The glow curve structure for the LiF:Mg,Cu,Na,Si TL detector with dopants concentrations and sintering temperatures

The glow curve structures for LiF:Mg,Cu,Na,Si TL detectors with various dopant concentrations and sintering temperatures were investigated for the improvement of the glow curve structure and sensitivity of the TL detector. The dopant concentrations were varied over the following ranges: Mg (0–0.25 mol%), Cu (0–0.07 mol%), Na and Si (0–1.5 mol%). With increasing Cu concentration, the intensity of the main peak was intensified and reached a maximum at a concentration of 0.05 mol%. The high-temperature peak was reduced. The dependency of the main peak intensity on the Mg concentration exhibits a sharp maximum at 0.2 mol%. The intensity of the high-temperature peak tends to rise slightly with increasing Mg concentration. It was found that the optimum concentrations of the dopants in the LiF:Mg,Cu,Na,Si TL material are Mg: 0.2 mol%, Cu: 0.05 mol%, Na and Si: 0.9 mol%. The dependency of the main peak intensity on sintering temperature exhibits a very sharp maximum at 830°C. The high-temperature peak was rapidly reduced after 825°C.     

Negative luminescence from mid-wave infrared HgCdTe diode arrays

A self-referencing, optical modulation technique was used to measure the negative luminescence efficiencies of an array of mid-wave infrared HgCdTe photodiodes with cutoff wavelength 4.6 μm as a function of sample temperature. The internal efficiency at a wavelength of 4 μm was 93% at 295 K, and nearly independent of temperature in the 240–300 K range. This corresponds to an apparent temperature reduction >50 K at room temperature and >30 K at 240 K. Moreover, the reverse-bias saturation current density was only 0.13 A/cm². The measured transmission and emission spectra were simulated using empirical HgCdTe absorption formulas from the literature.     

Longitudinal DC electric discharge in a supersonic air flow

A longitudinal dc electric discharge in a submerged high-pressure supersonic air jet is described. Photographs of the discharge are provided. The experimental voltage across the discharge gap and the discharge current are given for two resistances of the resistor that limits the discharge current over a certain range of the discharge channel length along the air flow. The current-voltage discharge characteristic is provided at a constant discharge length. The main discharge characteristics are obtained from a comparison of the experimental and theoretical results calculated on the basis of the simplest model.     

Effect of γ radiation from <Superscript>60</Superscript>Co on the formation of metal contacts to GaAs (Al<Subscript>x</Subscript>Ga<Subscript>1−<Emphasis Type="Italic">x</Emphasis></Subscript>As) structures

The properties of nonrectifying AuGe/GaAs (Al_0.4Ga_0.6As) contacts exposed to heat treatment, ⁶⁰Co γ radiation, and γ radiation combined with the application of an electrical bias are studied. A correlation between the type of interfacial interaction in the contacts and their resistance is found. Results obtained are explained in terms of a diffusion model with a movable boundary of the metal layer.     

Magnetic Properties of Iron-Based Amorphous Metal Wires

It has been studied how the conditions of machining and the elastic tensile stresses affect the magnetic properties of amorphous metal wires of composition Fe₇₅Si₁₀B₁₅ produced by drawing from a melt. The magnetic characteristics of wires subjected to both thermal treatment and treatment with a continuous electric current of different magnitude have been investigated. The residual induction of wires is their magnetic parameter most sensitive to the conditions of treatment. The dependences of the residual induction on temperature and on the magnitude of the treating electric current are qualitatively similar. The greatest changes in residual induction are observed in the range of treating electric currents from 0.5 to 0.8 A, which can be associated with the processes of structural relaxation and crystallization occurring in the wires. The run of the dependence of the residual induction on the magnitude of tensile stresses is nonmonotonic in character and is determined by the level of internal hardening stresses of the test wires.     

Collision operator for relativistic electrons in a cold gas of atomic particles

The collision operator of relativistic electrons with a cold gas of atomic particles is derived consistently taking into account elastic interactions, excitation of electron shells, and ionization. The creation of secondary electrons is described accurately. In the range of energies exceeding the binding energy of atomic electrons, the operator implicates only the angular scattering by nuclei and the ionization integral that automatically allows for scattering by atomic electrons. The collision operator used earlier for studying the kinetics of avalanches of relativistic runaway electrons is analyzed. A more exact operator derived in the present study is simpler in form and saves time in computer calculations.     

Characteristics of high-power radiating imploding discharge with cold start

A qualitative model of the dynamics of a multiterawatt radiating Z-pinch with cold start and high rate of current rise is proposed. The model is used to analyze discharges with currents I ～ 2–5 MA (with dI/dt > 10¹³ A/s) through uniform or structured plasma-producing loads, including wire arrays. The most important consequence of cold start is that spatially nonuniform plasma production is prolonged to almost the entire current rise time. Under these conditions, the Ampére force begins to play a dominant role in the plasma dynamics before the plasma-producing load is completely transformed into an accelerated plasma. The results of computations of wire-array vaporization are presented. A formula is proposed for estimating the highest attainable velocity of plasma flow into a heterogeneous liner driven by the Ampére force. It is shown that local imbalance between radial motion of the produced plasma and supply of the plasma-producing substance to be ionized leads to axially nonuniform breakthrough of magnetic flux into the liner, which precedes plasma collapse. The magnetic-flux breakthrough gives rise to a chaotic azimuthal-axial plasma structure consisting of radial plasma jets of relatively small diameter, which is called a radial plasma rainstorm. The breaking-through azimuthal magnetic flux obstructs further current flow in the breakthrough region. Analyses of Z-pinch implosion based on the theory of Rayleigh-Taylor instability or the snowplow model are incorrect under the plasma-rainstorm conditions. The processes taking place in a stagnant Z-pinch include conversion of the energy carried by the current-generated magnetic field into turbulent MHD flow of the ion component of the plasma, its convective mixing with magnetic field, heating, energy transfer from ions to electrons, and emission from the plasma. Under typical experimental conditions, emission plays a key role in the energy balance in an imploding pinch. Z-pinch is modeled by an electric-circuit component that has a time-dependent nonlinear impedance and consumes the magnetic energy supplied by a generator through a magnetically insulated transmission line (MITL). The peak power reached in the circuit is comparable to the peak soft X-ray power output emitted by the pinch in terms of magnitude and timing. Optimum matching conditions are formulated for the generator-MITL-pinch circuit.     

Synthesis of ordered Ge-Si heterostructures containing ultrasmall germanium nanoclusters

Different techniques for the fabrication of structures containing ensembles of ultrasmall germanium nanoclusters distributed with a high density over the substrate surface are discussed. How to control the morphology and ordering of these ensembles is also discussed.     

Electromechanical properties of Pb<Subscript>3</Subscript>Ga<Subscript>2</Subscript>Ge<Subscript>4</Subscript>O<Subscript>14</Subscript> piezoelectric crystals grown from solution in a melt

Single crystals of lead gallium germanate Pb₃Ga₂Ge₄O₁₄ are grown from their own solution melts. The propagation of bulk acoustic waves is investigated, and the elastic, piezoelectric, and dielectric constants are calculated. The temperature dependences of the dielectric constants of this compound are analyzed.