acrylic copolymer blends before and after UV exposure

Morphological and chemical properties of both the surface and interface of poly(vinylidene fluoride)/poly(methyl methacrylate)-co-poly(ethyl acrylate) (PVDF/PMMA-co-PEA) blend films have been investigated before and after the samples were exposed to ultraviolet (UV) irradiation using a xenon arc lamp at 50 °C and 9% relative humidity (RH) for 7 months. Surface and interfacial morphologies were studied by atomic force microscopy (AFM). Chemical composition information was obtained by confocal Raman microscopy, attenuated total reflection-FTIR spectroscopy (ATR-FTIR), X-ray photoelectron spectroscopy (XPS), and contact angle measurements. Results show an enrichment of the PVDF material at the air surface, while the acrylic copolymer enriches the interface. Blends having greater than 50% mass fraction of PVDF show little change in the surface morphology after UV exposure for 7 months. However, for a lower PVDF content, blends exhibit significant degradation of PMMA-co-PEA copolymer and a much rougher surface after UV exposure. Microstructural changes in the PVDF spherulites are also observed after UV degradation. It is found that the surface and interfacial morphologies are correlated with the chemical properties.     

Si衬底上ZnSe外延膜的低压MOCVD生长

以硒化氢（H2Se）和二甲基锌为源材料，生长温度是300℃时，用低压金属有机化学气相沉积（LP－MOCVD）系统在Si(111)衬底上外延生长了ZnSe薄膜。通过X射线衍射（XRD）、扫描电子显微镜的能量色散（EDS）以及光致发光（PL）实验验证ZnSe外延膜的质量，在X射线衍射谱中只有一个强的ZnSe(111)面衍射峰，这说明外延膜是（111）取向的单晶薄膜，在能量色散谱中除了Si,Zn和Se原子外，没有观测到其他原子，说明ZnSe外延膜中杂质含量较少。ZnSe外延膜中Zn/Se原子比接近1，有较好的化学配比。在ZnSe外延膜的77K光致发光谱中没有观测到与深中心发射相关的发光峰，表明ZnSe外延膜的晶格缺陷密度较小。77K时的近带边发射峰447nm在室温时移至465nm附近。     

膨胀的热夸克胶子物质的中等质量双轻子的增强

基于一个描述夸克胶子火柱演化的相对论流体力学模型,研究了夸克相、强子相互作用以及非热过程(DrellYan对、粲强子衰变)的中等质量双轻子的产生.发现由于相边对夸克胶子物质演化的影响和RHIC能量核碰撞产生的夸克胶子物质具有高的初始温度,夸克相对双轻子的贡献显著增强,比那些来自强子相互作用的贡献重要,甚至能与来自非热的贡献比较.表明中等质量双轻子的增强是一个在核碰撞中产生了夸克胶子物质的可能信号. 关键词： 夸克-胶子物质 双轻子增强 相对论流体力学模型     

空位在金刚石近(001)表面扩散的分子动力学模拟

用分子动力学方法模拟了空位在金刚石近(001)表面的扩散过程,研究了温度对空位扩散的影响.结果表明,当温度为1000K左右时,位于近表面第二层上的空位开始向表面运动;当温度在1400—2000K时,空位完全扩散到表面.这与实验结果和其他计算结果符合得很好.同时发现,温度为1400—1800K时,空位的扩散经历了两次迁移运动,其分别对应了均方位移图中的两个极大值.在不施加任何约束的条件下得到了空位的动态扩散路径,空位在金刚石近(001)表面的扩散势垒约为042eV.并探讨了一定温度下空位数目增多及其不同排列 关键词： 金刚石 空位 扩散 分子动力学     

一种“类耗散系统”中的“类Ⅴ型阵发”

一类不连续不可逆保面积映象可以展示类似耗散的行为,因此可称其为“类耗散系统”.在一种类耗散系统中观察到了椭圆周期轨道及其周围的椭圆岛与映象不连续边界碰撞而消失的现象.周期轨道消失后,经过一系列过渡椭圆周期轨道之后,系统的行为由一个混沌类吸引子主导.在混沌类吸引子刚刚出现时,混沌时间序列呈现层流相与湍流相的无规交替.这一切都与不连续耗散系统中发生的Ⅴ型阵发的相应性质十分相似,因此可称为“类Ⅴ型阵发”.然而,当混沌类吸引子刚刚出现时,仅可以找到最后一个过渡椭圆岛的“遗迹”,并不存在它的“鬼魂”,因此类Ⅴ型阵发不遵从Ⅴ型阵发的特征标度规律.反之,混沌类吸引子的鬼魂却存在于最后一个过渡椭圆周期轨道的类瞬态过程中,因此在类Ⅴ型阵发导致混沌运动的临界点之前,由此“类瞬态混沌奇异集”中逃逸的规律就成为标志这一种临界现象的标度律.这与Ⅴ型阵发又根本不同. 关键词： 类耗散性 类混沌吸引子 类Ⅴ型阵发     

宽带Ⅱ-Ⅵ族半导体及其低维结构的生长和光学性质研究进展

本文系自1979年以来，宽带Ⅱ-Ⅵ族半导体研究组取得的主要研究成果的简要介绍。取得的主要研究成果可分为如下六个方面：第一，系统地研究了宽带Ⅱ-Ⅵ族半导体在电场激发下的自由激子发射；第二，创造性地提出并实 利用宽带Ⅱ-Ⅵ族超晶格的室温激子效应来实现在蓝绿区快响应的光学双稳的物理思想；第三，深入研究了宽带Ⅱ-Ⅵ族超晶格中的激子行为以及激子与元激发态的相互作用，为利用激子获得有效蓝色自发和受激发射提供物理基础和实验途径；第四，研究了ZnSe基非对称双量子阱和组合超晶格中激子的隧穿以及激子的自发和受激发射；第五，CdSe和ZnSeS自组装量子点的生长及其形成机理；第六，ZnO薄膜的生长及其紫外发射特性。     

电子辐照诱发固态相变导致的氮化硼纳米结构生长

报道了N+离子轰击产生的氮化硼(BN)纳米结构,及在电子辐照时结构演化的高分辨透射电子显微镜的原位测定结果.应当强调的是,这种类富勒烯和发夹结构的演化,实际上是电子辐照诱发固态相变的发展,观察中发现的一些BN颗粒、卷曲物,可以被认为是类富勒烯等纳米结构形成的前体或早期阶段.提出了一种类富勒烯等结构的电子辐照动力学模型,并进行了讨论. 关键词： 氮化硼 电子辐照 透射电子显微镜 氮化硼纳米形成物     

狭缝式高速摄影机胶片的计算机判读

根据狭缝摄影机胶片的成象原理,运用数字图象处理技术,对狭缝式高速摄影机胶片判读工作的计算机化进行研究.应用结果表明,该技术先进实用,极大地提高了判读的精度和效率,将是这种胶片判读技术的发展方向.