FeSi2合金在高压下的凝固

研究了压力对FeSi2合金凝固组织的影响.与常压下凝固的典型共晶组织不同，高压条件下的凝固组织为初生ε相树枝晶加离异共晶.高压下凝固组织的变化主要是与压力对相图的影响和对凝固过程中溶质原子扩散的影响有关.通过引入压力参量，推导了高压凝固过程中的成分过冷判据，并应用该判据分析了高压凝固树枝晶组织的形成机理. 关键词： 高压 凝固 FeSi2     

Tesla微混合器结构参数对混合强度的影响

针对Tesla微混合器混合原理,利用计算流体力学(CFD)模拟与分析软件对其进行了三维数值模拟.模型采用有限体积法离散、SIMPLEC算法进行层流计算.分析了结构参数的改变对该混合器混合效果的影响,并采用混合强度值作为衡量指标.分析结果显示,不同通道高宽比和分离通道入流角度等结构参数对该微混合器的混合效果有重要影响.模...     

Intermolecular interaction potentials of methane－argon complex calculated using LDA approaches

The intermolecular interaction potential for methane－argon complex is calculated by local density approximation (LDA) approaches. The calculated potential has a minimum when the intermolecular distance of methane－argon complex is 6.75 a.u.; the corresponding depth of the potential is 0.0163eV which has good agreement with experimental data. We also have made a nonlinear fitting of our results for the Lennard-Jones (12-6) potential function and obtain that V(R)=143794365.332/R^{12}-3032.093 / R^6 (R in a.u. and V(R) in eV).     

流体动力式超声与槽式超声提取黄芩的比较

目的:比较两种超声发生器对化学反应的促进作用。方法:首先用碘释放测量法进行实验,分别用气哨式流体动力式超声发生器和槽式超声清洗仪处理碘化钾溶液,采用分光光度法测定碘化钾溶液的吸光度。随后分别用流体动力式超声与槽式超声提取黄芩,采用高效液相色谱法测定黄芩苷含量。结果:经流体动力式超声发生器和槽式超声清洗仪处理的碘化钾溶液的吸光度分别为0.990和0.498。以水为溶剂用流体动力式超声提取黄芩,黄芩苷含量显著高于槽式超声。结论:流体动力式发生器(每升能耗0.0156kwh)的空化效应高于槽式超声清洗仪(每升能耗0.0148kwh)。     

正压Rossby波扰动能量

利用Fourier变换方法,研究准地转近似下beta平面上绝热、无摩擦、无强迫耗散的正压大气Rossby波扰动能量在有限时段内的快速发展和衰减情形.给出线性正压位势涡度方程扰动流函数的解析解,并进一步分析扰动能量与东西波数、南北波数、基流切变和黏性系数之间的关系.     

氧族元素对D-A和D-π-A共聚物光吸收谱红移的第一性原理研究

D-A型共聚物作为有机聚合物太阳能电池的电子给体材料近年来引起广泛关注. 本文以苯并二噻吩(BDT)为电子给体单元, 苯并噻二唑(BT)为电子受体单元来模拟D-A共聚体; 并用噻吩环作为π桥, 构造出D-π-A(PBDT-DTBX, X = O, S, Se, Te)结构. 采用第一性原理的密度泛函理论, 系统地计算相应的电子结构和光吸收谱. 比较不同氧族元素和噻吩π-键桥对聚合物光吸收谱的影响. 研究结果表明: D-A共聚体中当X位元素以O, S, Se, T_e 替换时, 其体系的最高占有分子轨道(HOMO)能级变化不大, 最低未占有分子轨道(LUMO)能级逐渐靠近费米能级, 带隙逐渐减小. 在可见光区有两个较强的吸收峰, 随着X位元素原子序数增大, 位于4.0 eV左右的光吸收峰位基本不变, 另一光吸收峰强度明显增大并发生红移. 与D-A结构相比, D-π-A结构的带隙均有所减小, 其中X为Te时带隙最小; 光吸收峰强度随着氧族元素原子序数的增大也明显增大并发生红移. 通过比较光吸收系数和相应态密度, 结果表明, 4.0 eV 左右的光吸收峰主要是BDT单元的贡献, 氧族元素的改变主要影响519.4-703.9 nm范围的光吸收.     

分布损耗对回旋行波放大器稳定性的影响

基于电磁模式的色散方程和回旋管非线性理论,研究了损耗层厚度对回旋行波放大器注-波互作用的影响.结果表明,合理选择损耗层电导率和厚度能够让期待的工作模式TE₀₁衰减较小,而对应的竞争模式TE₂₁因损耗很大而更难以起振,随厚度的增加,放大带宽从两边向中间收缩变窄,频带中间部分的输出功率会上升,曲线更加平坦,从而达到改善互作用稳定性的目的. 关键词： 回旋行波放大器 起振长度 起振频率 饱和功率     

黏性水波振荡型行波解的存在性

利用追赶法技巧,研究了倾度为常数的宽矩形通道中黏性水波振荡型行波解的存在性,证明了当黏性系数、摩擦系数、倾度和高度比满足一定关系时,存在唯一的振荡型行波解.由于解析求解的困难,通过数值计算,给出了部分结果,最后进一步讨论了可能存在的振荡型行波解的结构. 关键词： 追赶法 黏性水波 振荡型行波解     

Focusing of Time Reversal Lamb Waves and Its Applications in Structural Health Monitoring

The focusing of time reversal acoustic fields for dispersive and multimodal Lamb waves is theoretically investigated and experimentally verified. It is demonstrated that the time reversal Lamb wave signal will reach the maximum amplitude when the observation point is located at the damage location. Based on the time reversal focusing theory, a damage imaging method is proposed for structural health monitoring using Lamb waves. The experiments employ a transducer network consisting of four piezoelectric transducers as actuators and as well sensors for excitation and measurement of Lamb waves. The results show that this method is able to accurately predict damage location and provides an estimation of the possible area even for damage close to one of the transducers or even slightly outside the transducer network.     

Surface Structure and Electronic Property of InP（001）-（2×1）S Surface： A First-Principles Study

The surface structure and electronic property of InP（001）-（2 ×1）S surface under S-rich condition are investigated based on first-principles simulations. The analyses of phase transition show that the 3B model is the most stable structure and the S-S dimer is difficult to form. The geometry of the 3B structure agrees well with the experiments. It is also found that the 3B structure has a good passivation with a band gap of about 1.24eV. The results indicate that the 3B structure is the best candidate for the sulfur-rich InP（001）（2 × 1）A phase.