Pt/TiO_2催化剂上的氢—氧作用 Ⅰ.氢、氧的吸咐—脱附行为以及相互促进作用

本文采用程序升温脱附(TPD)技术研究了光沉积方法制备的Pt/TiO_2催化剂经过氧化、还原后氧、氢的脱附行为.光沉积过程中,Pt/TiO_2表面上可以生成大量的吸咐氢,在TPD中脱附;同时Pt/TiO_2表面上化学吸附的水在TPD过程中也可以分解释氢.氧化处理的Pt/TiO_2在TPD过程中于550～750K温区出现氧脱附峰,随着氧化温度升高,脱附峰位向高温移动,经实验证明,这种可脱附活泼氧物种的生成是由样品前身中留存氢引起的.还原处理的Pt/TiO_2在TPD过程中分别在300～600和大于600K出现两个氢脱附峰,认为是由于表面羟基和钛—氢(Ti~(4+)—H~-)物种的分解释氢引起的Pt/TiO_2上活泼氧物种的存在,增加了样品在室温条件下的吸氢量;在中温(473～573K)这种活泼氧物种则和氢发生反应,减少了TPD过程中的脱氢量;Pt/TiO_2在大于673K温度还原,可以消除活泼氧物种的影响.     

Application of Headspace Liquid-Phase Microextraction to the Analysis of Volatile Halocarbons in Water

The determination of four volatile halocarbons (CHCl₃, CCl₄, C₂HCl₃ and C₂Cl₄) in water by headspace liquid-phase microextraction (HS-LPME) with gas chromatography using a micro electron capture detector (GC-μECD) is described. The effects of the type and volume of the extraction solvent, headspace volume, stirring rate, extraction temperature and time and ionic strength on the extraction performance are investigated and optimized. The developed protocol yields a linear calibration curve in the concentration range from 0.05 to 50 µg L^?1 for the target analytes; the detection limits ranged from 0.003 to 0.146 µg L^?1 and the relative standard deviation (R.S.D.) values below 8.45%. The results demonstrate that HS-LPME followed with GC-μECD is a simple and reliable technique for the determination of volatile halocarbons in water samples.     

Phase-locked InGaAsP laser array with diffraction coupling

A phase-locked array of InGaAsP lasers has been fabricated for the first time. The array utilized diffraction coupling between 10 adjacent lasers to achieve phase locking. Threshold current as low as 200 mA is obtained for arrays with 250 m cavity length. Smooth single-lobe far field patterns with beam divergence as narrow as 3° have been achieved.     

1—苯乙酰基—4—芳酰基氨基硫脲的合成及其在碱催化下的环化反应

1-酰基-4-芳基氨基硫脲类化合物在碱性条件下环化为具有广泛生物活性的3-取代基-4-芳基-1,2,4-三唑啉-5-硫酮的反应报道甚多,但1,4-位都含羰基的酰氨基硫脲在碱性条件下环化反应迄今报道较少。我们曾研究了1-[5-(α-萘)-2H-四唑-2-乙酰基]-4-芳酰基氨基硫脲和1-(α-萘乙酰基)-4-芳酰基氨基硫脲在碱催化下环化为3-取代基-4-芳酰基-1,2,4-三唑啉-5-硫酮的反应,它们在低浓度下均有一定的生物活性。本文研究了1-苯乙酰基-4-芳酰基氨基硫脲1_(a～m)在1mol/L K_2CO_3溶液催化下的环化反应,得到环化产物3-苄基-4-芳酰基-1,2,     

242-260nm波长区CS2分子的多光子解离电离

在242－260nm波氏范围通过CS2分子的共振增强多光子电离（REMPI）获得了母体离子CS和碎片离子的分质量激发谱．在λ＜246.4nm区间，CS激发谱上呈现出来源于CS2双光子电离的弥散谱带,碎片离子激发谱的归属强烈提示多光子过程中有中性基电子态的CS和S（经由CS2的光解离）产生：（1）CS 的谱带主要来源于中性CS碎片经由单光子跃迁产生的（1＋1）共振增强电离，（2）除了部分S 的谱峰来自CS 的光解外，多数S 的锐谱峰来自中性S原子经由3p3（2D0）4p，3p3（4S0）np（n＝6，7，8）←3p43pJ（J＝2，1,0）双光子跃迁产生的（2＋1）共振增强电离．     

High-performance liquid chromatographic determination of 18 alpha-glycyrrhetinic acid and 18 beta-glycyrrhetinic acid in rat plasma: application to pharmacokinetic study.

A high-performance liquid chromatographic method for the separation and determination of 18 alpha-glycyrrhetinic acid and 18 beta-glycyrrhetinic acid has been developed. Indomethacin was used as an internal standard. The drugs were separated on a reversed-phase column and detected by UV detection at a wavelength of 254 nm. Methanol-water-perchloric acid-ammonia (80:20:0.4:0.4, v/v) was used as the mobile phase at pH of 7.0-7.5. The detection limit of both compounds was 0.1 microgram/ml in rat plasma. The method was applied to pharmacokinetic studies of glycyrrhetinic acids in rats. The results suggest that the pharmacokinetics appeared to be non-linear in nature.     

