Ni(II), Cu(II), and Zn(II) complexes of tetradentate schiff base containing two thiadiazoles units: Structural,spectroscopic, magnetic properties,and molecular modeling studies

Four new mononuclear metal complexes with a mononucleating Schiff base ligand containing two thiadiazoles units have been synthesized. The ligand and metal complexes were characterized by elemental analyses, IR, ¹H, and ¹³C NMR, UV–vis, ESR, electrospray ionization mass spectra, and magnetic susceptibility measurements. Electronic spectra, magnetic susceptibility measurement, and molecular modeling studies support octahedral geometry around the Ni(II), Cu(II), and Zn(II) ions. The magnetic properties were investigated, and ferromagnetic coupling is observed in Cu(II) and Ni(II) complexes. In addition, total energy and heat of formation calculated for conformers of the Schiff base ligand by the semiempirical AM1 calculations have shown that E,Z‐isomer of the ligand is more stable (about 5.3 kcal/mol) than E,E‐ and Z,Z‐isomers. © 2008 Wiley Periodicals, Inc. Heteroatom Chem 19:700–712, 2008; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/hc.20496     

A theoretical investigation of the relative stability of hydrated glycine and methylcarbamic acid--from water clusters to interstellar ices

We have theoretically investigated how the low-energy conformers of the neutral and the zwitterionic forms of glycine as well as methylcarbamic acid are stabilized by the presence water. The MP2/6-311++G(d,p) method was utilized to conduct calculations on glycine and methylcarbamic acid in both isolated clusters and in clusters embedded in the conductor-like polarizable continuum model (C-PCM), where the clusters explicitly contain between one and ten water molecules. The neutral forms of glycine and methylcarbamic acid were found to have similar hydration energies, whereas the neutral methylcarbamic acid was determined to be approximately 32 kJ mol(-1) more stable than the neutral glycine in the isolated clusters and 30 kJ mol(-1) more stable in the C-PCM embedded clusters. Both the number and strength of the hydrogen bonding interactions between water and the zwitterions drive the stability. This lowers the relative energy of the glycine zwitterion from 50 kJ mol(-1) above neutral glycine, when there are two water molecules in the clusters to 11 kJ mol(-1) below for the clusters containing ten water molecules. For the methylcarbamic acid clusters with two water molecules, the zwitterion is 51 kJ mol(-1) higher in energy than the neutral form, but it remains 13 kJ mol(-1) above the neutral methylcarbamic acid in the clusters containing ten water molecules. When the bulk water environment is simulated by the C-PCM calculations, we find both the methylcarbamic acid and glycine zwitterionic forms have similar energies at 20 kJ mol(-1) above the neutral methylcarbamic acid energy and 10 kJ mol(-1) lower than the neutral glycine energy. Although neither methylcarbamic acid nor glycine have been detected in the interstellar medium yet, our findings indicate that methylcarbamic acid is the more stable product from methylamine and carbon dioxide reactions in a water ice. This suggests that methylcarbamic acid likely plays a role in the intermediate steps if glycine is formed in the interstellar medium.     

Phthalocyanine with a giant dielectric constant

Compound 1 has been prepared by the reaction of 4-nitrophthalonitrile and trans-2-methoxy-4-(2-nitrovinil)phenol by the common method of nucleophilic substitution of an activated nitro group in an aromatic ring. The metallophthalocyanines 2, 3 were prepared by the reaction of a dinitrile derivative with Co(OAc)(2) or Zn(OAc)(2) in DMSO. The lutetium bis-(phthalocyaninato) complex 4 was obtained by treating the dinitrile derivative with lutetium acetate and DBU in 1-hexanol. The new compounds were characterized by elemental analyses, FT-IR, (1)H-NMR, MALDI-TOF MS and UV/Vis spectral data. The spectroscopic data of the new compounds were in accordance with the structures. The temperature and frequency dependence of dielectric and conduction properties of the spin coated film of compounds (2-4) have been studied by fabricating metal-Pc-metal structures. The results show that compound 2 has giant dielectric constant. At a low range of frequency and room temperature, ε' is found to be equal to 2.33 × 10(6), 1.53 × 10(4) and 1.03 × 10(4) for 2, 3 and 4, respectively. The giant dielectric behavior of 2 is mainly attributed to Maxwell-Wagner polarization. The obtained results also indicated that the frequency dependence of the dielectric permittivity, ε'(ω), exhibits non-Debye type relaxation for all temperatures investigated. The ac conductivity results gave a temperature dependent frequency exponent s. The results were compared with the prediction of the Quantum Mechanical Tunneling and Correlated Barrier Hopping models.     

