Structures of Addition Products of Acetylenedicarboxylic Acid Esters with Various Dinucleophiles. An application of C,H-spin-coupling constants

Heterocyclic compounds obtained by addition of acetylenedicarboxylic acid esters to thioureas, cyclic amidines and o-difunctionalized aromatic systems have been studied by ¹³C-NMR. In particular, C, H-spin-coupling constants over two and three bonds were used to differentiate between the various constitutional isomers and to establish the configuration of trisubstituted exocyclic C, C-double bonds. The configurational significance and diagnostic value of vicinal cis and trans C,H-spin coupling is again demonstrated in the present series.     

Chemical ionization mass spectra of mononitroarenes

The H₂ and CH₄ chemical ionization mass spectra of a selection of substituted nitrobenzenes have been determined. It is shown that reduction of the nitro group to the amine is favoured by high source temperatures and the presence of water in the ion source. The H₂ chemical ionization mass spectra are much more useful for distinguishing between isomeric compounds than the CH₄ CI mass spectra because of the more extensive fragmentation. For ortho substituents bearing a labile hydrogen abundant [MH ? H₂O]⁺ fragments are observed. When the substituent is electron-releasing both ortho and para substituted nitrobenzenes show abundant [MH? OH]⁺ fragment ions while meta substituted compounds show abundant loss of NO and NO₂ from [MH]⁺. The latter fragmentation is interpreted in terms of protonation para to the substituent or ortho to the vitro function, while the first two fragmentation routes arise from protonation at the nitro group. When the substituent is electron-attracting the chemical ionization mass spectra of isomers are very similar except for the H₂O loss reaction for ortho compounds.     

On-line coupling of capillary isoelectric focusing with transient isotachophoresis-zone electrophoresis: a two-dimensional separation system for proteomics

A microdialysis junction is employed as the interface for on-line coupling of capillary isoelectric focusing with transient isotachophoresis-zone electrophoresis in a two-dimensional separation system. Capillary isoelectric focusing not only provides high-resolution separation of tryptic peptides based on their differences in isoelectric point, but also potentially allows the analysis of low-abundance proteins with a typical concentration factor of 50-100 times. Carrier ampholytes, employed for the creation of a pH gradient during focusing, are further utilized as the leading electrolyte in the second separation dimension, transient isotachophoresis-zone electrophoresis. Many peptides which have the same isoelectric point would most likely have different charge-to-mass ratios, and thus different electrophoretic mobilities in zone electrophoresis. Two-dimensional separation of proteolytic peptides is demonstrated using standard proteins, including cytochrome c, ribonuclease A, and carbonic anhydrase II. The maximum peak capacity is estimated to be around approximately 1600 and can be significantly increased by simply increasing the capillary column length and manipulating the range of pH gradient in isoelectric focusing. In addition to enhanced separation efficiency and resolution, this two-dimensional electrokinetic separation system permits sensitive and comprehensive analysis of peptide fragments, especially when integrated with electrospray ionization mass spectrometry for peptide/protein identification.     

Kinetics of decomposition of hydrogen peroxide on Fe(III)?Al(III) hydroxide-oxide systems

The kinetics of decomposition of hydrogen peroxide have been studied on mixed Fe(III)–Al(III) hydroxide and oxide catalysts. While iron hydroxide possesses considerable catalytic activity, aluminium hydroxide has very little activity. The rate of decomposition on mixed hydroxides increases with increasing concentration of aluminium hydroxide up to about 1.5 mol% and decreases thereafter. The mixed oxides possess negligible activity compared to the corresponding hydroxides. The energy of activation, as calculated from the Arrhenius equation, is 10.1 kcal/mol for sample S4, containing 1.52 mol% of alumina. The rate of decomposition of S4 increases with increasing pH up to 6.8 and decreases thereafter. The rate is first order in all these cases. A suitable mechanism is suggested.

---

Fe(III)–Al(III). , . , 1,5 , . . , , 10,1 / S4, 1,52 . S4 pH 6,8, . . .