CRYSTALLIZATION AND MELTING OF POLY（ETHYLENE OXIDE） CONFINED IN NANOSTRUCTURED PARTICLES WITH CROSS-LINKED SHELLS OF POLYBUTADIENE

Small fixed aggregates of a poly(ethylene oxide)-block-polybutadiene diblock copolymer(PEO-b-PB)in THFsolution were obtained by adding a selective solvent for PB blocks,followed by cross-linking the PB shells.Themorphologies of the nanostructured particles with a cross-linked shell were investigated by atomic force microscopy andtransmission electron microscopy.The average behaviors of the PEO crystallization and melting confined within thenanostructured particles were studied by using differential scanning calorimetry experiments.For the deeply cross-linkedsample(SCL-1),the crystallization of the PEO blocks was fully confined.The individual nanoparticles only crystallized atvery low crystallization temperatures(T_cs),wherein the homogenous primary nucleation determined the overallcrystallization rate.For the lightly cross-linked sample(SCL-2),the confinement effect was T_c dependent.At T_c(?)42℃,thecrystallization and melting behaviors of SCL-2 were similar to those of the pure PEO-b-PB diblock copolymer.At T_c>42℃,SCL-2 could form PEO lamellae thicker than those of the pure PEO-b-PB crystallized at the same T_c.     

Determination of gamma-globulin at nanogram levels by its enhancement effect on the resonance light scattering of functionalized HgS nanoparticles

A novel assay of γ-globulin (γ-IgG) with a sensitivity at the nanogram level is proposed based on the measurement of enhanced resonance light-scattering (RLS) signals resulting from the interaction of functionalized nano-HgS with γ-globulin. At pH 5.03, the RLS signals of functionalized nano-HgS were greatly enhanced by γ-globulin in the region of 200-700 nm characterized by the peak around 362 nm. Linear relationship can be established between the enhanced RLS intensity and γ-globulin concentration in the range of 10-140 ng ml⁻¹. The limit of detection is 2.71 ng ml⁻¹. Based on this, a new direct quantitative determination method for γ-globulin in blood serum samples without separation of human serum albumin (HSA) is established. The contents of γ-IgG in blood serum samples were determined with recovery of 95.7-102.5% and R.S.D. of 1.6-2.4%. This method is proved to be very sensitive, rapid, simple and tolerance of most interfering substances.     

QSAR models using a large diverse set of estrogens

Endocrine disruptors (EDs) have a variety of adverse effects in humans and animals. About 58,000 chemicals, most having little safety data, must be tested in a group of tiered assays. As assays will take years, it is important to develop rapid methods to help in priority setting. For application to large data sets, we have developed an integrated system that contains sequential four phases to predict the ability of chemicals to bind to the estrogen receptor (ER), a prevalent mechanism for estrogenic EDs. Here we report the results of evaluating two types of QSAR models for inclusion in phase III to quantitatively predict chemical binding to the ER. Our data set for the relative binding affinities (RBAs) to the ER consists of 130 chemicals covering a wide range of structural diversity and a 6 orders of magnitude spread of RBAs. CoMFA and HQSAR models were constructed and compared for performance. The CoMFA model had a r2 = 0.91 and a q2LOO = 0.66. HQSAR showed reduced performance compared to CoMFA with r2 = 0.76 and q2LOO = 0.59. A number of parameters were examined to improve the CoMFA model. Of these, a phenol indicator increased the q2LOO to 0.71. When up to 50% of the chemicals were left out in the leave-N-out cross-validation, the q2 remained significant. Finally, the models were tested by using two test sets; the q2pred for these were 0.71 and 0.62, a significant result which demonstrates the utility of the CoMFA model for predicting the RBAs of chemicals not included in the training set. If used in conjunction with phases I and II, which reduced the size of the data set dramatically by eliminating most inactive chemicals, the current CoMFA model (phase III) can be used to predict the RBA of chemicals with sufficient accuracy and to provide quantitative information for priority setting.     

Ionic limiting molar conductivity calculation of Li-ion battery electrolyte based on mode coupling theory

A method is proposed based on mode coupling theory in which the ion transference number is introduced into the theory. The ionic limiting molar conductivities of LiPF6, LiClO4, LiBF4, LiCF3SO3, Li(CF3SO3)2N, LiC4F9SO3, and LiAsF6 in PC(propylene carbonate), GBL(gamma-butyrolactone), PC(propylene carbonate)/EMC(ethylmethyl carbonate), and PC(propylene carbonate)/DME(dimethoxyethane) are calculated based on this method, which does not involve any adjustable parameter. The results fit well to the literature data which are calculated by an empirically adjusted formula. This presents a potential way to calculate the conductivities of Li-ion battery electrolytes.