Synthesis of 4-substituted chlorophthalazines, dihydrobenzoazepinediones, 2-pyrazolylbenzoic acid, and 2-pyrazolylbenzohydrazide via 3-substituted 3-hydroxyisoindolin-1-ones

Herein we describe a general three-step synthesis of 4-substituted chlorophthalazines in good overall yields. In the key step, N,N-dimethylaminophthalimide (8a) directs the selective monoaddition of alkyl, aryl, and heteroaryl organometallic reagents to afford 3-substituted 3-hydroxyisoindolinones 9b, 9i-9am. Many of these hydroxyisoindolinones are converted to chlorophthalazines 1b-1v via reaction with hydrazine, followed by chlorination with POCl(3). We have also discovered two novel transformations of 3-vinyl- and 3-alkynyl-3-hydroxyisoindolinones. Addition of vinyl organometallic reagents to N,N-dimethylaminophthalimide (8a) provided dihydrobenzoazepinediones 15a-15c via the proposed ring expansion of 3-vinyl-3-hydroxyisoindolinone intermediates. 3-Alkynyl-3-hydroxyisoindolinones react with hydrazine and substituted hydrazines to afford 2-pyrazolyl benzoic acids 16a-16d and 2-pyrazolyl benzohydrazides 17a-17g rather than the expected alkynyl phthalazinones.     

New liquid chromatographic-chemometric approach for the determination of sunset yellow and tartrazine in commercial preparation

A new liquid chromatographic (LC)-chemometric approach was developed for the determination of sunset yellow (SUN) and tartrazine (TAR) in commercial preparations. This approach uses LC and chemometric calibration methods, i.e., classical least-squares (CLS), principal component regression (PCR), and partial-least squares (PLS), simultaneously. The combined LC-chemometric approaches, denoted as LC-CLS, LC-PCR, and LC-PLS, are based on photodiode array (PDA) detection at multiple wavelengths. Optimum chromatographic separation of SUN and TAR with allura red as the internal standard (IS) was obtained by using a Waters Symmetry C18 column, 5 microm, 4.6 x 250 mm, and 0.2 M acetate buffer (pH 5)-acetonitrile-methano-bidistilled water (55 + 20 + 15 + 10, v/v) as the mobile phase at a flow rate of 1.9 mL/min. The LC data sets consisting of the ratios of analyte peak areas to the IS peak area were obtained by using PDA detection at 5 wavelengths (465, 470, 475, 480, and 485 nm). LC-chemometric calibrations for SUN and TAR were separately constructed by using the relationship between the peak-area ratio and the training sets for each colorant. LC-chemometric approaches were tested for different synthetic mixtures containing SUN and TAR in the presence of the IS. These LC-chemometric calibrations were applied to a commercial preparation of the 2 colorants. The experimental results of the LC-chemometric approaches were compared with those obtained by a developed classical LC method using single-wavelength detection.     

Synthesis and Properties of Thiophene and Dithiin Functionalized Tetrathiafulvalenes

Abstract

Syntheses of two analogues of tetrathiafulvalene (TTF), fused to 1,4-dithiin and thiophene rings, substituted with thiophene moieties, have been illustrated. The syntheses were accomplished through the reaction of a 1,8-diketone with phosphorus pentasulfide or Lawesson's reagent in boiling dry toluene. Conversion of the thioketones to their the oxo forms with mercury (II) acetate, was followed by self-coupling in freshly distilled boiling triethyl phosphite. Attempts for their electro-polymerizations through the thiophene groups at the peripherals were unsuccessful. Computational chemistry studies revealed that the thiophene groups did not exhibit enough spin densities to perform polymerization.

Supplemental materials are available for this article. Go to the publisher's online edition of Phosphorus, Sulfur, and Silicon and the Related Elements to view the free supplemental file.     

