Comparative X-ray photoelectron spectroscopic study on the desulfurization of thiophene by Raney nickel and rapidly quenched skeletal nickel

The desulfurization of thiophene on Raney Ni and rapidly quenched skeletal Ni (RQ Ni) has been studied in ultrahigh vacuum (UHV) by X-ray photoelectron spectroscopy (XPS). The Raney Ni or RQ Ni can be approximated as a hydrogen-preadsorbed polycrystalline Ni-alumina composite. It is found that thiophene molecularly adsorbs on Raney Ni or RQ Ni at 103 K. At 173 K, thiophene on alumina is desorbed, while thiophene in direct contact with the metallic Ni in Raney Ni undergoes C-S bond scission, leading to carbonaceous species most probably in the metallocycle-like configuration and atomic sulfur. On RQ Ni, the temperature for thiophene dissociation is about 100 K higher than that on Raney Ni. The lower reactivity of RQ Ni toward thiophene is tentatively attributed to lattice expansion of Ni crystallites in RQ Ni due to rapid quenching. The existence of alumina and hydrogen may block the further cracking of the metallocycle-like species on Raney Ni and RQ Ni at higher temperatures, which has been the dominant reaction pathway on Ni single crystals. By 473 K, the C 1s peak has disappeared, leaving nickel sulfide on the surface.     

Co-immobilization of polymeric luminol,iron(II) tris(5-aminophenanthroline) and glucose oxidase at an electrode surface,and its application as a glucose optrode

The anodic polymerization of 3-aminophthalhydrazide (luminol) and iron(II) tris 5-aminophenanthroline (Fe(phen-NH2)3(2+)) has been reported in this paper. A bilayer electrode was developed based on these polymers and the ITO conductive glass (denoted ITO[Fe(phen-NH2)3(2+)]luminol electrode). This electrode emitted light (lambdaem: 430 nm) as it was brought into contact with H2O2. At pH 10, the resulting electrochemiluminescence (ECL) showed a linear relationship with the concentration of H2O2 in the range of 10 microM(-1) mM. This bilayer electrode also showed an application potential for the detection of glucose after being further modified with glucose oxidase (denoted ITO[Fe(phen-NH2)3(2+)]luminol]GOx electrode). Although the resulting ECL decayed more rapidly in concentrated glucose solutions (e.g., I M) because of the consumption of luminol during use, the decay became less severe in diluted glucose solutions (e.g., 10 mM). According to the flow injection analysis, a linear relationship existed between the ECL and the concentration of glucose from 10(-5)-10(-3) M at pH 9. The detection limit could reach a level of 5 x 10(-5) M at this pH.     

Determination of N-Methylpyrrolidine in Cefepime for Injection by Capillary Electrophoresis with Indirect UV Detection

N-Methylpyrrolidine in cefepime for injection was determined by capillary electrophoresis with indirect UV detection. Best results were achieved with background electrolyte consisting of 10 mM creatinine adjusted to pH 3.8 with formic acid and an applied voltage of 30 kV in a bare fused-silica capillary. Indirect UV detection was performed at a wavelength of 225 nm. The application of a small amount of inlet pressure during the separation assisted the attainment of a stable baseline. The optimized method was validated regarding selectivity, linearity, accuracy, precision, ruggedness, repeatability and detection limits. Careful control of capillary conditioning enabled migration time precision values of <0.2% RSD. The use of an internal standard enabled precision values of <1% RSD to be obtained for peak area ratios.     

Ξ Resonances in Ξ− Be interactions II. Properties of Ξ(1820) and Ξ(1960) in the\Lambda \bar K^0 and\Sigma ^0 \bar K^0 channels

In an experiment at the CERN-SPS charged hyperon beam, we have investigated the inclusive \(\Lambda \bar K^0 \) and \(\Sigma ^0 \bar K^0 \) final states formed in Ξ^? Be interactions. In the \(\Lambda \bar K^0 \) channel, we observe a signal at 1826 MeV/c² which can be identified with the known Ξ(1820) resonance. We determine its mass and width to be:M=1826±4 MeV/c², Г=12±14 MeV/c². A moment analysis is consistent with a spin of 3/2 and indicates a negative parity for this spin assignment. Also in the \(\Lambda \bar K^0 \) channel, we observe a 3.6σ signal with the following parameters:M=1963±5 MeV/c², Г=25±15 MeV/c². This state, which we call Ξ(1960), is not observed in the \(\Sigma ^0 \bar K^0 \) channel, leading to an upper limit on the ratio of partial widths \(\Sigma \bar K/\Lambda \bar K\) of 2.3 (90% confidence level). A moment analysis of the \(\Lambda \bar K^0 \) final state indicates a spin of 5/2 or greater in the natural spin-parity series 5/2⁺, 7/2^?, etc.     

