无催化纳米氧化锌的制备及其光学性质研究

本文采用无催化剂直接蒸发高纯Zn粉,在800℃氧气氛条件下,在Si(111)衬底上生长得到以四角状为主的纳米ZnO(T-ZnO)。T-ZnO纳米线每个角约互成110°,长度约为1.5μm,直径100nm左右;Raman分析表明E2(H)普遍存在于各形态的ZnO;光致发光光谱表明,T-ZnO纳米线的光致发光除了与材料性质有关,还与杂质缺陷有关,蓝绿光带是ZnO的缺陷产生的。     

位移和速度反馈的数学模型及实现方法

本文提出了位移和速度同时反馈的数学模型 .并给出了位移和速度反馈的实现方法 ,该方法用传统的差动变压器实现了位移和速度的同时反馈     

BEPCⅡ高频发射机和环流器的调整和测试

北京正负电子对撞机升级改造工程(BEPCⅡ)将采用的频率500MHz、输出功率250kW的高频发射机和环流器已安装、调整、测试和验收完毕,这是国内建立的第一套500MHz/250kW发射机系统.本文将详细介绍机器的调测试的原理和各项测量内容及结果, 并比较设计指标和要求,来阐述此发射机的实际技术指标和测试性能.     

Demonstration of Soliton Solutions of DNLS Equation by Liouville Theorem

In the inverse scattering transform (IST), the reflectionless Jost solutions are combined by their analytic properties in the complex spectrum parameter plane, and then can be shown to satisfy the two Lax equations indeed by Liouville theorem. So the corresponding soliton solutions certainly satisfy the nonlinear equation by compatibility condition. Especially the multi-soliton solutions of DNLS equation can be demonstrated in this way. PACS Numbers: 05.45.Yv, 02.30.-f, 11.10.Ef     

Surface free energy of CrNx films deposited using closed field unbalanced magnetron sputtering

CrN_x thin films have attracted much attention for semiconductor IC packaging molding dies and forming tools due to their excellent hardness, thermal stability and non-sticking properties (low surface free energy). However, few data has been published on the surface free energy (SFE) of CrN_x films at temperatures in the range 20-170 °C. In this study CrN_x thin films with CrN, Cr(N), Cr₂N (and mixture of these phases) were prepared using closed field unbalanced magnetron sputtering at a wide range of Cr⁺² emission intensity. The contact angles of water, di-iodomethane and ethylene glycol on the coated surfaces were measured at temperatures in the range 20-170 °C using a Dataphysics OCA-20 contact angle analyzer. The surface free energy of the CrN_x films and their components (e.g., dispersion, polar) were calculated using the Owens-Wendt geometric mean approach. The influences of CrN_x film surface roughness and microstructure on the surface free energy were investigated by atomic force microscopy (AFM) and X-ray diffraction (XRD), respectively. The experimental results showed that the lowest total SFE was obtained corresponding to CrN at temperature in 20 °C. This is lower than that of Cr(N), Cr₂N (and mixture of these phases). The total SFE, dispersive SFE and polar SFE of CrN_x films decreased with increasing surface temperature. The film roughness has an obvious effect on the SFE and there is tendency for the SFE to increase with increasing film surface roughness.     

腺嘌呤及其β-环糊精包结物的光谱研究

通过紫外光谱的摩尔比法确定了腺嘌呤与β-环糊精（β－CD）包结物的包结比为1：1，通过紫外光谱和荧光光谱研究了腺嘌呤在酸性，中性，及碱性条件下的光谱变化及与β－CD包结物的光谱变化，分别求得了它们与β－CD包结的平衡常数。     

Bioaccumulation and excretion of arsenic compounds by a marine unicellular alga,polyphysa peniculus

Polyphysa peniculus was grown in artificial seawater in the presence of arsenate, arsenite, monomethylarsonate and dimethylarsinic acid. The separation and identification of some of the arsenic species produced in the cells as well as in the growth medium were achieved by using hydride generation–gas chromatography–atomic absorption spectrometry methodology. Arsenite and dimethylarsinate were detected following incubation with arsenate. When the alga was treated with arsenite, dimethylarsinate was the major metabolite in the cells and in the growth medium; trace amounts of monomethylarsonate were also detected in the cells. With monomethylarsonate as a substrate, the metabolite is dimethylarsinate. Polyphysa peniculus did not metabolize dimethylarsinic acid when it was used as a substrate. Significant amounts of more complex arsenic species, such as arsenosungars, were not observed in the cells or medium on the evidence of flow injection–microwave digestion–hydride generation–atomic absorption spectrometry methodology. Transfer of the exposed cells to fresh medium caused release of most cell–associated arsenicals to the surrounding environment.     

双全纯映照的一些偏微分不等式

该文在有界星形圆型域上建立一些与双全纯星形映照有关的偏微分不等式．作为应用，给出有界星形圆型域上ε星形映照以及近似星形映照的一些充分判别条件．     

Use of a long-spacer-side-chain liquid crystalline polysiloxane containing a crown ether as a stationary phase for capillary gas chromatography

A new kind of side chain liquid crystalline polysiloxane containing a crown ether with a longer spacer (PSC-11) has been prepared and coated on a fused silica capillary column. The main chroma-tographic characteristics including efficiency, polarity, and selectivity have been examined. The phase exhibits the retention properties of both liquid crystal and crown ether stationary phases and possesses higher efficiency and better selectivity than PSC-3, which has a shorter spacer between the main polysiloxane chain and liquid crystalline side chain.     

The effects of flow split ratio and flow rate in manifolds

This paper reports a combined experimental and numerical investigation of three-dimensional steady turbulent flows in inlet manifolds of square cross-section. Predictions and measurements of the flows were carried out using computational fluid dynamics and laser Doppler anemometry techniques respectively. The flow structure was characterized in detail and the effects of flow split ratio and inlet flow rate were studied. These were found to cause significant variations in the size and shape of recirculation regions in the branches, and in the turbulence levels. It was then found that there is a significant difference between the flow rates through different branches. The performance of the code was assessed through a comparison between predictions and measurements. The comparison demonstrates that all important features of the flow are well represented by the predictions.