Synthesis,characterization and biological evaluation of some novel sulfonylthiosemicarbazides

Abstract

A series of thiosemicarbazides were synthesized and structurally characterized by spectroscopic techniques (NMR, FT-IR) besides elemental analysis. These compounds were evaluated for their cytotoxicity against human breast cancer cell line MCF7 and prostate cancer cell line PC3 and nonmalignant fibroblast L929 cell line by MTT assay. Among the compounds, N-[2-(4-chlorophenyl)ethyl]-2-[(4-methylphenyl)sulfonyl]hydrazinecarbothioamide (3d) and 2-[(4-methylphenyl)sulfonyl]-N-[4-(trifluoromethoxy)phenyl]hydrazinecarbothioamide (3f) were found to display significant cytotoxicity with IC₅₀ of 13.87?μM (against PC3 cell line) and 1.47?μM (against MCF7 cell line), respectively. These compounds were non-cytotoxic to normal cell line with IC₅₀>100?μM. Western blotting studies demonstrated that compound 3f induced apoptosis and caused cell death in the MCF7 and PC3 cell lines via an increase in Bax protein expression and a slight decrease in Bcl-2 protein expression. The gene expression ratio Bax/Bcl-2 showed the induction of mitochondrial apoptosis in cancer cell lines. All of synthesized compounds have also been tested for antioxidant activity and all compounds achieved strong inhibition of the DPPH radical. These findings showed that compound 3f, displays potential to be further explored in the development of new anticancer agents.     

Effect of anionic surfactant on alginate‐chitosan polyelectrolyte multilayer thickness

Alginate and chitosan are among the most common biopolyelectrolytes. Surfactants can be included in alginate and chitosan formulations in order to improve their physical and functional properties. In the present study, the effect of the anionic surfactant sodium dodecyl sulfate (SDS) on alginate‐chitosan polyelectrolyte multilayer (PEM) films is reported for the first time. Layer‐by‐layer deposition technique was employed to prepare the PEM samples and the samples were characterized by ellipsometry, X‐ray reflectivity, atomic force microscopy, and quartz crystal microbalance with dissipation. Incorporation of SDS into PEM formulations increased the film thickness and an increased adsorption behavior between alginate and chitosan layers are observed. Since the concentration of SDS was below its critical micelle concentration, no micelle formation was expected and hydrophobic‐hydrophobic interaction between alginate and SDS might be the main reason. © 2017 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2017 , 55, 1798–1803     

X-ray structure of palladium (II) complex and its catalytic activity on Suzuki–Miyaura reaction under mild conditions

Research on Chemical Intermediates - Palladium (II) complex with 4-tert-butylbenzoic hydrazide (TBBH)/triphenylphosphine (PPh3) ligands was successfully synthesized and characterized by X-ray,...     

Syntheses,characterization of and studies on the electrochemical behaviour of ferrocenyl dithiophosphonates and 4-methoxyphenyl dithiophosphonates

Some 1,3-dithiadiphosphetane 2,4-disulfides (X₂P₂S₄, X: Fc, FcLR; X: CH₃O?C₆H₄?, LR) were allowed to react with alcohols to obtain dithiophosphonic acids (X(OR)PS₂H). These were converted to the corresponding ammonium salts. The salts were of the structures [Fc(OR)PS₂]^?[NH₄]⁺, R: 3-methyl-1-butyl- for I; 1-phenyl-1-propyl- for II; 3-pentyl- for III; 3-phenyl-1-propyl- for IV and [CH₃O?C₆H₄(OR)PS₂]^?[NH₄]⁺, R: 3-methyl-1-butyl- for V and 1-phenyl-1-propyl- for VI. To the best of our knowledge, all the compounds except V were prepared for the first time.

The compounds synthesized were characterized by elemental analysis, NMR (¹H, ¹³C, ³¹P), MS, FTIR, and Raman spectroscopies. Electrochemical behaviors of I–VI at disposable pencil graphite electrode (PGE) were investigated by using cyclic voltammetry (CV) and square-wave voltammetry (SWV). Adsorption and diffusion patterns of all the compounds on the PGE were also studied.

Two electroactive groups were identified in the compounds I–IV and only one in V and VI. The ferrocenyl groups of I-IV were oxidized at around 0.4 V. The same compounds display a second, more intense CV band at 0.8 V. The corresponding band for the compounds V–VI appears at around 0.6 V with a much weaker intensity. It is suggested that the ferrocenyl group introduced into the structures stabilizes the radical species formed as the product of the oxidation of the dithiophosphonato group.