     

Chromium(III) Hydroxide Solubility in the Aqueous K+-H+-OH?-CO2-HCO 3? -CO 32? -H2O System: A?Thermodynamic Model

Chromium(III)-carbonate reactions are expected to be important in managing high-level radioactive wastes. Extensive studies on the solubility of amorphous Cr(III) hydroxide solid in a wide range of pH (3–13) at two different fixed partial pressures of CO₂(g) (0.003 or 0.03 atm.), and as functions of K₂CO₃ concentrations (0.01 to 5.8 mol⋅kg⁻¹) in the presence of 0.01 mol⋅dm⁻³ KOH and KHCO₃ concentrations (0.001 to 0.826 mol⋅kg⁻¹) at room temperature (22±2 °C) were carried out to obtain reliable thermodynamic data for important Cr(III)-carbonate reactions. A combination of techniques (XRD, XANES, EXAFS, UV-Vis-NIR spectroscopy, thermodynamic analyses of solubility data, and quantum mechanical calculations) was used to characterize the solid and aqueous species. The Pitzer ion-interaction approach was used to interpret the solubility data. Only two aqueous species [Cr(OH)(CO₃)₂²⁻ and Cr(OH)₄CO₃³⁻] are required to explain Cr(III)-carbonate reactions in a wide range of pH, CO₂(g) partial pressures, and bicarbonate and carbonate concentrations. Calculations based on density functional theory support the existence of these species. The log ₁₀ K° values of reactions involving these species [{Cr(OH)₃(am) + 2CO₂(g)⇌Cr(OH)(CO₃)₂²⁻+2H⁺} and {Cr(OH)₃(am) + OH⁻+CO₃²⁻ ⇌Cr(OH)₄CO₃³⁻}] were found to be −(19.07±0.41) and −(4.19±0.19), respectively. No other data on any Cr(III)-carbonato complexes are available for comparisons.     

Solvent and thiourea adsorption/intercalation effects on the solid-state electrochemistry of α-phase nickel hydroxide nanoparticles

Nanoparticles of α-phase nickel hydroxide were synthesized by a single-step hydrothermal method using urea as the hydrolytic agent. Precipitated powders were of pure turbostratic α-phase as confirmed by x-ray diffraction profile. The ageing of α-Ni(OH)₂ in 1.0 M alkali solutions is investigated for pure non-intercalated α-Ni(OH)₂ and thiourea intercalated/absorbed α-phase nanomaterials. The α-Ni(OH)₂ powder immobilized on the surface of graphite electrodes shows a gradual α→β phase transformation with continuous voltammetric cycling, and the concentration gradient of water that exists in the layered-double-hydroxide-like interlayers of α-phase and the solution was shown to play a crucial role on the high electrochemical activity of this phase nickel hydroxide. To understand the role of water in the ageing process, concomitant entries of non-aqueous solvents like ethanol and acetonitrile along with thiourea were effected. Cyclic voltammetric measurements of thiourea-treated α-Ni(OH)₂ samples revealed that hydroxyl ion influx during the anodic oxidation depends on the counter flux of solvent molecules, and if the intercalated the solvent is acetonitrile, then the electrochemical activity of α-Ni(OH)₂ reduced drastically; Q _a/Q _c>1 for water as solvent in the interlayers α-Ni(OH)₂ and Q _a/Q _c<1 for ethanol and acetonitrile as solvents. The α-phase gets stabilized in the presence of thiourea with water and ethanol as co-intercalates. Transmission electron microscope images of α-Ni(OH)₂ and thiourea-treated samples show a change in particle size and morphology. Elemental CHNS analysis confirms the presence of sulphur in the thiourea intercalated samples.     

A spectrophotometric method for uranium determination

A very sensitive extraction spectrophotometric method for the analysis of uranium based on the extraction of a uranium—benzoate—crystal violet complex by a mixture of xylene and benzene is described. The absorbance maximum is at 606 nm and molar absorptivity is 4.28·10⁴ l·mol⁻¹·cm⁻¹. The interference due to a number of anions and cations studied without any pre-extraction was found to be within permissible limits. The method has been used for determining uranium in a synthetic solution, i.e., uranium in the presence of various other ions. The interference due to some cations was eliminated by the use of a masking agent (boric acid).     