Crystal Structure of Dimethylamine 3,5-Dinitrobenzoic Acid Organic Adduct

1 INTRODUCTION Nonlinear optics (NLO) is at the forefront of cur- rent researches because of its importance in provi- ding the key functions of frequency shifting, optical modulation, optical switching, optical logic and op- tical memory for the emerging …     

Photokatalytische Systeme. XLIV. Über das Intervalence-Charge-Transfer-Verhalten von Ionenpaarassoziaten des Octacyanomolybdats

Photocatalytic Systems. XLIV. On the Intervalence Charge Transfer Behaviour of Ion Pairs of Octacyanomolybdate [Mo(CN)₈]^4? ions are forming coloured ion pairs with Fe^III, Cu^II, U^VIO₂, and V^IVO, the long-wavelength absorption band of which could be assigned to an intervalence charge-transfer transition. From the solvent dependence of the IT band, interionic distances could be estimated.     

Kinetics of oil saponification by lead salts in ancient preparations of pharmaceutical lead plasters and painting lead mediums

Lead soaps can be found in archaeological cosmetics as well as in oil paintings, as product of interactions of lead salts with oil. In this context, a better understanding of the formation of lead soaps allows a follow-up of the historical evolution of preparation recipes and provides new insights into conservation conditions. First, ancient recipes of both pharmaceutical lead plasters and painting lead mediums, mixtures of oil and lead salts, were reconstructed. The ester saponification by lead salts is determined by the preparation parameters which were quantified by FT-IR spectrometry. In particular, ATR/FT-IR spectrometer was calibrated by the standard addition method to quantitatively follow the kinetics of this reaction. The influence of different parameters such as temperature, presence of water and choice of lead salts was assessed: the saponification is clearly accelerated by water and heating. This analysis provides chemical explanations to the historical evolution of cosmetic and painting preparation recipes.     

催化燃烧去除VOCs污染物的最新进展

催化燃烧是目前最有效的处理挥发性有机物(VOCs)技术之一. 本文从催化剂活性组分、催化剂载体、有效组分颗粒大小、水蒸汽的影响及催化燃烧反应中的积碳等几个方面, 对近年来催化燃烧处理VOCs的研究进行了总结. 分析表明: 贵金属催化剂的研究主要着重于选择有效的载体和双组分贵金属催化剂; 非贵金属催化剂的研究主要集中在高活性的过渡金属复合氧化物、钙钛矿和尖晶石型等催化剂的研制, 还有这些活性组分粒径大小及载体对催化燃烧VOCs反应活性的影响;此外, 在实际应用中,水蒸汽和催化剂积碳失活等问题对催化燃烧VOCs的反应也有很大影响. 本文的评述将为选择合适的催化燃烧技术处理VOCs污染物提供一定参考.     

Mechanically responsive films of variable hydrophobicity made of polyelectrolyte multilayers

Mechanically responsive surfaces that allow to switch reversibly from a hydrophobic to a hydrophilic substrate are reported. The surfaces are constituted of polyelectrolyte multilayers deposited on modified charged silicone sheets. n bilayers of poly(allylamine)-Nafion (PAH-Naf) and m bilayers of poly(allylamine)-poly(acrylic acid) (PAH-PAA) composed the multilayers. A (PAH-Naf)(n) film possesses a water contact angle of around 105 degrees, whereas the contact angle of a (PAH-Naf)(4)-(PAH-PAA)(m) multilayer is around 50 degrees. When such a film with m < 5 and terminated by PAA is stretched out, its water contact angle increases up to around 100 degrees. Successive elongation/retraction cycles allow the water contact angle to alternate reversibly between 100 and 57 degrees indicating the reversible mechanical responsive nature of the film.     

DMF-甲醇体系粘度与核磁共振化学位移的同时关联

提出了一个基于局部组成概念上的核磁共振模型. 利用该模型和以前别人提出的局部组成型粘度方程, 成功地同时关联属于传递性质的粘度数据和属于波谱性质的核磁共振化学位移数据，关联所得到化学位移的平均绝对偏差小于0.0072，粘度的平均绝对偏差小于0.0006 mPa•s，结果表明提出的局部组成模型是合理的.