Synthesis and fluorescence properties of covalently linked homo- and hetero-porphyrin dyads containing meso-tolyl porphyrin and meso-furyl porphyrin sub-units

Three porphyrin building blocks with N₄, N₃S and N₂S₂ cores having three meso-furyl groups and one meso-iodophenyl group were synthesized and characterized. The porphyrin building blocks were used to synthesize six porphyrin dyads such as N₄-N₄, N₃S-N₃S, N₂S₂-N₂S₂, N₄-N₃S, N₄-N₂S₂ and N₃S-N₂S₂ containing meso-tolyl and meso-furyl porphyrin sub-units under mild Pd(0) mediated coupling conditions. Steady state fluorescence studies indicated an efficient energy transfer from the meso-tolyl porphyrin sub-unit to the meso-furyl porphyrin sub-unit in all six dyads. This study supported the argument that the meso-furyl porphyrins can be used as good energy acceptors when meso-aryl porphyrins act as energy donors in their metal free form.     

A new chelating resin for preconcentration and determination of Mn(II), Ni(II), Cu(II), Zn(II), Cd(II), and Pb(II) by flame atomic absorption spectrometry

A new polychelatogen, AXAD-16-1,2-diphenylethanolamine, was developed by chemically modifying Amberlite XAD-16 with 1,2-diphenylethanolamine to produce an effective metal-chelating functionality for the preconcentration of Mn(II), Ni(II), Cu(II), Zn(II), Cd(II), and Pb(II) and their determination by flame atomic absorption spectrometry. Various physiochemical parameters that influence the quantitative preconcentration and recovery of metal were optimized by both static and dynamic techniques. The resin showed superior extraction efficiency with high-metal loading capacity values of 0.73, 0.80, 0.77, 0.87, 0.74, and 0.81 mmol/g for Mn(II), Ni(II), Cu(II), Zn(II), Cd(II), and Pb(II), respectively. The system also showed rapid metal-ion extraction and stripping, with complete saturation in the sorbent phase within 15 min for all the metal ions. The optimum condition for effective metal-ion extraction was found to be a neutral pH, which is a great advantage in the preconcentration of trace metal ions from natural water samples without any chemical pretreatment of the sample. The resin also demonstrated exclusive ion selectivity toward targeted metal ions by showing greater resistivity to various complexing species and more common metal ions during analyte concentration, which ultimately led to high preconcentration factors of 700 for Cu(II); 600 for Mn(II), Ni(II), and Zn(II); and 500 for Cd(II) and Pb(II), arising from a larger sample breakthrough volume. The lower limits of metal-ion detection were 7 ng/mL for Mn(II) and Ni(II); 5 ng/mL for Cu(II), Zn(II), and Cd(II), and 10 ng/mL for Pb(II). The developed resin was successful in preconcentrating metal ions from synthetic and real water samples, multivitamin-multimineral tablets, and curry leaves (Murraya koenigii) with relative standard deviations of < or = 3.0% for all analytical measurements, which demonstrated its practical utility.     

Solubility of (UO2)3(PO4)2?4H2O in H+-Na+-OH?-H2PO?4-HPO2?4-PO3?4-H2O and Its Comparison to the Analogous PuO2 +2 System

The objectives of this study were to address uncertainties in the solubility product of (UO₂)₃(PO₄)₂⋅4H₂O(c) and in the phosphate complexes of U(VI), and more importantly to develop needed thermodynamic data for the Pu(VI)-phosphate system in order to ascertain the extent to which U(VI) and Pu(VI) behave in an analogous fashion. Thus studies were conducted on (UO₂)₃(PO₄)₂⋅4H₂O(c) and (PuO₂)₃(PO₄)₂⋅4H₂O(am) solubilities for long-equilibration periods (up to 870 days) in a wide range of pH values (2.5 to 10.5) at fixed phosphate concentrations of 0.001 and 0.01 M, and in a range of phosphate concentrations (0.0001–1.0 M) at fixed pH values of about 3.5. A combination of techniques (XRD, DTA/TG, XAS, and thermodynamic analyses) was used to characterize the reaction products. The U(VI)-phosphate data for the most part agree closely with thermodynamic data presented in Guillaumont et al.,⁽¹⁾ although we cannot verify the existence of several U(VI) hydrolyses and phosphate species and we find the reported value for formation constant of UO₂PO⁻₄ is in error by more than two orders of magnitude. A comprehensive thermodynamic model for (PuO₂)₃(PO₄)₂⋅4H₂O(am) solubility in the H⁺-Na⁺-OH⁻-Cl⁻-H₂PO⁻₄-HPO²⁻₄-PO³⁻₄-H₂O system, previously unavailable, is presented and the data shows that the U(VI)-phosphate system is an excellent analog for the Pu(VI)-phosphate system.